Operating Instructions Wine Cooler Model WKS 390
2. Transport, installation and safety instructions
1. Please be careful during the transportation or moving of the wine cooler.
2. To prevent possible compressor damage, transport the appliance in upright position. If
the wine cooler were not upright transported, you have to wait 3 hours, before you
connect it to electricity mains.
3. There is a wooden pallet under cooler to transport safely. Remove this pallet and place
the cabinet in upright position (in a level position) by means of the adjustable screws at
the base. To unscrew the wooden pallet, tilt the cabinet approximately 45° with the
horizontal and unscrew with a suitable screw driver.
4. Remove the wrapping material and draw off slowly the plastic protection film.
5. Clean the outside of the wine cooler with a damp cloth and the grids with a soft, damp,
warm cloth and a commercial cleaning detergent. Wipe off and dry everything carefully.
Do not use aggressive detergents, steel wool or abrasive sponges. The wine cooler may
not be hosed down with water.
6. Place the wine cooler on a stable, dry and level surface. You can do this by using
adjustable feet at the bottom and by a water level gauge.
7. Keep the wine cooler out of direct sun or heat sources to ensure correct temperatures
can be achieved. Please note that optimal appliance performance is obtained at an
ambient temperature between +16°C and + 35°C.
8. The installation site should be dry and temperature-controlled and allow unhindered
exchange of air. Always leave 15 cm space on all sides of the wine cooler. Also make
sure, that there is enough space for a proper use of the cooler.·
9. Before connecting the appliance, make sure that the tension indicated on the
indentification plate agrees with the tension of your electricty mains. A safe function is
only possible if the appliance is grounded according to the valid safety regulations and
standards.
10. Do not use „double adapters“ or similar devices which allow numbers of electrical
appliances to be operated together from electrical outlet.
11. The cable must not come into contact with water.
12. Regularly check the cable. If it is damaged, it must exchanged by a qualified specialist.
13. Do not touch the plug with wet hands.
14. Plug the power plug into the suitable outlet.
15. Do not cover ventilation holes which are on the top of the cooler.
16. Never put anything on the cooler.
17. Never put explosive and flammable things inside the cooler.
3. Operating
• After cleaning the wine cooler, insert the plug into the socket and make sure that the plug
is accessible and can be disconnected from the power supply in an emergency. Before
cleaning / repair the plug has to be pulled out.
• At the top of the front panel is the control panel. In the center of it there is the analog
temperature indicator and on the left is the switch of the indicator light and on the right
the control light.
• In the interior of the bottle cooler you find above a thermostat with a level specified from 0
to 7. If you turn the control knob to 0 the cooler is off, but remains working.
• From level 1 to 7 you can set the desired temperature. The level 7 is the lowest
temperature.
Page 2
