BODYPACK TRANSMITTER AUDIO GAIN ADJUSTMENT
The audio gain control on transmitter has been factory-at the mid-range position for best
performance in most applications. This may be necessary for soft singers or talkers, or guitar
or basses with low outputs.
•To Increase Gain: Rotate the transmitter gain control clockwise with the screwdriver to
increase audio gain.
•To Reduce Gain: Rotate the transmitter gain control counter clockwise with the
screwdriver to reduce audio gain.
•To return audio gain to the factory setting, rotate the transmitter audio gain control to
the mid position
TIPS FOR ACHIEVING MAXIMUM PERFORMANCE
•Make sure you can always see a receiver antenna from the transmitter position.
•Keep the distance from transmitter to receiver antenna as short as possible.
•Point receiver antennas away from each other at a 45 angle from vertical.
•Avoid placing the receiver antennas near metal surfaces and obstruction.
•Monitor battery fuel gauge and replace battery as soon as red light is on.
•If stacking or rack mounting receivers In a multiple-system use situation, do not allow
antennas to touch or cross.
•Perform a walk-through before Performance or Presentation .If dead spots are found,
adjust location of receiver .If dead sports remain ,mark spots and avoid.
TROUBLESHOOTING
PROBLEM INDICATOR STATUS SOLUTION
No sound Red transmitter indicator is not
flash
Slide transmitter POWER ON/OFF switch to ON
Make sure battery is Inserted properly, observing battery
("+/."). If battery is inserted
properly. replace with fresh battery.
No sound Red transmitter indicator Is flash Slide transmitter MUTE/ON switch to ON position
No sound Red receiver POWER light off.
Make sure ac adapter is securely plugged into electrical
outlet and into de input connector. Make sure ac
electrical outlet works and supplies proper voltage.
No sound Receiver signal Indicators A/B
lights glowing
Turn up receiver volume control. Confirm that the output
connections from the receiver to the external equipment
are secure.
No sound
Receiver signal Indicators A/B
lights off, Transmitter and
receiver POWER lights glowing
Confirm transmitter’s and receiver’s frequencies match.
Move transmitter closer to receiver
Sound level differs
from level of a
cabled instrument
Receiver signal Indicators A/B
lights glowing
Adjust transmitter gain level to compessary
Adjust receiver volume as necessary
Sound level differs
with different guitars
Receiver signal Indicators A/B
lights glowing
Readjust transmitter gain level to compensate for
differences In guitar outputs
Distortion level
increases gradually
Receiver Signal Indicators A/B
Lights and transmitter LOW
BATTERY light glowing
Replace transmitter battery
Bursts Of noise or
other audible radio
signals present
Signal Indicators A/B lights on
Identify potential sources of interference (other
RF·sources) and turn off, remove or use a wireless
system operating on a different frequency
Momentary loss of
sound as transmitter
is moved around.
performing area.
Receiver signal Indicators A/B
lights off when sound is lost
Reposition receiver and perform walkthrough test, if
audim dropouts persist mark "dead" spots and avoid
them during performance
