Satel AQUA Series Manuel utilisateur

DIGITAL PASSIVE INFRARED DETECTOR

AQUA RING

CEILING MOUNT

aquaring_e 06/04

The microprocessor-based, fully

digital AQUA series detectors

feature high sensitivity and

interference resistance. A dual pyro

electric element is used in the AQUA

RING detector.

TERMINALS:

NC - alarm relay (NC)

TMP - tamper contact (NC)

COM - ground (0V)

12V - supply input (9-16V DC)

Three pairs of pins are used to set the detector working parameters (see Table)

JP1 JP2 JP3

Low sensitivity

Medium sensitivity

High sensitivity

LED indicator ON

LED indicator OFF

- pins open - pins shorted

The LED lights red when the detector is actuated, which enables the installer to

check the detector for correct functioning and to approximately determine the

protected area.

For 30 seconds after the power is turned on, the detector remains in a starting

state, which is signalized by rapid LED blinking. Only then the detector enters its

operational readiness state.

The detector monitors the supply voltage. If the voltage drops below 9V (±5%) for

more than 2 seconds, the detector will signalize a violation state until a voltage of

minimum 9V (±5%) is restored.

INSTALLATION

The detector is designed for ceiling mount. Prior to installation, remove the

electronics board and make adequate openings for screws and cable in the

housing.

Be careful so as not to soil or damage the pyro element in the process of

installation.

LED

NC NC TMP TMP COM 12V

PIR SENS.

LED ON/OFF

JP1

JP2

JP3

pyro element

tamper contact

relay

positioning scale operating parameter

setting pins

Figure 1. View of detector electronics board

Figure 3 shows typical examples of connecting the detectors in EOL (parameter)

configuration and 2EOL (two-parameter) configuration. Resistors should be

mounted inside the detector housing.

NC NC TMP TMP COM 12V

AQUA RING detector

Z2 - programmed as „24h TAMPER” – NC type

+12V COM Z1 Z2 COM Z3 Z4 COM Z5 Z6 COM Z7 Z8 COM

R R

NC NC TMP TMP COM 12V

AQUA RING detector

Figure 3. Examples of detector connection

open

Figure 2. Detector view

TECHNICAL DATA

Nominal supply voltage ...............................................................................12V DC

Mean power consumption (±10%)..................................................................9.5mA

Violation signaling time........................................................................................ 2s

Protected area: when mounted at a height of 2.4m........................................36m2

when mounted at a height of 3.7m........................................80m2

Operating temperature range ................................................................-10...+50°C

Detectable motion speed....................................................................... up to 3 m/s

Dimensions ........................................................................................... ø97x29mm

Recommended installation height............................................... from 2.2m to 4.5m

Latest EC declaration of conformity and product approval certificates can

be downloaded from our Web site www.satel.pl

SATEL sp. z o.o.

ul. Schuberta 79

80-172 Gdańsk

POLAND

tel. + 48 58 320 94 00

info@satel.pl

www.satel.pl

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Satel Capteur de sécurité

Satel

Satel AQUA PET Manuel utilisateur

Satel

Satel IVORY Manuel utilisateur

Satel

Satel INDIGO TESTER Manuel utilisateur

Satel

Satel AMD-103 Manuel utilisateur

Satel

Satel APD-100 Manuel utilisateur

Satel

Satel AMD-101 Manuel utilisateur

Satel

Satel AVD-100 Manuel utilisateur

Satel

Satel micra MXD-300 Manuel utilisateur

Satel

Satel AQUA LUNA Manuel utilisateur

Satel

Satel VD-1 Manuel utilisateur

Satel

Satel APD-100 Manuel utilisateur

Satel

Satel APMD-150 Manuel utilisateur

Satel

Satel FD-1 Manuel utilisateur

Satel

Satel SILVER Manuel utilisateur

Satel

Satel GRAPHITE Manuel utilisateur

Satel

Satel COBALT Manuel utilisateur

Satel

Satel OPAL Manuel utilisateur

Satel

Satel SLIM-DUAL-PRO Manuel utilisateur

Satel

Satel abax 2 ACD-220 Manuel utilisateur

Satel

Satel SLIM-DUAL-PRO Manuel utilisateur

Satel

Satel FD-1 Manuel utilisateur

Satel

Satel AQUA PRO Manuel utilisateur

Satel

Satel AOD-200 Manuel utilisateur

Satel

Satel VD-1 Manuel utilisateur

Manuels Capteur de sécurité populaires d'autres marques

THORLABS

THORLABS PDA10JT Manuel utilisateur

Waeco

Waeco UV-DETECT Manuel utilisateur

Intermatic

Intermatic IOS-DSIMF Manuel utilisateur

urmet domus

urmet domus 1083 Manuel utilisateur

Siemens

Siemens AZL66 Series Manuel utilisateur

BTI

BTI Profiline Multi Finder Manuel utilisateur

Challenger

Challenger SL01 Manuel utilisateur

DMP Electronics

DMP Electronics 1122INT Manuel utilisateur

Rielta

Rielta Ladoga MK-RK Manuel utilisateur

Mirion Technologies

Mirion Technologies ACCURAD PRD Manuel utilisateur

Bosch

Bosch DS835 Manuel utilisateur

DBI SALA

DBI SALA EZ Stop Manuel de l'opérateur

Lamptime

Lamptime ST05C Manuel utilisateur

Ubiquiti

Ubiquiti MFI-MSC Manuel utilisateur

Subsite

Subsite 910R Instructions d'installation

Aleph

Aleph XC-1XTEU Manuel utilisateur

Pima

Pima LARIS QUAD Manuel utilisateur

Solinst

Solinst 301 Manuel utilisateur