Shure 33-44 Series Manuel utilisateur
1/5
33-44 Series -- Phono Cartridge
General Description
Shure cartridges can be used in DJ or Hi-Fi applications.
The M70BX is not recommended for heavy scratching.
Install Your Cartridge
1. Carefully remove the stylus from the cartridge. See Figure 1.
2. Use needle-nose pliers to connect the colored wires from the tonearm headshell to the corresponding pins on
the cartridge. See Table 1 and Figure 2.
Table 1. Cartridge Wiring
HEADSHELL WIRE COLOR PIN
RIGHT "HOT" RED R
RIGHT GROUND GREEN RG
LEFT "HOT" WHITE L
LEFT GROUND BLUE LG
Figure 1
Shure Incorporated
2/5
Figure 2
Figure 3
1. Attach the cartridge to the headshell using the screws supplied. See Figure 3. Tighten the screws after posi
tioning the cartridge (and headshell weight, if desired) according to one of the methods described below.
2. Carefully insert the stylus into the cartridge.
Choose a Method for Cartridge Positioning
HI-FI Setup: For maximum fidelity and minimal record wear, position the cartridge using an alignment protractor or
the overhang gauge supplied with your turntable. Level your tonearm (See Figure 7). Use Table 2 and "Setting a
Precise Tracking Force", below, to set the typical tracking force for your cartridge. Set the anti-skate control to the
same number as the tracking force.
Shure Incorporated
3/5
Figure 4
Standard DJ Setup: Mount cartridge at rear of headshell. Set tonearm height to 4-5. Set tracking force to 3
grams. Set anti-skate control to 0.
Figure 5
Unorthodox DJ Setup: Reverse the counterweight and mount it flush with the end of the tonearm. Mount car
tridge (with headshell weight) flush with the front edge of the headshell. Set anti-skate control to 0.
Figure 6
Level Your Tonearm
Figure 7
Extra Skip Resistance for DJ's:
Mount the cartridge at a 23 degree angle as shown, so that the cartridge points to the tonearm pivot. Set anti-skate
to 0.
Shure Incorporated
4/5
Setting a Precise Tracking Force
1. After mounting the cartridge on the tonearm, rotate the circular weight at the back of the tonearm until the nee
dle floats evenly above the record.
2. Hold the circular weight in place and rotate the calibration ring to read zero. The tonearm should still float even
ly above the record.
3. Rotate the weight until the calibration ring indicates the desired tracking force.
Care and Cleaning
•DJs: Don't use more tracking force than necessary to prevent skipping. Excess force will burn records, damage
needles, and reduce sound quality.
•Clean the stylus with the supplied cleaning brush.
Brush from the back to the front only, as shown in Figure 9.
Figure 9
Cartridge Specifications
Table 2. Cartridge Specifications
Shure Incorporated
5/5
Car
tridge
Replace
ment Sty
lus
Stylus
Color
Stereo Output (1 KHz
at 5 cm/sec peak
recorded velocity)
Frequency
Response in
Hz
Tracking
Force Range
(grams)
Typical
Tracking
Force
(grams)
M44-7 N44-7 White 9.5 mV 20 to 20,000 1-3 3
M44G N44G Gray 6.2 mV 20 to 20,000 .75-1.5 1.5
M35S N35S Char
treuse
5.0 mV 20 to 20,000 3-5 4
35X N35X White 6.0 mV 20 to 20,000 1.5-3 3
M70BX N70BX Beige .0 mV 20 to 18,000 1.5-3 3
SC35C SS35S Light
Blue
5.0 mV 20 to 20,000 4-5 4.5
All Cartridges and Styli
•Standard ½ inch mount for DJ turntables
•Wide diameter styli for reduced record wear
•Optimum Load:
◦47 K Ohms, M44: 400-500 pF
◦M35, M70BX, SC35C: 200-300 pF
•Inductance:
◦M44: 720 Mh, M35
◦SC35C: 425 mH
◦M70BX: 600 mH
•Channel Separation: 20 dB at 1KHz
Table des matières
Autres manuels Shure Microphone
Shure
Shure PG185 Manuel utilisateur
Shure
Shure Microflex MX405 Manuel utilisateur
Shure
Shure Microflex MX395 Manuel utilisateur
Shure
Shure VP83F Manuel utilisateur
Shure
Shure AXT200 Manuel utilisateur
Shure
Shure R193 Manuel utilisateur
Shure
Shure SM7d1B Manuel utilisateur
Shure
Shure MV5 Manuel utilisateur
Shure
Shure 561 Manuel utilisateur
Shure
Shure PGA27 Manuel utilisateur
Shure
Shure ROSWELLITE KSM353/ED Manuel utilisateur
Shure
Shure KSM42 Manuel utilisateur
Shure
Shure Controlled Magnetic 444D Manuel utilisateur
Shure
Shure 520DX Manuel utilisateur
Shure
Shure KSM32 Manuel utilisateur
Shure
Shure SM90 Manuel d'instructions
Shure
Shure Conference Phone Manuel utilisateur
Shure
Shure SM58 Manuel utilisateur
Shure
Shure ULX-D Quad Z16-20 Manuel utilisateur
Shure
Shure PG Alta Series Manuel utilisateur
