Sinclair ASH-09AF Guide de démarrage rapide
AIR CONDITIONING
Internet: http://www.sinclair-eu.com
E-mail: info@sinclair-eu.com
WALLMOUNTED SPLIT AIR CONDITIONER SINCLAIR
OPERTIONAL MANUAL
ASH-09AF, ASH-12AF
FLAT SERIE
Before operation please carfully read this manual.
Ｃｏｎｔｅｎｔｓ
Structure and Function
1
Important Advice 2
Specificate Model and Technical Data ５
Name and Function of Every Button of Wireless Remote Control 6
Operation Guide 8
Install Note Items 9
Install of Indoor Unit 12
Install of Outdoor Unit 14
Trial Run 17
Repair and Maintenance 18
When the unit cannot run normally 19
KFR-20GW/NaA512
Structure Principle and Usage
Install Part
Repair
Maintenance
and
Structure Principle and Usage
Structure and Function
◆
Ｐａｎｅｌ Ｆｉｌｔｅｒ
Air out
ｃｏｖｅｒ ｐｌａｔｅ
Ｄｒａｉｎａｇｅ ｈｏｓｅ
Power plug
Wireless remote control
Ａｉｒ ｉｎ
Front grill of air outlet vent
：
Heat
Air out
Outdoor
unit
Ｗｉｒｅ ｃｏｎｎｅｃｔｉｏｎ
ｕｎｉｔ
Ｉｎｄｏｏｒ
Ａｉｒ ｉｎ
:Cool/Dry
:Run
:Auto
Connection pipe and wire
Important Advance (Read the follwoing items carefully before using the unit)
Insert power plug firm enough
shock or fire.
For loose insert may cause electric
Don't plug out power plug
when unit is operating.
occur.
Or electric shock or fire may
Don't damage wire or use the
wire that is not appointed.
Or electric shock or fire may
occur.
Don't share socket with other
appliances or use prelonged hose.
occur.
Or electric shock or fire may
Don't operate unit with wet
hand for electric shock may occur.
vents, or damage may occur.
Don't let cooled air blows body
directly for too long, and don't
set indoor temp. too low for it is
If abnormal phenomenon occurs
(like burning odor etc.), cut off
power supply first, then contact
Gree Service Center. If abnormal
continues, the unit may be damaged
and cause electric shock or fire.
Don't repair the unit yourself
for incorrect repair may cause
electric shock or fire. So, contact
Gree Service Center to have
ＷＡＲＮＩＮＧ
Don't insert finger or stick-
like thing into air inlet and outlet
Danger
Structure Principle and Usage
not good for health.
Cut off power
unit repaired.
★Earthing: Earth must be
reliable! Earth wire should be
connected on special earth settings．
connected by perfessional personnel
Don't connect earth wire onto gas
pipe, water pipe, blowing pipe or
★Plug out power plug when the
unit will not be used for a long time.
★Cut off power when cleaning
the unit. Otherwise, electric shock
or damage may occur.
Otherwise, fire may be caused
★Don't plug out the plug by
pulling the power hose.
for over heat of wire.
★Don't let the unit blows to
monoxide poisoning may occur for
heater or cooker directly. Or carbon
incomplete burn.
★Chemical sprayer must be
placed 1m away from both indoor
and outdoor unit to prevent fire
without repair, unit may fall down
★Note if install chassis is
damaged. If the chassis is damaged
and cause injury.
things may fall down and cause
★Don't stand or put things on
the outdoor unit. For people or
injury.
★Don't block the air inlet or outlet
vent of both indoor and outdoor unit.
It would cause low performance
or stop of unit.
If there is no such settings, have it
place where perfessiona personnel
Structure Principle and Usage
considers it unrealiable.
or explosionor explosion
４
50Hz~230V
Proper set temp. can save electricity.
Indoor temperature should be set properly
When the unit is running, adjust up and down adjusting plate
●Adjust airflow and direction properly
by wireless remote control can adjust vertical direction of
air, hold the adjust plate that control left and rignt direction
can adjust horizontal flow direction of air.
●Don't blow pets or plants directly for it is not
good for them.
Left and right adjust plate
When the unit is running, don't open windows
or doors of the room for long time.
It would lower performance of the unit.
Temp. dif of
indoor and outdoors
Don't pour water on the unit or wash it by water
for malfunction or electric shock may occur.
Power hose of this unit adopts X type connection, don't
cut off or damage it and signal control wire. If power
hose or signal wire is damaged, please have them
changed by trained maintainer.
The unit allow voltage fluctuation of ２３０±１０％Ｖ，
too low of voltage may increase libration of
compressor that cause damage on cool system.
This unit cannot be used to dry clothes or refrigerate
and store foods etc..
Up and down adjust plate
Structure Principle and Usage
ＮＯＴＩＣＥ
should be５℃
Specificate Model and Technical Data
All above are tested according to standard ＧＢ／Ｔ７７２５－１９９６, cooling capacity, heating capacity and noise etc. are tested before leaving factory
If the data are changed, please refer the one offered on nameplate.
Model ASH-07AF ASH-09AF ASH-12AF
Function Cooling and Heating Cooling and Heating Cooling and Heating
Cooling Capacity（W）2000 2500 3500
Heating Capacity（W）2300 2700 3700
Rated Voltage 230V～
Rated Frequency 50Hz
Cooling/Heating Rated Power (W)
920/920 920/920 1440/1440
Cooling/Heating Rated Currency (A)
4/44/46.26/6.26
Air Flow（m３/h）450 450 500
Name of Refrigerant and Charge Amount
R410A1. 2kg R410A1.35kg R410A1.4kg
Noise (Indoor/Outdoor) dB（A）
38/52 38/53 40/54
Climate Type T1
Water-proof Level IP×4
Electric Shork Proof Protect Type
I
Weight (Indoor/Outdoor) (kg)
11/32 11/32 11/36
Outline Diameter (Indoor/Outdoor)
（W×H×D）（cm）
Indoor：101.5×29.0×15
Outdoor：84.8×54.0×32.0
Structure Principle and Usage
Remote control operation procedure
Name and Function-Remote control
Note:
Be sure that there are no obstructions between receiver and remote controller.
The remote control signal can be received at the distance of up to about 10m.
Don’t drop or throw the remote control.
Don’t let any liquid in the remote controller and put the remote controller di-
rectly under the sunlight or any place where is very hot.
SWING button
When it is pressed, the louvers
start to rotate automatically and
stop when repressed.
TEMP.button
SET TEMP. increases 1 by
pressing button once,and decreases
1by pressing button once.
At COOL mode operation, SET
TEMP. can be selected from 16 to
30 .
At DRY mode operation, SET TEMP.
can be selected from 16 to 30 .
At HEAT mode operation, SET
TEMP. can be selected from 16 to
30 .
MODE button
press this button to change the
operation mode in order of:
FAN button
Press this button to change
the fan speed of:
“ ” COOL mode
“ ” DRY mode
“ ” FAN mode
“ ” HEAT mode
ON/OFF button (1/0is
used in some models)
Press this button to turn on
or turn off the unit.
AUTO
3
REMOTE CONTROL OPERATION PROCEDURE
Name and Function-Remote control. (Remove the cover)
Note: This type of remote controller is a kind of new controller.
some buttons of the controller which are not available to thisAir condi-
tioner will not be described below.
Operate on unmentioned buttons would not impact on the normal use.
SLEEP button
Press this button to set
SLEEP operation.And stop
when repressed.
TIMER OFF button
At operating, press TIMER
OFF button, set OFF TIME
in range of 0 to 24 hour to
stop the unit automatically.
TIMER ON button
At stopping, press TIMER
ON button, set ON TIME in
range of 0 to 24 hour at the
interval of 0.5h to start the
unit automatically.
0 24h
Timer
cancellation
0 24h
Timer
cancellation
Liquid crystal displayer It
shows all set contents.
1/0 is used in some
models
4
REMOTE CONTROL OPERATION PROCEDURE
COOL mode operation procedure
According to difference between room temp. and set temp., microcomputer can control cooling on or
not.
If room temp. is higher than set temp., compressor runs at COOL mode.
If room temp. is lower than set temp., compressor stops and only indoor fan motor runs.
SET TEMP. should be in range of 16 to 30
4.Press FAN button, set
fan speed.
5.Press TEMP. but-
ton, set suitable SET
TEMP.
2.Press MODE button,
set operation
mode.
3.Press SWING button,
the louvers start to ro-
tate automatically, and
stop when repressed.
1.Plug in, press ON/OFF button
(1/0is used in some models),then
air conditioner is turned on.
5
REMOTE CONTROL OPERATION PROCEDURE
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Sinclair Climatiseur
Sinclair
Sinclair SDV4 series Manuel utilisateur
Sinclair
Sinclair ASH-09AQ Manuel utilisateur
Sinclair
Sinclair MC-C24AI Manuel utilisateur
Sinclair
Sinclair SF-51H Manuel utilisateur
Sinclair
Sinclair FOCUS Series Manuel utilisateur
Sinclair
Sinclair ASH-09AIK Manuel utilisateur
Sinclair
Sinclair SF HM2 Series Manuel utilisateur
Sinclair
Sinclair ASC-24BI Manuel utilisateur
Sinclair
Sinclair MS-H09AICN PT Manuel utilisateur
Sinclair
Sinclair ROCKY Series Manuel utilisateur
Sinclair
Sinclair ASGE-09AIN WK Manuel utilisateur
Sinclair
Sinclair SF-F3 Series Manuel utilisateur
Sinclair
Sinclair SDV5 EAM Series Manuel utilisateur
Sinclair
Sinclair AST-24AI Manuel utilisateur
Sinclair
Sinclair ROCKY SERIES ASH-09AIR Manuel utilisateur
Sinclair
Sinclair SF-08C Manuel utilisateur
Sinclair
Sinclair MV-F BI Series Manuel utilisateur
Sinclair
Sinclair AST-24BI Manuel utilisateur
Sinclair
Sinclair SDV4 series Manuel d'utilisation
Sinclair
Sinclair ASH-18BIF Manuel utilisateur
