7 / 15
4. Stereo outputs
1. MIX OUT
The mix left and right outputs are sent from the XLR sockets as
balanced signals.
2. SUB
The SUB output jack.
3. AUX OUT
AUX 1: This is an impedance balanced phone-jack type output. This jack
outputs the signals from AUX (AUX1) bus. You can use this jack, for
example, to connect an effect unit, cue box, or other monitoring system.
AUX 2: This is an impedance balanced phone-jack type output that outputs the signals from
AUX2 bus. You can use this jack, for example, to connect an effect unit.
Note: The channel fader can adjust the level.
4. AUX RET: MONO L/R
These are unbalanced phone-jack type line inputs. The signal received by these jacks is sent
to the MIX L/R buses and the AUX 1 (AUX 2) bus. These jacks are typically used to receive
the signal returned from an external effect device (reverb, delay, etc.)
Note: These jacks can also be used as an auxiliary stereo input. If you connect the L (MONO)
jack only, the mixer recognize the signal as monaural and will send the identical signal to the L
and R jacks.
5. PHONE
This is used for monitoring the master signal and individually monitoring each channel with
PFL.
6. MIX BALANCE OUT
Left/Right master out balanced interface.
7. 2TK IN
These two RCA phone sockets are unbalanced left and right line-level
inputs, used for connecting a playback device.
8. REC OUT
These two RCA outputs carry a copy of the MIX L and MIX R signals.
Here you can connect a recording device.
