- 5 -
Microscope operation instruction
1. After installing microscope well. Turn on the power supply.
2. When the power is turned on, the camera power indicator is green and the display
power indicator is blue.
4. Turn on power of four-zone light source select the area light source and adjust
the brightness according to the need. (Note: try not to keep the brightness in the
brightest state for a long time, so as not to reduce the service life)
5. Adjust lens to max. magnification 5.0X. Adjust the focus holder. The working
distance is about 86 mm. At this time, the image will appear on the display screen.
Attention to increase or decrease the brightness of the light source to make the
image in the clearest state.
6. Adjust lens to min magnification 0.6X. At this time, the image is not clear. Adjust
CCD fine focusing tube to let the image is the clearest.
7. Repeat more than 5.6 steps twice, finish lens parfocal. Adjust each magnification
has a clear image.
8. Then we can observe with 2D or 3D.
Special tips: 3D observation. Users need push 2D/3D rotation viewer 2D observation
position. Adjust the zoom lend to 0.6X and put the position of observing part to the
center of display screen. Then adjust the focusing holder let the image clear. Then
adjust the zoom lens up 0.6X. Pull to 3D observation position. The screen will present
a clear 3D picture. Users can 360°rotation observation. Also can adjust zoom lens
magnification to observe. The image will remain clear and no longer need to focus
again.
