BT1 User Manual V1.0
Sebury Technology Co.,Ltd http://www.sebury.com.cn
Page 7
2. If the door was opened by force, or open the door after 120 seconds when normal unlock. The
outer connecting alarm and built-in buzzer will alarm simultaneously. swipe the valid card or input
correct user PIN Code #, wait for more than 1 minutes will release alarm.
3.9 Setting the security mode
7, 0# Default value, set to normal mode.
7, 1# Set to lock mode. When the invalid card, user password or administrator password is
continuously tried 10 times, the keypad will be automatically locked for 10 minutes.
7, 2#
Alarm mode. If there are continuously 10 invalid cards, 10 incorrect PIN number or administrator code
within 10 minutes, both the buzzer and alarm output will be operated. Swiping valid card, or input valid
PIN number, or wait for 1 minute will release the alarm output.
For example, set to lock mode:
71#
3.10 Exit from the administrator mode
In the administrator mode of operation, press the * key many times until the indicator light is always red,
that is, to exit the administrator mode of operation.
3.11 Change user’s password
3.11.1 Change password by card
*, Read user card, Old user password #, New password #, New password #
For example, Change user password by card:
* Read user card 1234#123456#123456#
Note: A initial password 1234 will be generated when adding a new card user. The initial password can’t
open the door, Just can be used to change the card user’s password. The new password should be in 6
digits.
3.11.2 Change password by ID number
*, ID number #, old password #, new password #, new password #
For example, Change user’s password by ID:
*1#123456#111111#111111#
Note: when changing password by ID number, the old user password can not be initial password 1234.
3.12 Users open the door
Read the card, or enter 6 digits user’s passwords, or press the Exit button
Note: No pressing # key after entering the password reduces frequency of using # key and greatly
improves the service life of # key. When opening the door, there will be a long sound of "beep" and the
indicator light will turn green during unlock. when the opening mode is card and password, the interval
between reading card and enter the password cannot exceed more than 5 seconds.
3.13 Resetting To Factory Default Setting
When administrator password is out of mind, or after user randomly adjust various parameters, you can
return to the normal situation by resetting to factory default setting. As following:
power off, press *and hold it, then power on, release it until hear two beeps, and master password
will revert to 888888,And the keypad parameters are reset to factory default setting, detail is in the
“administrator mode operation summary table”, the user’s card and password won’t be deleted.
