9
●Duplex, stationary IP, thread connection (KC)
Screw the internal pipe taper thread into the head. For standard specification products, the
thread directions of the rotor and internal pipe are the same. Depending on the customer’s
request, the thread directions of the rotor and internal pipe may be different from each other.
Check the thread directions on the product drawings, etc. before installation.
●Duplex, stationary IP, flange connection (KCF)
Screw G thread (right-hand thread) of the internal pipe into the head, and then secure it with a
supplied lock nut.
Instruction
1. Do not subject the product to undue impact while it is being transported.
Falling down or impact causes product damage (seal ring, etc.) or early
leakage. If the product fell down or was damaged, contact us for maintenance.
2. When transporting a product with an internal pipe, do not secure the product
so that load is directly applied to the internal pipe. Doing so may bend the
internal pipe, hindering installation to a roll. Moreover, abnormal noise or early
leakage may result after installation.
4. Transport and Storage
4‐1) Transport
Transport this product by following the instructions described below.
4‐2) Storage
An improper storage method causes product damage or early leakage.
Store this product by following the instructions described below.
Instruction
1. Wrap the product before storing it to prevent the entry of foreign objects.
2. Store this product in a dry environment at 10℃ to 40℃.
3. The storage period should be within two years. If the storage period exceeds
two years, contact us for maintenance.
4. If the product is stored after use, clean and then store it under the above
conditions.
5. Installation to Machinery
5‐1) Internal pipe (for duplex only)
Install an internal pipe to the product according to the following instructions.
Product adjustment is not required before installation.
Instruction
1. When inserting an internal pipe into the product rotor, be careful so that the
pipe does not hit inner parts. Failure to do so could cause inner part damage,
resulting in fluid leakage.
2. When installing an internal pipe to the product, be careful not to bend the pipe.
If it is bent, product installation to a roll may be hindered. Also, vibration or
abnormal noise after installation, or early leakage may result.
