FCC INFORMATION(U.S.A)
1.IMPORTANT NOTICE:DO NOT MODIFY THIS UNIT!
This product,when installed as indicated in the
instructions contained in this manual , meets FCC
requirements,Modifications not expressly approved
by KDS may void your authority,granted by the
FCC,to used this probuct.
2.IMPORTANT:When connecting this product to
accessories and/or another product use only high quality
shielded cables,Cable(s)supplied with this product
MUST be used.Follow all installation instrutions.Failure
to follow instructions could void your FCC authorization
to use this product in the U.S.A.
3.NOTE:This product has been tested and found to
comply with the requirements listed in FCC Regulations.
Compliance with these requirements provides a
reasonable level of assurances that your use of this
product in a residential environment will not result in
harmful interference with other electronic devices,This
equipment generates/uses radio frequencies and ,if not
installed and used according to the instructions found
in the owner's manual,may cause interference hamful
to the operation of other electronics devices,compliance
with FCC regulations does not guarantee that
interference will not occur in all installations.If this
product is found to be the source of interference,which
can be detemined by turning the unit"OFF"and "ON",
please try to eliminate the problem by using one of the
following measures:
Relocate either this product or the device that is being
affected by the interference.
Use power outlets that are on different branch(circuit
breaker or fuse)circuits or install AC line filter(s)
In the case of radio or TV interference,relocate/reorient
the antenna.If the antenna lead-in is 300-ohm ribbon
lead,change the lead-in to coaxial type cable.
If these corrective measures do not produce satisfactory
results,please contact your local retailer authorized to
distribute KDS products
CAUTION
The apparatus is not disconnected from the AC power
source so long as it is connected to the wall outlet,even
if the apparatus itself is turned off. To fully insure that
the apparatus is indeed fully void of residual power, leave
unit disconnected the AC outlet for at least fifteen
seconds.
1.To ensure the finest performance,please read this
manua carefuily,keep it in a safe place for future reference.
2.Install your unit in a cool.dry,clean place - away from
windows,heat sources,and too much vibration.dust,
moisture or cold Avoid sources of hum (transformers,
motors),To prevent fire or electrical shock,do not expose
to rain or water.
3.Do not operate the unit upside-down.
4.Never open the cabinet.if a foreign obiect drops into
the set,contact your deafer.
5.Place the unit in a location with adequate air circulation.
Do not interfere with its proper ventilation;this will cause
the internal temperature to rise and may result in a failure.
6.Do not use force on switches,knobs or cords,When
moving the unit,turn the unit off first,Then gently disconnent
the power plug and the cords connecting to other equipment.
Never pull the cord itself.
7.Do not attempt to clean the unit with chemical solvents
this might damage the finish,Use a clean,dry cloth.
8.Be sure to read the "Troubleshooting" section on common
operating errors before concluding that your unit is faulty.
9.This unit consumes a fair amount of power even when
the power switch is turned off.We recommend that you
unplug the power cord from the wall outlet if the unit is not
going to be used for a long time.This will save electricity
and help prevent fire hazards.To disconnect the cord.pull
it out by grasping the plug.Never pull the cord itself.
10.To prevent lightning damage,pull out the power cord
and remove the antenna cable during an electrical storm.
11.The general signals may interfere with other
equipment such as tuners or receivers .Move the system
farther away from such equipment if interference is
observed.
NOTE:
Please check the copyright laws is your country before
recording from records,compact discs,radio etc.
Recording copyrighted material may infringe copyright laws.
Voltage Selector (General Model Only)
Be sure to position the voltage selector to match the voltage
of your local power lines before installing the unit.
SAFETY INSTRUCTIONS
3
CAUTION:READ THIS BEFORE OPEARATING YOUR UNIT
