Sargent Assa Abloy 9900 Manuel utilisateur

1-800-727-5477 • www.sargentlock.com

A5572F 4/21

Copyright © 2018, 2021 SARGENT Manufacturing Company. All rights reserved. Reproduction in

whole or in part without the express written permission ofSARGENT Manufacturing Company is

prohibited.

Installation Instructions

9900 & 12-9900

Mortise Lock Exit Device

See Figure 1 for identification of parts.

Review the dimensions on the template to obtain the correct

height from finished floor.

1. Locate and place template as follows:

a. Stick center case and lock front template on door as

illustrated in Figure 2.

b. Using the cross bar hole centers for measuring, locate

the vertical center line of bracket.

2. Drill holes and mortise for lock as directed by the templates. See Figure 3.

3. If screwless rose outside trim is used, see separate instruction sheet and install rose at this time.

See Figure 4.

Figure3

4. Fasten mortise lock in place. See Figure 5.

Figure4

Figure1

Figure5

Figure2

1-800-727-5477 • www.sargentlock.com

A5572F 4/21

Copyright © 2018, 2021 SARGENT Manufacturing Company. All rights reserved. Reproduction in

whole or in part without the express written permission ofSARGENT Manufacturing Company is

prohibited.

WARNING

This product can expose you to lead

which is known to the state of California

to cause cancer and birth defects or other

reproductive harm. For more information go

to www.P65warnings.ca.gov.

Figure7

6. Attach outside trim when used.

a. Install cylinder and tighten cylinder set screw in lock front.

b. Attach center case cover to chassis.

7. Mount bracket chassis on door and attach bracket cover to

chassis.

8. Assemble and secure cross bar to arms.

9. Mortise strike in position.

A5572F 4/21

NOTE: If thru bolted trim is used, drill four 7/32” diameter holes through the

door and counterbore outside of the door for lugs.

5. IMPORTANT: Mount the center case chassis as follows:

a. Remove cover from center case chassis. Lock down arm. (For exit devices

less the cross bar lock down feature, hold arm in depressed position.)

See Figure 6.

b. Position center case chassis against the door so that the center case lever

is under the rear lever of themortise lock.

c. Lift center case chassis upward until the latch bolt is completely retracted.

d. With chassis in this position, mark location of the screw holes.

e. Drill holes for screws and mount center case chassis to the door.

Figure6

Figure 7

Ce manuel convient aux modèles suivants

1

Table des matières

Autres manuels Sargent Verrouillage

Sargent

Sargent Degree DG-2 Manuel utilisateur

Sargent

Sargent H1 Manuel utilisateur

Sargent

Sargent SE LP10 7000 Series Manuel utilisateur

Sargent

Sargent IN220 Manuel utilisateur

Sargent

Sargent ASSA ABLOY Simpli R8200 Series Manuel utilisateur

Sargent

Sargent ASSA ABLOY IDP-H1 Manuel utilisateur

Sargent

Sargent Assa Abloy IN120 Manuel utilisateur

Sargent

Sargent ASSA ABLOY PR100 Manuel utilisateur

Sargent

Sargent IN100 Manuel utilisateur

Sargent

Sargent GX Series Manuel utilisateur

Sargent

Sargent ASSA ABLOY 10 Series Manuel utilisateur

Sargent

Sargent ASSA ABLOY Profile Series Manuel utilisateur

Sargent

Sargent PASSPORT 1000 Exit Device Manuel utilisateur

Sargent

Sargent Profile Series v.S2 Manuel utilisateur

Sargent

Sargent ASSA ABLOY FM7100 Series Manuel utilisateur

Sargent

Sargent ASSA ABLOY IN Series Manuel utilisateur

Sargent

Sargent IN100 Manuel utilisateur

Sargent

Sargent ASSA ABLOY 8200 Manuel utilisateur

Sargent

Sargent EK Exit Device Retrofit Kit Manuel utilisateur

Sargent

Sargent ASSA ABLOY SE LP10 Manuel utilisateur

Sargent

Sargent 7800 Manuel utilisateur

Sargent

Sargent ASSA ABLOY Harmony Series Manuel utilisateur

Sargent

Sargent Profile Series Manuel utilisateur

Sargent

Sargent ASSA ABLOY SN Series Manuel utilisateur

Manuels Verrouillage populaires d'autres marques

Magic

Magic 105 Manuel utilisateur

Gantner

Gantner GAT NET.Lock 7020 System Guide rapide

Wittkopp

Wittkopp Insys 7202 Manuel utilisateur

Dorma

Dorma Studio Classic Manuel utilisateur

Securam

Securam ECSL-601 Manuel utilisateur

Sudhaus

Sudhaus 3003 Manuel utilisateur

Safety 1st

Safety 1st 48517 Manuel utilisateur

Pado

Pado FDS-10 Manuel utilisateur

Esco

Esco systeQ Series Manuel utilisateur

COMPX

COMPX National D8951 Manuel utilisateur

secureo

secureo Key Box Manuel utilisateur

Stock Loks

Stock Loks C8713 Manuel utilisateur

COMPX

COMPX 1T-058 Manuel du propriétaire

Auslock

Auslock T11 Manuel utilisateur

ELCOM

ELCOM 7205 Manuel utilisateur

Stealth SAFES

Stealth SAFES ShadowVault Manuel utilisateur

Knox

Knox KeySecure 5 Manuel utilisateur

Kwikset

Kwikset 48334/01 Manuel utilisateur