Snapper 1691827 Manuel utilisateur

Section A. General

This kit provides an add-on light and required

alternator for compact and large frame

snowthrowers with Tecumseh engines. Kit can be

installed on snowthrowers that are equipped with

cabs (hard or soft). See the appropriate section for

installation instructions:

Section Snowthrower Application

Section C.

Compact No Cab/Soft Cab

Section D. Large-Frame

No Cab/Soft Cab

Section E. Large-Frame

Hard Cab

Section B. Kit Parts

ITEM DESCRIPTION P/N

Alternator

1704.346

B. Self-Tapping Screw, l-114”

1704652

Self-Tapping Screw, :&I@“**

1704663

C. AC Ughtlng Connector

1704647

D. Spacer’

1704646

Centertng

Tube

1704649

F. Alternator Shaft, 3””

1704641

Alternator Shafl,

3-M”’

1704642

G. Headllght Assy.

1704644

H. Plastic Tie’

925094

CIIP

930222

HP Models “7, 6, 10 HP Models

QTY.

Figure 1.

INSTALLATION

INSTRUCTIONS

~~,

SNOWTHROWER HEADLIGHT KIT

MFG. NO. 1691827

Section C. Compact Snowthrower With

Sofi

Cab/

Without Cab.

1. Drill a 13/&Y hole, 5/8” from bottom and

centered (approx.

8-i/2”

from either end) on the

crossmember as shown in figure 2.

AD-815

:igure

2. Install light with capsorew, lockwasher, and nut

(lockwasher and nut towards rear).

3. Install alternator as provided in the Tecumseh

Installation Instructions. Use the appropriate

alternator shaft (F, figure 1) and self-tapping

screws (B).

4. Install clip and plastic ties as shown in figure 3.

This will prevent wire harness from interfering

with recoil starter.

‘1990

CLIP I I

”

-1

gure

FORM

1704651-02

PRlNTED IN U.S.A.

10190

‘I

Section D. Large Frame Snowthrower With Soft-

Cab/ No Cab. Section E. Large Frame Snowthrower With Hard

Cab.

1. Drill 13/32” hole in right-hand side channel, 3”

below auger drive handle and centered (approx.

i-3/4”),

as shown in figure 4.

_~~~

--.-

-._~~~~..

---~

.---

------l

NOTE

Hard cab should be installed first before

installing light kit.

Figure 4.

2. Install light with capscrew, lockwasher, and nut

(nut on inside).

3. Install alternator as provided in the Tecumseh

Installation Instructions. Make sure alternator is

installed with wire harness plug at the 3:00

position. Use the appropriate alternator shaft (F,

figure 1) and self-tapping screws

(B).

4. Install clip on upright as shown in figure 5 to

prevent wire from interfering with recoil starter.

Plastic ties provided with kit will not be used.

5. If soft cab is used, tuck the right-hand side of cab

around the light bracket

1. Drill 13/32” hole in the right hand side of thecab

frame, approx. 3/4” down and

l-1/2”

from

capscrew, as shown in figure 6.

2. Install light through cab frame with capscrew,

lockwasher, and nut (nut on inside).

3. Install clip on upright asshown in figure 5. Plastic

ties provided with the kit will not be used.

igure

,.’

,i,

Autres manuels Snapper Souffleuse à neige

Snapper

Snapper I4221 Manuel d'exploitation et d'entretien

Snapper

Snapper 105308E Manuel utilisateur

Snapper

Snapper 1696000 Manuel utilisateur

Snapper

Snapper 15254 Instructions d'installation

Snapper

Snapper 5201M Manuel utilisateur

Snapper

Snapper Snow Thowers Manuel

Snapper

Snapper EI Manuel utilisateur

Snapper

Snapper I422 Manuel utilisateur

Snapper

Snapper 9266 Manuel d'exploitation et d'entretien

Snapper

Snapper 10305 Manuel d'exploitation et d'entretien

Snapper

Snapper I7244 Manuel d'exploitation et d'entretien

Snapper

Snapper 10305E Manuel utilisateur

Snapper

Snapper H1528ES Manuel utilisateur

Snapper

Snapper 3203 Series Manuel d'exploitation et d'entretien

Snapper

Snapper 7555 Manuel utilisateur

Snapper

Snapper 155223 Manuel d'exploitation et d'entretien

Snapper

Snapper 860 Manuel utilisateur

Snapper

Snapper L1226E Manuel utilisateur

Snapper

Snapper 13388E Manuel utilisateur

Snapper

Snapper 1694602 9247E, 11694602 9247E, Manuel utilisateur

Snapper

Snapper 1694836 7555M Manuel

Snapper

Snapper 1030 Manuel d'exploitation et d'entretien

Snapper

Snapper ESS50220E (7800083), SS50220E Manuel utilisateur

Snapper

Snapper N10305E Manuel d'exploitation et d'entretien

Manuels Souffleuse à neige populaires d'autres marques

Murray

Murray 624504X4A Manuel utilisateur

Blizzard

Blizzard POWER PLOW 8100PP Manuel utilisateur

Craftsman

Craftsman 486.24837 Manuel utilisateur

Yard-Man

Yard-Man E2B5 Manuel utilisateur

ST ST 526 A Manuel utilisateur

MTD

MTD 3AA Manuel utilisateur

Toro

Toro Power TRX 1428 OHXE Manuel utilisateur

Ryobi

Ryobi RYAC800 Manuel utilisateur

Poulan Pro

Poulan Pro 416829 Manuel utilisateur

Poulan Pro

Poulan Pro 437986 Manuel utilisateur

MTD

MTD 319-180-00 Manuel utilisateur

Brute

Brute 1695565 Manuel utilisateur

Egholm

Egholm City Ranger 2250 Manuel utilisateur

Poulan Pro

Poulan Pro 420915 Manuel utilisateur

GreenWorks

GreenWorks SNF402 Manuel utilisateur

LOFTNESS

LOFTNESS 601D1 Manuel utilisateur

LOFTNESS

LOFTNESS 1082I Manuel utilisateur

LOFTNESS

LOFTNESS 481EL Manuel utilisateur