This remote control includes a childproof “LOCK-OUT” feature that allows the user to “lock-out” operations from the transmitters.
• To activate the “LOCK-OUT” feature, press and hold the ON and OFF icons on the
LCD screen together, for 5 seconds. The lock icon will appear on the LCD screen.
• To disengage the “LOCK-OUT”, press and hold the ON and OFF icons on the LCD
screen together, for 5 seconds. The lock icon will disappear on the LCD screen.
NOTE: If the appliance is already operating in the ON mode engaging the “LOCK-OUT”
will not cancel the operating mode.
CHILDPROOF “LOCK-OUT”
RECEIVER
Install the (4) AA-size batteries supplied with the unit. It is recommended that ALKALINE batteries always be used for this product. Be
sure the batteries are installed with the (+) and (-) ends facing the correct direction.
• REMOTE: will allow use of handheld transmitter. If the system does not respond
to the transmitter on initial use, check the battery positions in the remote. If that
does not work, see the LEARNING TRANSMITTER TO RECEIVER section.
• OFF: will disable the remote receiver.
• It is suggested that the slide switch be placed in the OFF position if you will
be away from your home for an extended period of time.
The remote receiver has a 2-position slide switch for selecting the mode of operation
REMOTE/OFF
WARNING
This remote control system must be installed exactly as outlined in these instructions. Read all instructions completely before at-
tempting installation. Follow instructions carefully during installation. Any modications of this remote control or any of its compo-
nents will void the warranty and may pose a re hazard.
Do not connect any gas valve or electronic module directly to 110-120VAC power. Consult gas appliance manufacturer’s instruc-
tions and wiring schematics for proper placement of all wires. All electronic modules are to be wired to manufacturer’s specica-
tions.
The following wiring diagrams are for illustration purpose only. Follow instructions from manufacturer of gas valve and/or electronic
module for correct wiring procedures. Improper installation of electric components can cause damage to electronic module, gas
valve and remote receiver.
INSTALLATION
The remote receiver should be placed on or near the replace hearth. The remote receiver should be kept away from temperatures
exceeding 130º F. Battery life is also signicantly shortened if batteries are exposed to temperatures 130ºF or higher.
Before installation make sure the remote receiver slide switch is in the OFF position. After installation be sure that the slide switch is
moved to the REMOTE position.
HEARTH MOUNT
• The remote receiver can be placed on the replace hearth or under the re-
place behind the control access panel.
• Use the wires attached to the remote receiver to connect to the gas valve or
the electric module (Female spade connectors are provided).
REMOTE
LEARN
Requires 4-AA 1.5V
alkaline batteries
Learning
button
Remote Receiver
Battery cover slides on/off
Slide
Switch
REMOTE
OFF
OFF
REV. 5-16-16 Page 2
Skytech: RCAF-LMF/RD
www.FireplaceRemoteControls.com
