SEFA ®France
Page N° 7
2. INSTALLATION
USE BY QUALIFIED STAFF ONLY
Do not manipulate the machine by the plates!
Unpack the machine from its box.
Place it on a stable table manipulating it by its frame.
After having properly positioned the equipment on its working place:
• Electrically plug the press in (220 Volt + Neutral + Earth / 50 or 60 Hertz),
• Pneumatically connect the press (DN9 network pressure 8 bars).
3. DESCRIPTION OF THE RUNNING CYCLE
1. The operator will have to turn the main switch on so that the machine is powered up,
2. Press on the red switch On / Off and on the Réarmement button (order either way),
3. Set the temperature to 180° (or to define according to the type of transfer) See SETTING §1,
4. Set the application time to 15 seconds (or to define according to the type of transfer) See SETTING
§1,
5. Set the pressure to 6 bars (or to define according to the type of transfer),
6. Position the cap on the curve,
7. Press on the red button situated on the curve support to action the cap stretcher,
(if the cap is not properly positioned on its curve, press on the stretcher red button (see photo page 4) of the
opposite curve, without releasing, action the one which corresponds to the station used. The stretcher will release
the cap and the user will be able to replace it. Then, press on the red button of the station used to stretch the cap)
8. Adjust the transfer sheet,
9. On the « 1P / Manu / Auto » button, select the mode you wish,
10. At the end of pressing, the stretcher will automatically release the cap.
1 POSTE: this selection allows the user to only work on one curve:
An impulse on the foot pedal will make the heating plate swivel in order to press one curve. If on the
first impulse on the pedal, the heating plate swivel, but does not press, on the second impulse, the cycle will
start normally.
At the end of the timer count down, the plate will go back up and will clear automatically to position
itself above the opposite plate and will stay in position until the operator presses on the pedal to start a new
cycle. The plate will then come back pressing the used curve.
MANU: this selection will authorize the use of the pedal:
When the operator presses on the pedal, the heating plate will swivel to position itself above the
opposite curve. Arrived in position, it will go down automatically. At the end of the timer countdown, the plate
will go back up and will stay in position until the operator presses on the pedal to start a new cycle.
AUTO: this selection prohibits the use of the pedal but needs the programming of a time on
the timer situated to the right of the machine.
The operator will have to start the cycle pressing on the pedal; the heating plate will swivel to position itself
above the opposite curve. Arrived in position, it will go down automatically. At the end of the timer count down,
the plate will go back up and will stay in position until the rotation time selected on the timer has run out.
This time is the difference between the time of unloading / loading of an item on a curve and the
pressing time. As soon as this time has run out, the plate rotation will happen automatically.
THE PRESSING TIME CAN BE INTERRUPTED AT ANY TIME USING THE PEDAL
THE PLATE WILL THEN CLEAR THE PRESSING STATION AUTOMATICALLY
