4.4 Device Install Position
To install this device you need have some necessary knowledge about Car Electronics. So
please make sure you have right person to make the first installation.
In the installation process, do not power on device. The following is some problem may
facing in the installation process, please note:
There have two kind of way to install the device: Hidden install and Open type install.
When install in special-purpose vehicle you can select hidden install, and when install in
temporary vehicle you can select Open type install.
I. To avoid be broken, the install position of the device should be hidden. The suggest positions are:
Covert within the dalle below the front windshield glass;
Covert around the front instruments panel (the cover of the instruments should not be metal)
Place Under the dalle below the rear windshield glass of the car.
II. Avoid the positions round emitters, such as reverse sensor, burglar alarm and other vehicle-mounted
communication devices.
III. Use the ribbon or sponge powerful double-sided adhesive to fasten the device.
IV.The device GSM Antenna and GPS Antenna are build-in, please make sure the GPS receiving surface
(the side with LED indicator) face to sky and no metal shelter above when install.
Note:
If there have metal thermal-protective coating or warm up coating on the windshield glass, the GPS
signal will be damped. That may cause the device work abnormal, please change install position.
If you want to install the device by Open type, you can paste the Velcro tape on the dalle below the
front windshield glass, and then fasten the device on it.
