SIMAG SP 405 Manuel utilisateur
ELECTRONIC MODULAR FLAKERS
SP 405 – SP 605
ICE CHUTE KIT INSTALLATION
PROCEDURES
1. Remove first the Front/Top Panel. 2. Remove pre-punched small panel from right or…
Page 1/5
……..rear panel.
3. Install at bottom side of the opening gasket included
in the kit.
4. Remove the ice chute with Optical Ice Level control
secured on it.
Unscrew the screw securing the ice spout metal bracket
to the frame of the ice machine.
5. Remove the rubber band from the insulation of
plastic ice spout.
6. Remove the two polystyrene insulation.
Page 2/5
7. Unloose the two screws securing the ice spout
metal bracket to the ice breaker and remove it
8. Remove the plastic ice spout.
9. Unloose and remove the four ice-breaker screws
and…..
….turn the same toward the selected opening. Secure
again the ice-breaker with its screws in the new
position.
10. Remove the Ice Level Control from ice chute
and……
Page 3/5
……move it through the ice opening so to have the
same available just outside the unit frame.
11. Fit plastic ice spout by its two screws onto the ice
breaker (new position).
12. Install ice spout insulation.
13. Install Ice Level Sensor onto the new ice chute
included in the kit securing it to the two drilled holes.
14. Insert the new ice chute through the selected
opening of the panel.
15. Secure it back to the ice spout.
Page 4/5
16 . Re-fit the Front-Top panel.
Page 5/5
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels SIMAG Machine à glaçons
SIMAG
SIMAG SPN 125 Manuel utilisateur
SIMAG
SIMAG SPR 80 Guide de configuration
SIMAG
SIMAG SD 10 Manuel utilisateur
SIMAG
SIMAG SV 325 Manuel utilisateur
SIMAG
SIMAG SDE30 Manuel utilisateur
SIMAG
SIMAG SDE Series Guide de l'utilisateur
SIMAG
SIMAG SD 22 Manuel utilisateur
SIMAG
SIMAG SDE34 Manuel utilisateur
SIMAG
SIMAG KGCW22 Manuel utilisateur
SIMAG
SIMAG SV 145 Manuel
