Sentiotec VitaMy 164 Manuel utilisateur

Version 03/21 ID no. 1-038-133

INSTRUCTIONS FOR INSTALLATION AND USE

English

Infrared cabin

VitaMy 164

164 x 120 x 202 cm

VITAMY-164-B / 1-037-765: VitaMy 164 Basic

VITAMY-164-S&L / 1-037-768: VitaMy 164 S&L

Table of Contents

1. About this instruction manual 3

2. Important information for your safety 4

2.1. Intended use 4

2.2. Safety information 4

3. Product description 6

3.1. Scope of delivery VitaMy 164 Basic (1-037-765) 6

3.2. Scope of delivery VitaMy 164 S&L (1-037-768) 6

3.3. Product functions 7

4. Installation of the VitaMy 164 infrared cabin 8

4.1. Necessary tools 8

4.2. Infrared cabine VitaMy 164 Basic / BT / S&L parts list 8

4.3. Cabin installation 10

4.4. Installation of the infrared control 30

4.5. Installing the LED strip 33

4.6. Installation of the sound & light (only VitaMy 164 S&L) 34

4.7. Installation of the bench 35

4.8. Installation of spacer strips of the rear wall 35

4.9. Installation of the backrests and headrests of the bench 36

5. Cleaning and maintenance 37

5.1. Cleaning 37

5.2. Maintenance 37

6. Troubleshooting 37

7. Disposal 37

8. Technical data 38

9. Floor plan 38

Instructions for installation and use p. 3/40

1. About this instruction manual

Read these instructions for installation and use carefully and keep them within

reach of the infrared cabin. This ensures that you can refer to information about

your safety and the operation at any time.

Symbols used for warning notices

In these instructions for installation and use, a warning notice located next to

an activity indicates that this activity poses a risk. Always observe the warning

notices. This prevents damage to property and injuries, which in the worst case

may be fatal.

The warning notices contain keywords, which have the following meanings:

DANGER!

Serious or fatal injury will occur if this warning notice is not observed.

WARNING!

Serious or fatal injury can occur if this warning notice is not observed.

CAUTION!

Minor injuries can occur if this warning notice is not observed.

ATTENTION!

This keyword is a warning that damage to property can occur.

Other symbols

This symbol indicates tips and useful information.

Do not cover

These installation and operating instructions can also be found in the

downloads section of our website: www.sentiotec.com/downloads.

Instructions for installation and use p. 4/40

2. Important information for your safety

The infrared cabin has been produced in accordance with the safety

regulations applicable for technical units. However, hazards may

occur during use. Therefore adhere to the following safety informa-

tion and the specic warning notices in the individual chapters.

2.1. Intended use

The infrared cabin serves for warming the human body.

The location of the cabin has to be protected against splash water.

For optimum operation, the site should have an ambient tempera-

ture of at least 20 °C. The maximum ambient humidity should not

exceed 95%.

The cabin has to be placed on a at surface. A distance of at least

5 cm from the wall must be maintained.

Any use exceeding this scope is considered improper use. Improper

use can result in damage to the product, severe injuries or death.

Instructions for installation and use p. 5/40

2.2. Safety information

●Installation and connection of the electrical parts (control unit,

radiator, etc.) may only be performed when the power supply is

disconnected.

●Also comply with the regulations applicable at the installation

location.

●For your own safety, consult your supplier in the event of prob-

lems that are not explained in su󰀩cient detail in the installation

instructions.

●The cabin must not be used by children under 8 years old.

●The cabin may be used by children above 8 years old, by persons

with limited psychological, sensory or mental capabilities or by

persons with lack of experience/knowledge only when:

– They are supervised.

– They have been shown how to use the device safely and

are aware of the hazards that could occur.

●Children must not play with the cabin.

●Children under 14 years of age may only clean the cabin if they

are supervised.

●The cabin must not be cleaned with steam cleaners, high-pres-

sure cleaners or splash water.

●For health reasons, do not use the sauna when under the in-

uence of alcohol, medication or drugs.

● Make sure that no ammable objects have been placed on the

heater element before the control unit is switched on.

Instructions for installation and use p. 6/40

3. Product description

3.1. Scope of delivery VitaMy 164 Basic (1-037-765)

●1x Infrared cabine VitaMy 164

●1x 1-037-357 / Power unit wave.com4 Infra

●1x 1-012-222 / Control panel wave.com4 Infra

●1x 1-009-265 / Power supply cord infrared 2.5m

●2x 1-028-862 / Cable GST18i/3s – GST18i/3B 0.5m

●2x 1-028-731 / Distributor T-Form (3-pole) IR-1P2

●2x 1-027-788 / Infrared radiator ECO 500 - dark (pre-mounted ) front radiator

●2x 1-027-785 / Infrared radiator ECO 350 - dark rear radiator

●2x 1-028-348 / IR- Thermal plate 380 mm x 700 mm, 230V/100W (pre-mounted)

●2x 1-037-397 / Switch set IR thermal plate (pre-mounted)

●1x 1-028-660 / Vent round Espe 631-A

●2x 1-028-629 / Soapstone bow

●1x 1-052-935/ LED-Set WC4-Infra

3.2. Scope of delivery VitaMy 164 S&L (1-037-768)

in addition to VitaMy 164 Basic

●1x 1-028-257 / sound & light Set (colour lamp, power supply, control panel,

USBDock)

Instructions for installation and use p. 7/40

3.3. Product functions

Infrared cabin

Solid cabin made of spruce for the infrared radiation of 2 people.

Resin pockets are not grounds for complaint. This is because resin pockets

often occur in spruce and the depth at which they are located cannot be

determined during sorting.

If they are just below the surface, they break open during heat genera-

tion and "bleed".

The leaking resin can be removed with an acetone rag. If only resin drops

appear, let them cure and then scrape them o󰀨 carefully with a knife.

Infrared control wave.com4 Infra

Control for the dimming of 2 heating circuits each with a maximum of 1.5 kW as

well as the dimming of light and an optional fan.

The control unit only supports the operating mode “Intensity mode”.

sound & light colour light (only version VitaMy 164 S&L)

The sound & light colour light lets music be played via a USB stick and the cabins

be lit with di󰀨erent colours.

The colour of light can be selected manually or di󰀨erent colours can be displayed

in automatic mode.

Instructions for installation and use p. 8/40

4. Installation of the VitaMy 164 infrared cabin

Before you start work, check the parts list to see whether all the items have

actually been delivered. If individual items are missing, notify your dealer within

14 days after receipt of the cabin.

For the installation, you will need to have a helper!

We also recommend that the screw holes be pre-drilled.

4.1. Necessary tools

●Hammer and insert wood or a rubber mallet

●Cordless screwdriver with bits for Phillips screws and Torx

●Measuring tape

●Water level

●Drift punch or wooden blocks 12 mm

●Allen 1.5 mm

Pre-drill

60 cm

80 cm

100 cm

Check the right angle:

Handle glass with care: Special care must be taken with the edges of

the glass – hardened glass can shatter into small pieces in the event of

impact. Insert protective cushioning (e.g: cardboard box) under the edge

of the glass.

Instructions for installation and use p. 9/40

4.2. Infrared cabine VitaMy 164 Basic / S&L parts list

Base frame

1Rear oor frame 164 x 9 x 4 cm

2 Floor frame 114 x 9 x 4 cm

Wall elements

4 A/A Wall elements with Multiclip, W1,W2,W5,W6 193 x 54 x 4 cm

1 Electrical element according to type (see end

parts list) 193 x 20,6 x 4 cm

2 A/B wall elements with cutout, W3,W4 193 x 65,7 x 4 cm

Corner posts

2 Multi-clip corner plug 193 x 6 x 6 cm

1 Multi-clip corner plug left front 202 x 6 x 4 cm

1 Multi-clip corner plug right front 202 x 6 x 4 cm

1 Skirting above glass front 152 x 10 x 4 cm

Support slats

1 Roof support slat 156 x 4 x 4 cm

1 Roof support slat with drilled holes 156 x 4 x 4 cm

2 Roof support slat 112 x 4 x 4 cm

Ceiling elements

1 A/B ceiling element 152 x 54 x 4 cm

1 A/B ceiling element with fan recess 152 x 54 x 4 cm

Interior ttings

2 Spruce heater boxes 105 x 23 x 12 cm

2 IR thermal panel VitaMy 73,8 x 42 x 4,3 cm

2 U-Strip for IR thermal plate, left, right 41 x 6 x 6,5 cm

1Sti󰀨ener bar for thermal plate 156 x 4 x 2,5 cm

1 Bench 156 x 56 x 10 cm

2 Bench support slats, left, right 46 x 41 x 4 cm

1 Bench support slat 30 x 4 x 4 cm

4 Ergonomic backrest 70 x 18 x 10,5 cm

2 Headrest VitaMy 35 x 27,5 x 8 cm

2 Frame for 350 W heater, lime wood 73,5 x 23 x 2 cm

1 LED Cover strip 156 x 3 x 3 cm

1 Spruce base 155,4 x 64 cm

No.of

Items Name Dimensions

Instructions for installation and use p. 10/40

Glass element

1 Clear glass without wholes 194,5 x 47,4 x 0,8 cm

1 Clear glass with wholes for door hinges 194,5 x 47,4 x 0,8 cm

1 Clear glassdoor with wholes for door hinges 191,5 x 59 x 0,8 cm

Accessories

2Alu-Prole L=46 cm

1 Door handle set VitaMy

1 2 Door hinges 8652-02

1 Glasdoor seal 192 cm

2 Mounting rail for headrest 13,5 x 2 x 2 cm

1 Template for Multiclip installation backrest

1 Template for Multiclip installation glass front

2 Rear wall cover strip 202 x 5 x 4 cm

1 Installation material

1 Installation instructions

Elektroelement VitaMy 164 Basic 2 cutouts

Elektroelement VitaMy 164 - S&L 4 cutouts

No.of

Items Name Dimensions

Autres manuels pour VitaMy 164

Ce manuel convient aux modèles suivants

Table des matières

Langues :

Autres manuels Sentiotec Produits de plomberie

Sentiotec

Sentiotec ALASKA MINI Manuel utilisateur

Sentiotec

Sentiotec Karibu Modern Bio Manuel utilisateur

Sentiotec

Sentiotec Home combi Series Manuel utilisateur

Sentiotec

Sentiotec LAVA Manuel utilisateur

Sentiotec

Sentiotec Onni Small Manuel utilisateur

Sentiotec

Sentiotec Komfort Small Manuel utilisateur

Sentiotec

Sentiotec WELLFUN CORNER Manuel utilisateur

Sentiotec

Sentiotec SCALA Medium Manuel utilisateur

Sentiotec

Sentiotec LAVA Guide de configuration

Sentiotec

Sentiotec ARKTIS INFRA + Manuel utilisateur

Sentiotec

Sentiotec Onni 1-053-080 Manuel utilisateur

Sentiotec

Sentiotec wave.com4 11 kW Manuel utilisateur

Sentiotec

Sentiotec SCALA Large Manuel utilisateur

Sentiotec

Sentiotec ALASKA CORNER INFRA+ Mode d’emploi

Sentiotec

Sentiotec COUNTRY Manuel utilisateur

Sentiotec

Sentiotec VitaMy 164 Manuel utilisateur

Sentiotec

Sentiotec Concept R Emotion CPR-EMO-L1 Manuel utilisateur

Sentiotec

Sentiotec KUUSI 180 Manuel utilisateur

Sentiotec

Sentiotec KASKI 220 VIEW Manuel utilisateur

Sentiotec

Sentiotec KASKI 220 PANORAMA Manuel utilisateur

Sentiotec

Sentiotec Panorama Small Manuel utilisateur

Sentiotec

Sentiotec 1-030-313 Manuel utilisateur

Sentiotec

Sentiotec PHONIX-S Manuel utilisateur

Sentiotec

Sentiotec COUNTRY Manuel utilisateur

Manuels Produits de plomberie populaires d'autres marques

Weka

Weka 506.2020.00E Mode d'emploi

Kohler

Kohler K-6228 Instructions de montage

UBERHAUS DESIGN

UBERHAUS DESIGN 75175017 Manuel utilisateur

American Standard

American Standard DetectLink 6072121 Manuel utilisateur

Uponor

Uponor Contec TS Manuel utilisateur

Pfister

Pfister Selia 49-SL Manuel utilisateur

Fortis

Fortis VITRINA 6068700 Manuel utilisateur

Fortis

Fortis MILANO 78211JS Manuel utilisateur

Kohler

Kohler K-12183 Instructions de montage

Maxxus

Maxxus MX-M206-01 Manuel utilisateur

Moen

Moen 5922 Series Manuel utilisateur

Viega

Viega Prevista Pure 8512 Manuel utilisateur

Kohler

Kohler Centerset K-15240 Instructions de montage

Viega

Viega Prevista Dry 8522.33 Manuel utilisateur

Sanela

Sanela Lema SLP 59RB Manuel utilisateur

Elkay

Elkay EDF15AC Manuel d'installation

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Manuel

baliv

baliv WT-140 Manuel utilisateur