M
Figure 4 Figure 5Figure 3
BATTERY REPLACEMENT
1. Replace the battery when appears in the lower right corner of LCD display.“ ”sign
2. Pull battery cover off as shown in Figure 3.
3. Gently pull out the plastic circuit board with battery chamber approximately 1 cm
(slightly less than1/2 (See Figure 4)").
4. Use pointed object such as pen to remove old battery. Discard battery lawfully. Replace
with new 1.5V DC button type LR41 or SR41,UCC392, or equivalent. Be sure battery is
installed with polarity facing up. (See Figure 5)“+”
5. Slide battery chamber back into place and attach cover.
LIMITED WARRANTY
Shikon Digital Thermometer carries a warranty of one year from the date of purchase. If
the thermometer does not function properly because of any defective components or poor
workmanship, it will be repaired or replaced free of charge. All components are covered
by this warranty excluding the battery. This warranty also does not cover damages to the
thermometer due to improper handling, normal wear and tear. To obtain warranty service,
kindly produce the original or copy of the invoice issued by the seller which is mandatory.
Disposal of this product and used batteries should be carried out in accordance with the national
regulations for the disposal of electronic products.
DIRECTIONS
2. Position the thermometer in the desired location (mouth, rectum, or armpit).
*Note: Normal mode: When te mperature reachesThe beep buzzes as“ Bi-Bi-Bi-B i-”;
37.8 (100 ) or higher ,t℃ ℉ he beep buzzes as “ Bi-Bi-Bi----- Bi-Bi-Bi------- Bi-Bi-Bi”
1. Press the On/Off Button next to LCD display. A beep will sound as the screen shows ,
followed by last recorded temperature. After showing the self-test temperature,
the thermometer is now in the testing mode.
Figure 2
CLEANING AND DISINFECTION
Wipe the thermometer with a soft clean cloth.
For stubborn stain, wipe the thermometer with a cloth dampened with water or a neutral
detergent solution and then wring thoroughly. Wipe dry with a soft dry cloth.
To prevent the thermometer from being damaged:
-Do not use benzene, paint thinner or other strong solvents to clean the thermometer.
-Do not soak the sensing probe (tip) of the thermometer in alcohol, OPA or using hot
water (at a temperature of 122℉/ 50℃ or higher).
-Do not use ultrasonic washing to clean the thermometer.
Made in India by:
SPACEAGE MULTIPRODUCTS PRIVATE LIMITED
16, Ganesh Chandra Avenue, Kolkata - 700 013, West Bengal, India
Mob: +91 94 3 3 0 46999 I info@sh i k on.co.in I www.shiko n . co.in
4. For prolonged battery life, press the On/Off Button to turn off after the measurement is
complete. If not turned off the device will automatically shut off after around10 mins.
3. During measurement the degree sign flashes. When it stops flashing, an alarm beeps for
10 secs and the measured reading appears on LCD screen. The minimum measurement
time must be maintained till the beep tone continues. We suggest to keep the probe in the
mouth and rectum for about 2 mins, or in armpit for about 5 mins regardless of the beep
sound to obtain accurate body temperature measurement result. An interval of 30 secs
should be maintained between each measurement.
c) Armpit Use: Wipe your armpit dry. Place the probe under the armpit and keep arm
pressed firmly at side. Medically, this method provides inaccurate readings, and should
not be used for precise measurements. The normal temperature will be between
95.4 98.1 (35.2 36.7 ).℉～℉℃～ ℃
b) Rectal Use: Lubricate silver probe tip with petroleum jelly for easy insertion. Gently
insert sensor approximately 1cm (less than 1/2 ) into rectum. The normal temperature "
will be between 97.2 99.9 (36.2 37.7 ).℉～℉℃～ ℃
a) Oral Use: Place the thermometer under the tongue as indicated by
position shown in Figure 2. Close your mouth and breathe “√”
normally through the nose to prevent the measurement from being
influenced by inhaled / exhaled air. The normal temperature will be
between 96.3 99.1 (35.7 37.3 ).℉～℉℃～ ℃
