SIIG JU-CSL111-S1 Manuel utilisateur

USB 3.0 Data KM Magic

Switch Console Cable

User manual

P/N: JU-CSL111-S1

MAGIC SWITCH User Manual

SYSTEM REQUIREMENTS

Windows

OS: Windows 10 / 8.1 / 7 (SP1) (32/64 bit)

Available USB port: USB3.0 is recommended

Use USB3.0 Host: Fresco FL1000 / FL1009 install additional Host Driver

USB Host not supported: Asmedia, Etron 168 / 188, Via 801/ Via 805

CPU: Intel Pentium IV Processor or later

RAM: 1G or above

Hard Disc Capability: at least 100MB

Mac

Mac OS X 10.14/10.13/10.12/10.11/10.10

Available USB port: USB3.0 is recommended

CPU: Intel Pentium IV Processor or later

RAM: 1G or above

Hard Disc Capability: at least 100MB

Notes

※Windows RT not supported.

※On Windows Vista，restart your computer after the initial installation.

※Virtual Windows or Mac OS by VMware is not supported.

※The computer/user needs to have administrator rights.

※If one of the two connected computers restarts, reboots, sleeps or hibernates, please

disconnect and reconnect both sides of the Magic Switch.

MAGIC SWITCH User Manual

Windows installation

Please follow the instructions below to install the Magic Switch driver.

1. Connect one end of the Magic Switch to a standard USB port on one of the two computers.

And connect the other end of the Magic Switch to aUSB port on thesecond computer.

2. The device willautomatically start the Magic Switch software installation on both

computers. An AutoPlay option window may appear. Please double-click the Magic

Switch icon to start the application.

3. If the User Account Controlwindow appears on the screen, click Yes to continue.

4. Please run the steps above on both computers. If the other computer is a Mac, please refer

to the Mac installation guide.

5. When the Magic Switch is connected properly the Magic Switch launch page will be

shown.

The Magic Switch icon will appear in the lower right-hand corner. If the two units are

connected to the USB3.0 port this icon will appear, indicating the transmission speed as

USB3.0; however, if a USB2.0 port is connected to one end, then this icon will appear,

indicating that the transmission speed is USB2.0. If the icon appears it means the other

computer is not connected. When this icon appeared means the keyboard & mouse is

under controlled by other computer.

6. Please set the position of the other PC. Please click on the Magic Switch or icon to

open the Magic Switch toolbar. Then click on The Position of Other PC and select the

screen location according to where you want your mouse to flow from one screen to the

other.

MAGIC SWITCH User Manual

Mac installation

Please follow the instructions below to install the Magic Switch driver.

1. Connect one end of the Magic Switch to a standard USB port on one of the two

computers. And connect the other end of the Magic Switch to aUSB port on the second

computer.

2. When you initially connect the Magic Switch to the MAC computer the Keyboard Setup

Assistant window may pop up, follow the steps to select the keyboard type.

3. When both ends of the Magic Switch plugged into the computers’ USB ports, the Magic

Switch drive will appear on the desktop, double-click Magic Switch icon to

start the software.If the Enable access for

assistive devices window appears on the screen,

click Yes to continue.

4. Please run the steps above on both computers. If the other computer is a Windows, please

refer to the Windows installation guide.

5. When the Magic Switch is connected properly the Magic Switch launch page will be

shown.

The Magic Switch icon will appear in the lower right-hand corner. If the two units are

connected to the USB3.0 port this icon will appear, indicating the transmission speed

as USB3.0; however, if a USB2.0 port is connected to one end, then this icon will appear,

indicating that the transmission speed is USB2.0. If the icon appears it means the

other computer is not connected.

6. Please set the position of the other PC.Please click on the Magic Switch or icon to

open the Magic Switch toolbar. Then click on The Position of Other PC and select the

screen location according to where you want your mouse to flow from one screen to the

other.

MAGIC SWITCH User Manual

Functions:

Explore the Magic Switch’s convenient and user-friendly features.

9Keyboard and Mouse Sharing

Move your mouse cursor between two computers naturally and seamlessly.

9ɈPlease use a keyboard and mouse set.(The keyboard switch function always applies to

the computer the mouse is currently on).

9Switch the keyboard usage to another computer

Move the mouse cursor to the second computer and open any editing application such

as Word, Excel, Power Point, etc. and use the keyboard of the first computer to type the

text on the file of the second computer.

9Clipboard Sharing

With the clipboard sharing feature you can easily copy and paste clipboard content

bi-directionally between two computers.

9File Transferring

Quickly and easily transfer files between two computers. Simply copy/paste or

drag/drop the file or folder to the other computer.

9ɈPlease use the original system hotkey settings on your computer operating system (the

keyboard always follows the mouse cursor).

MAGIC SWITCH User Manual

SOFTWARE INSTRUCTIONS

To begin set up, please click the Magic Switch utility icon or , found on both Mac OS &

Windows OS.

MAC OS:

Windows OS:

9The Position of the Other PC烉You can quickly set up the position of the other computer by

using one of the 4 options (Right/Left/Up/Down)

9Temporarily Disable/Enable the keyboard/mouse and/or clipboard sharing function烉You

can quickly disable or enable the sharing option.

9Preference Setup

MAC OS Windows OS:

3Keyboard and Mouse Control Switch Settings烉

¾Off: Turns the mouse/keyboard sharing option off.

¾Use the Mouse to Move off the Edge of the Screen烉You can adjust your

settings so that your mouse moves from one computer’s screen to the other

computer’s screen from either the right/left/up/down side of the PC.

¾Use only the Hotkey to switch烉You can setup the hotkey to activate the

keyboard/mouse control switch. The default hotkey is (Alt+S)

3Clipboard Share Options烉Turn Off or Auto Share

MAGIC SWITCH User Manual

3Others烉

¾Show Connection Information烉Un-checking this setting means the launch page will

not be shown when you start up the device.

ɈThis option is only available on Mac OS computers.

¾Resident this Application烉When you choose this setting the Magic Switch program

automatically setsup every time you connect the Magic Switch device.

¾Enable Access for System Hotkey烉Choose this setting to activate the Hotkey function.

ɈThis option is only available on Mac OS computers.

¾Double Click the System Tray Icon to Turn Sharing On/Off Temporarily烉Enable/disable

the clipboard sharing and keyboard/mouse control functions by simply double clicking

the icon on the bottom right-hand side of the taskbar.

ɈThis option is only available on Windows OS computers.

¾Send Ctrl-Alt-Del to another computer烉This option allows for alternative key options

for the [Ctrl-Alt-Del]command for the second computer.

ɈThis function is only available when 2Windows OS computersare connected.

9Online Update烉Check and update the latest version of software for the Magic Switch.

1. Please make sure you are connected to the internet and Do Not disconnect the

Magic Switch during the driver update.

2. Remove the Magic Switch cable from the slave computer.

3. Select Online Update

4.After you have finished the installation process,disconnect and then reconnect

the Magic Switch device on both computers.

9About Magic Switch:Software version information can be found here.

9Quit USB Switch/ Exit:The Magic Switch can be uninstalled in the confirmation box.

Magic Switch compability issue on macOS 10.14

We have tested our Magic Switch on the oﬃcial release of macOS 10.14 Mojave and we have

conﬁrmed that this device is compable with the newest macOS operang system. However, we

have found that you may need to allow the Magic Switch applicaon on macOS 10.14.

Please follow these steps below:

1.) Please unplug the Magic Switch ﬁrst

2.) Open System Preferences→Click on

Security & Privacy →Click on the Privacy

tab.

3.) Plug-in the Magic Switch. When the

system appears "Accessibility Access

(Events)" press "Open System Preferences"

4.) Click on “Click the lock to prevent further

changes" and key in your mac password to

make change.

5.) Check-Mark the box next to

GoBridgeDaemon or Magic Switch

7.) Click the lock again to save the changes.

Table des matières

Autres manuels SIIG Câbles et connecteurs

SIIG

SIIG USB-to-PS/2 Adapter Manuel utilisateur

SIIG

SIIG AV-GM06J3-S1 Manuel utilisateur

SIIG

SIIG AV-GM06E3-S1E Manuel utilisateur

SIIG

SIIG AV-GM06K3-S1 Manuel utilisateur

SIIG

SIIG AV-GM06B3-S1 Manuel utilisateur

SIIG

SIIG AV-GM05G3-S1 Manuel utilisateur

SIIG

SIIG AV-GM06H3-S1 Manuel utilisateur

SIIG

SIIG AV-GM0683-S1 Manuel utilisateur

SIIG

SIIG ID-SC0911-S1 Manuel utilisateur

SIIG

SIIG USB 3.0 Manuel utilisateur

SIIG

SIIG CE-CH0312-S1 Manuel utilisateur

SIIG

SIIG JU-P40212-S1 Manuel utilisateur

SIIG

SIIG 1x8 HDMI Splitter with 4Kx2K & EDID... Manuel utilisateur

SIIG

SIIG AV-GM06N3-S1 Manuel utilisateur

SIIG

SIIG CE-H20M11-S1 Manuel utilisateur

SIIG

SIIG MHL Manuel utilisateur

SIIG

SIIG CE-H22K12-S1 Manuel utilisateur

SIIG

SIIG USB 2.0 to SATA/IDE Manuel utilisateur

SIIG

SIIG USB 3.0 4-Port Bay Hub Manuel utilisateur

SIIG

SIIG CE-VG0B11-S1 Manuel utilisateur

SIIG

SIIG ID-SC0211-S2 Manuel utilisateur

SIIG

SIIG CE-DV0031-S1 Manuel utilisateur

SIIG

SIIG AV-GM05L3-S1 Manuel utilisateur

SIIG

SIIG AV-GM06M3-S1 Manuel utilisateur

Manuels Câbles et connecteurs populaires d'autres marques

Philips

Philips SWA6310 Manuel utilisateur

StarTech.com

StarTech.com CRJ4550PK Manuel utilisateur

Nohau

Nohau EMUL-IP2K-PC Manuel utilisateur

Foxun

Foxun SX-SP144E-HD4K2K Manuel utilisateur

Philips

Philips SWA3305W Manuel utilisateur

opticis

opticis Stretch DVIM1-1P0x Manuel utilisateur

Volkswagen

Volkswagen VAS 6558A Manuel utilisateur

NEXIBO

NEXIBO N-13 Manuel utilisateur

CYP

CYP PU-1H3HBTL Manuel utilisateur

Allen-Bradley

Allen-Bradley 1784-u2dhp Manuel utilisateur

Global Caché

Global Caché Flex Link Blaster Manuel utilisateur

Hauppauge

Hauppauge USB-Live2 Manuel utilisateur

Fenix

Fenix MPSV 15 Manuel utilisateur

BEGA

BEGA 71 085 Manuel utilisateur

Tesla

Tesla HPWC Manuel utilisateur

GAMERON

GAMERON LUXURY TV CABLE Manuel utilisateur

molex

molex Milli-Grid Dual row 87568 Series Manuel utilisateur

Burndy

Burndy Continental Industries thermOweld CRE-7 Manuel utilisateur