4
–Do not climb on or sit on the appliance, do not lean on or hang on the appliance
doors and do not allow children to do this.
–Do not use water spray and steam to clean the appliance.
The appliance should be transported in the vertical position; do not tilt any
more than 30°. THE MANUFACTURER WILL NOT BE RESPONSIBLE FOR ANY
DAMAGE OF THE APPLIANCE THAT RESULTS FROM NON-COMPLIANCE WITH THE
INSTRUCTIONS FOR TRANSPORTATION.
INSTALLATION AND OPERATING CONDITIONS
Positioning:
•This appliance can be installed in a dry, well ventilated indoor location where the
ambient temperature corresponds to the climate class indicated on the rating plate of
the appliance.
CAUTION! Do not install this appliance in areas that are too humid or too cold.
Place the appliance away from heat sources such as kitchen stove/oven,
radiators, or direct sunlight. The appliance must not touch any pipes for heating,
gas or water supply, or any other electrical devices.
•Do not cover the ventilation holes at the top of the appliances –it must be a good air
circulation around the appliance. There should be a gap of at least 10 cm between the
top of the appliance body and any furniture that may be above it. If this requirement is
not followed, the appliance consumes more electrical energy and its compressor may
overheat.
•The appliance must stand on a level surface
and must not touch the wall. If necessary,
regulate the height of the appliance by
adjusting the levelling feet: by turning them
clockwise –the front of the appliance rises, by
turning them counter clockwise –it comes
down. If the appliance is tilted slightly
backward –the doors will close by themselves.
•If the appliance is placed in a corner, a gap of
at least 5 cm must be left between the
appliance body and the wall.
Preparing for operation:
•It is recommended to prepare the appliance for operation with a helper.
•Remove package. Lift the appliance away from foamed polystyrene base. Therefore
take out adhesive tapes from sides and simply lift the appliance up and take out the
board. Strip adhesive tapes off and open the door. Remove all the red coloured parts,
they are only used for the transportation of the appliance.
