Operation Guide
1. Press and hold the Power button for 3 seconds to turn on the transmitter TX.
2. Insert the right adapter into the receiver RX according to your needs (Please refer to
“Accessories Installation” for detailed operation). Press and hold the Power button for
3 seconds to turn on the receiver RX.
3. Transmitter and Receiver pairing
Before leaving factory, the system has been paired successfully. If they are
disconnected or unpaired, please see below for pairing instructions:
①With the system powered on, double-click the Power button of the receiver. The
receiver indicator will flash rapidly in blue.
②When the receiver indicator flashes rapidly in blue, double-click the Power button
of the transmitter to enter pairing mode. When paired successfully, the indicators will
be in a solid blue state.
4. Connect the receiver to your camera.
5. You are ready to record.
Note: Due to 2.4GHz wireless frequency, signal can be easily attenuated. Please try to
avoid obstacles, such as walls and buildings, and avoid close proximity to devices with
2.4GHz signal, such as high-power wifi antennas, smartphones with wifi in use, radios,
etc.
06
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:(1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
FCC Warning
