SolarEdge SE-MTR-3Y-400V-A Manuel utilisateur

Installation Guide

Energy Meter with Modbus

Connection

For Europe, APACand South Africa

Version 1.0

Disclaimers

Important Notice

No part of this document may be reproduced, stored in a

retrieval system or transmitted, in any form or by any means,

electronic, mechanical, photographic, magnetic or otherwise,

without the prior written permission of SolarEdge Inc.

The material furnished in this document is believed to be

accurate and reliable. However, SolarEdge assumes no

responsibility for the use of this material. SolarEdge reserves

the right to make changes to the material at any time and

without notice. You may refer to the SolarEdge web site

(www.solaredge.com) for the most updated version.

All company and brand products and service names are

trademarks or registered trademarks of their respective holders.

Patent marking notice: see http://www.solaredge.com/patent

The general terms and conditions of delivery of SolarEdge shall

apply.

The content of these documents is continually reviewed and

amended, where necessary. However, discrepancies cannot be

excluded. No guarantee is made for the completeness of these

documents.

Energy Meter with Modbus Connection Installation Guide MAN-01-00643-1.0

Disclaimers1

The images contained in this document are for illustrative

purposes only and may vary depending on product models.

Emission Compliance

This equipment has been tested and found to comply with the

limits applied by the local regulations.

These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications. However, there is no guarantee that

interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment off and on, you are encouraged to try to correct

the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the

receiver.

Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician

for help.

Energy Meter with Modbus Connection Installation Guide MAN-01-00643-1.0

2 Emission Compliance

Changes or modifications not expressly approved by the party

responsible for compliance may void the user’s authority to

operate the equipment.

Energy Meter with Modbus Connection Installation Guide MAN-01-00643-1.0

Disclaimers3

Version History

Version 1.0 (August 2019) - Initial release

Energy Meter with Modbus Connection Installation Guide MAN-01-00643-1.0

4 Emission Compliance

Contents

Disclaimers 1

Important Notice 1

Emission Compliance 2

Contents 5

HANDLING AND SAFETY INSTRUCTIONS 7

Safety Symbols Information 7

Chapter 1: The SolarEdge Energy Meter with Modbus

Connection 9

Package Contents 10

Terminology 11

Metering Applications 12

Meter Connection Options 14

Meter Interfaces 15

Chapter 2: Meter Installation 19

Installation Guidelines 19

Installing and Connecting the Meter 21

Chapter 3: Configuration 31

SolarEdge Device Firmware Version 31

Device Configuration 33

Appendix A: Troubleshooting the Meter 39

Communications Failure 39

The Energy Value is not Advancing 42

Appendix B: Installing Two Meters 44

Connecting Two Meters 44

Energy Meter with Modbus Connection Installation Guide MAN-01-00643-1.0

Contents5

Configuring the Dual-Meter Connection 46

Verifying the Dual-Meter Connection 48

Troubleshooting the Dual-Meter Connection 48

Appendix C: Monitoring Platform - Meter Data 49

Appendix D: External Lightning Protection 53

Appendix E: Meter Technical Specifications 55

Support Contact Information 58

Energy Meter with Modbus Connection Installation Guide MAN-01-00643-1.0

6 Contents

HANDLING AND SAFETY

INSTRUCTIONS

During installation, testing and inspection, adherence to all the

handling and safety instructions is mandatory. Failure to do so

may result in injury or loss of life and damage to the

equipment.

Safety Symbols Information

The following safety symbols are used in this document.

Familiarize yourself with the symbols and their meaning before

installing or operating the system.

WARNING!

Denotes a hazard. It calls attention to a procedure

that, if not correctly performed or adhered to, could

result in injury or loss of life. Do not proceed beyond a

warning note until the indicated conditions are fully

understood and met.

CAUTION!

Denotes a hazard. It calls attention to a procedure

that, if not correctly performed or adhered to, could

result in damage or destruction of the product. Do

not proceed beyond a caution sign until the indicated

conditions are fully understood and met.

Energy Meter with Modbus Connection Installation Guide MAN-01-00643-1.0

HANDLING AND SAFETY INSTRUCTIONS7

NOTE

Denotes additional information about the current

subject.

IMPORTANTSAFETYFEATURE

Denotes information about safety issues.

Disposal requirements under the Waste Electrical and

Electronic Equipment (WEEE) regulations:

NOTE

Discard this product according to local regulations or

send it back to SolarEdge.

Energy Meter with Modbus Connection Installation Guide MAN-01-00643-1.0

8 Safety Symbols Information

Chapter 1: The SolarEdge Energy

Meter with Modbus Connection

The SolarEdge Energy Meter with Modbus Connection (also

referred to as “the meter”) enables measuring the power and

energy of the photovoltaic (PV)system.

The meter is used by the inverter for the following applications:

Production metering

Consumption monitoring

Export limitation

Smart Energy on-grid applications

The meter supports both single-phase and three-phase grids,

and requires the installation of Current Transformers (CTs). The

CTs are available from SolarEdge:

When used in a single-phase grid, one CT is required.

When used in a three-phase grid, three CTs are required.



NOTE

This installation guide is for connection of the meter to

inverters using SetApp.

An installation guide for connection of the meter to

inverters using a display is available for download from:

https://www.solaredge.com/sites/default/files/solaredge-

meter-installation-guide-dispaly-row.pdf

Energy Meter with Modbus Connection Installation Guide MAN-01-00643-1.0

Chapter 1: The SolarEdge Energy Meter with Modbus



Table des matières

Autres manuels SolarEdge Instrument de mesure

SolarEdge

SolarEdge MTR-240-3PC1-D-A-MW Manuel utilisateur

SolarEdge

SolarEdge SE330K Instructions d'installation et d'utilisation

SolarEdge

SolarEdge SolarEdge SE-MTR240-2-400-S1 Manuel utilisateur

SolarEdge

SolarEdge SE-WND-3Y400-MB-K2 Manuel utilisateur

SolarEdge

SolarEdge SE-MTR240-NN-S-S1 Manuel utilisateur

SolarEdge

SolarEdge AS4034-1 Manuel utilisateur

SolarEdge

SolarEdge RGM Mode d'emploi

SolarEdge

SolarEdge SE-RGMTR-3D-208V-A Manuel utilisateur

Manuels Instrument de mesure populaires d'autres marques

Suaoki

Suaoki D40 Manuel utilisateur

Elster

Elster BK-G1.6 Manuel utilisateur

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manuel

Duratool

Duratool D03128 Manuel utilisateur

Vega

Vega VEGAPULS 65 Manuel utilisateur

Tonghui

Tonghui TH2618B Manuel utilisateur

Tenmars

Tenmars TM-801 Manuel utilisateur

MSR

MSR 145 Manuel utilisateur

TPS

TPS WP-82 Manuel utilisateur

ELMETRON

ELMETRON CP-511 Manuel utilisateur

PCB Piezotronics

PCB Piezotronics 003C30 Manuel utilisateur

Tenma

Tenma 72-10465 Manuel utilisateur

Endress+Hauser

Endress+Hauser Proline Promag 50 Caractéristiques techniques

Siemens

Siemens SITRANS F Coriolis FCT030 Manuel de la liste des pièces

KLINGER

KLINGER CMF V Series Manuel utilisateur

EXFO

EXFO FTB-2 Manuel d'exploitation et d'entretien

Keysight

Keysight M8290A Manuel utilisateur

ADTEK

ADTEK MW-5 Manuel utilisateur