8
SIRI PRO 57-68-80-90-130-160 Operating and Maintenance manual Ver 6.0
TILE CUTTER COMPONENTS (Fi . 2)
Th machin basically consists of:
1) Bas
2) Sliding rod
3) Handl
4) Squar
5) Ext nsion
6) Small squar
FITTING TILE CUTTER
Th til cutt r is d liv r d to th custom r insid a box, as shown in Fi .2 or in a cas
(optional).
To fit th til cutt r, it is th r for n c ssary to:
1) r mov th machin from th box
2) unscr w th knob on th cutting troll y Fi .4
3) unscr w th knob (A) that locks th squar in th conv ying position. Ins rt th pin
of th squar into th hol und rn ath th sliding rod. Lock th pin in th r quir d position
by placing th knob (A) in th slot of th squar and tight ning it in th hol on th bas
3) Unscr w th knob (B), op n th squar xt nsion (C) and r tight n th knob (B)
4) To mak incisions in larg til s, tak out th sid supports (D)
90°-INCISION
To mak this typ of incision, lock th squar against th block in such a way that th
squar is p rp ndicular to th sliding rod. (Pic. 6)
Position th til on th bas , plac it in contact with th squar and small squar (us th
millim tric scal s on th squar and small squar to adjust th dim nsions of th til on
which th incision is to b mad ).
Mak th incision on th til starting from th sid of th op rator. To mak th incision,
hold th handl , mov it upwards, pr ss th m tal slid r forward, hold this position (Pic.
7 ) and th n mov downwards th handl so that th cutting wh l com s into contact
with th til (B Pic 4 and 7.1). K ping th handl down, push it for all th til l ngth
towards th squar , to obtain a compl t incision (Pic.8.)
If th incision is not mad corr ctly, r p at th op ration.
BREAKING TILE
To br ak th til , aft r th incision has b n mad r l as th m tal slid r, lift th handl
so that th m tal slid r com s back to th original position. In this way th wh l do s
not touch th til any long r. Push th handl downwards in th position shown in Fi .5,
at a distanc b tw n 1 and 2 cm from th dg and mak pr ssur on th nd part of
th handl , as shown in pics 9 and 9.1.
