SCIFIT DC4000 Manuel utilisateur
1
DC4000 Hand Rail Installation
1. Slide the hand rail coupler halfway onto the upright handlebar with the
coupler pinch bolt heads facing out. The upright handlebar should stop
between the middle two (2) coupler pinch bolts.
2. Insert the top end of the hand rail into the hand rail coupler.
3. Line up the two (2) holes in the hand rail mounting base with the two (2)
unused holes on the underside of the extrusion. The holes on the
underside of the extrusion are located at 3” and 6” behind the front roller
cover.
2
4. Install each base mounting bolt up through the hand rail mounting base,
the extrusion, followed by a base lock washer, and then install base
mounting nut. Do not tighten.
5. Verify hand rail coupling is centered between the upright handle bar and
the handle bar and the tapered lip on the hand rail coupling is pointed
down. Tighten the coupler pinch bolts, using a ¼” Allen wrench.
6. Tighten the base mounting bolts and nuts, using a ½” wrench and socket.
7. Repeat procedure for the other side.
Table des matières
Autres manuels SCIFIT tapis roulant
SCIFIT
SCIFIT AC5000 series Manuel utilisateur
SCIFIT
SCIFIT AC5000 series Manuel utilisateur
SCIFIT
SCIFIT DC1000 Intelli-Fit Mode d’emploi
SCIFIT
SCIFIT DC1000 Intelli-Fit Manuel utilisateur
SCIFIT
SCIFIT AC5000 series Mode d’emploi
SCIFIT
SCIFIT AC5000 series Manuel utilisateur
SCIFIT
SCIFIT AC7000M Manuel utilisateur
SCIFIT
SCIFIT Fit-Key AC7000 Manuel utilisateur
Manuels tapis roulant populaires d'autres marques
Smooth Fitness
Smooth Fitness EVO 3i Manuel utilisateur
NordicTrack
NordicTrack NETL81810.0 Manuel utilisateur
Schwinn
Schwinn 830/Journey 8.0 Manuel utilisateur
Keys Fitness
Keys Fitness HealthTrainer HT-740T Manuel utilisateur
Spirit
Spirit XT8 Manuel utilisateur
NordicTrack
NordicTrack T 14.0 Treadmill Manuel utilisateur