Parking Stand Replacement Instructions
©2004 Segway LLC Page 2 of 4 18250-00001ab
> Removing the Tire/Wheel Assembly
Step 1 Make sure the Parking Stand (i Series only) is
retracted. Position the Segway HT Wheels on a
non-slip surface. Brace the Wheel to be removed
so it will not rotate when you loosen the Wheel
Nut. You may find it easier to place the Handlebar
on the ground.
Step 2 Loosen the Wheel Nut with a 16 mm deep socket
by turning the wrench counterclockwise. (This may
require considerable force.) You may need to
strike the end of the wrench with a rubber mallet.
You can increase your leverage by extending the
length of the wrench handle.
Note: Your torque wrench may be designed only
for tightening. Check the manufacturer’s
specifications.
Step 3 Tip the Segway HT onto its side with the Wheel you
are removing facing up. Rest the other Wheel on a
flat, clean, smooth surface (the p Series Wheel is
dome-shaped, and is more vulnerable to scratches
and rocking unless adequately supported and
protected).
Step 4 Remove the Wheel Nut.
Step 5 Strike the outside edge of the Tire (not the Wheel!)
with a rubber mallet to unseat the Wheel Hub
Taper. (This may require multiple attempts as the
Wheel Hub Taper is seated tightly into the Gearbox
Taper.)
Step 6 Lift off the Tire/Wheel Assembly.
> Removing the Fender
Step 1 Remove the six Fender fasteners using a T-20 six-
lobed bit (Torx T-20) (T-15 Six Lobe bit if your
Segway HT was purchased prior to March 2003).
The plastic Fender is flexible. Twist the bottom
right edge of the fender and flex it away from the
Gearbox.
Step 2 Disengage the mat loop from the Fender.
Step 3 Remove the Fender.
> Removing the Parking Stand
Step 1 Remove the two 4 mm Hex Drive Parking Stand
fasteners using the “L” shaped Hex Wrench
included with your Segway HT.
