The procedure is as follows:
1. Press and hold the Security button on Bridge B for 10 seconds, then release. Once released,
the Power light will flash.
The password to Bridge B has just been erased and removes itself from Bridge A & C.
2. Press and hold the Security button on Bridge D for 2 seconds.
3. Within 120 seconds after the Power light on Bridge D starts to flash, press and hold the Security button on
Bridge B for 2 seconds then release.
4. Bridge B and Bridge D are now connected to each other, which in turn becomes part of Network BDE.
3 Troubleshooting and Disclaimer
If your HomePlug AV2 nano Ethernet Bridges have difficulty communicating with each other, check the following:
Try power cycling the unit by unplugging it from the wall for 10 seconds and plugging it in again.
Hold the security/reset button down for more than 15 seconds to reset to default setting. The HomePlug AV2
nano Ethernet Bridge’s light will flash, the units will reset and attempt to link using default factory settings.
Try plugging the HomePlug AV2 nano Ethernet Bridge into an adjacent plug.
HomePlug AV2 Ethernet Bridges work better when plugged directly into the wall outlet. Connecting these Ether-
net Bridges to a power strip or surge protector may degrade network performance or completely stop network
signals.
This HomePlug AV2 nano Ethernet Bridge should not be used on GFI protected outlets as some outlets will filter
out HomePlug Powerline signal.
This HomePlug AV2 nano Ethernet Bridge should not be used in areas with excessive heat.
Certain florescent or incandescent lights are noise sources on the electrical and can degrade performance.
If your building has more than one circuit breaker box, your HomePlug AV2 Ethernet Bridges may not be able to
connect between the different circuit breaker boxes. In this case, connect one HomePlug AV2 Ethernet Bridge to
a power outlet located on each of the circuit boxes. Connect Ethernet cable between each of the HomePlug AV2
Ethernet Bridges to link the different circuits together. This will allow the HomePlug AV2 Ethernet Bridges from
different circuit breaker boxes to connect.
