Sanyo PLC-LNS08 Manuel utilisateur

PARTS LIST

Following parts are contained in the packing.

· LENS 1 piece

· LENS MOUNTING SCREWS 6 screws (2 for spare)

· DRIVER 1 piece

· LIGHT-BLOCK SHEET 1 sheet

· LENS COVER 1 set

NOTES ON LENS REPLACEMENT

LENS REPLACEMENT PROCEDURE

LCD PROJECTOR LENS

MODEL NO. PLC-LNS07

PLC-LNS08

Lens replacement should be performed by the qualified service personnel.

It should be followed by this procedure precisely.

Before attempt to replace the lens, confirm the model number (both the LCD

projector and the lens) and use the proper lens.

If you have any questions, contact to the dealers.

Following checks and confirmations should be taken for safety.

Check the following things by the time of the cabinet cover installation after

the lens replacement.

1. Confirm the proper wiring and the wires are fixed properly.

2. Confirm the each connector is connected properly.

3.Wiring must not be tangled in the gear of the lens motor or the other

mechanical part.

4.There is no missing part, or no loosing mounting part.

1AA6P1P1732-- (ICKV)

● The focus and zoom of this lens can’t be adjusted by controls on main cabinet or the remote control unit.

LENS REPLACEMENT PROCEDURE

REMOVE THE LENS COVER. (See figure-1.)

1. Turn on the LCD projector.

2. Adjust the lens shift, so that lens is set in

the center.

3. Turn off the LCD projector and disconnect

the power cord from the AC outlet.

4. Remove 4 screws of the lens cover and

remove the lens cover.

REMOVE THE LENS. (See figure-2.)

1. Remove the connector

“K16B” of the circuit board.

2. Loosen the A, B wire bands,

wire holder and remove the

lens motor lead.

After removal of the lens

motor lead, fasten it by plac-

ing it back into position.

3. Remove screws D(4 screws)

which fastens the lens and

remove the lens.

LENS

MOTOR LEAD

CONNECTOR “ K16B “

(D)

LENS MOTOR

Fig-2

This part wiring should

not be tightened.

❋Figure shown inside of the cabinet.

Fig-1

LENS COVER

1 5

Perform the steps to for lens replacement.

WIRE HOLDER

MOUNT THE LENS COVER. (See figure-5)

INSTALL THE LENS. (See figure-3)

Remove protective caps(front and

back) on the lens.

Mount the lens on mounting bracket of

the main cabinet with 4 screws.

Use the screws included with the lens.

Use the driver included with the lens

to fasten the screws.

INSTALL THE LIGHT-BLOCK SHEET. (See figure-4)

When this projector permanently install in the

structure, slide the picture, obtain correct

focus, then lock the lens by Focus Lens Lock

screw at this step.

In case unfixing the focus lens, remove the

screw.

Install the light-block sheet around the lens as shown in Figure.

Insert the upper part lens cover and

fix them with screws A (4 screws).

Insert the lower part lens cover and

fix them with screws B. (2 screws).

LENS MOUNTING BRACKET

ATTACHED DRIVER

FOCUS LENS LOCK SCREW

UPPER LENS COVER

LOWER LENS COVER

Fig-3

Fig-4

Fig-5

(After using, save it for latter use.)

When in install the both upper and lower lens

covers, install the light-block sheet so that it

should be placed in the guide slot of the lens

cover. If the installation of the light-block

sheet is incorrect, there will be the space

between lens and the lens cover, so that it will

be the cause of leakage of light or the dust

entering at the main cabinet.

LIGHT-BLOCK SHEET

Set the light-block sheet, so

thatthelargeroundersideis

set over the lens.

This file has been downloaded from:

www.UsersManualGuide.com

User Manual and User Guide for many equipments like mobile phones, photo cameras, monther board, monitors, software, tv, dvd, and othes..

Manual users, user manuals, user guide manual, owners manual, instruction manual, manual owner, manual owner's, manual guide,

manual operation, operating manual, user's manual, operating instructions, manual operators, manual operator, manual product,

documentation manual, user maintenance, brochure, user reference, pdf manual

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Sanyo Projecteur

Sanyo

Sanyo PLC-XW300 Manuel utilisateur

Sanyo

Sanyo PLC-XF60 Manuel utilisateur

Sanyo

Sanyo PLC-XU106 - 4500 lm Manuel utilisateur

Sanyo

Sanyo WF10 - PLV WXGA LCD Projector Manuel utilisateur

Sanyo

Sanyo PLC-9000NA Manuel utilisateur

Sanyo

Sanyo PLC-XU48 Manuel utilisateur

Sanyo

Sanyo PLC-WU3800 Manuel utilisateur

Sanyo

Sanyo PLV-Z2000 Manuel utilisateur

Sanyo

Sanyo PLC-XU4000 Manuel utilisateur

Sanyo

Sanyo SU30 - PLC SVGA LCD Projector Manuel utilisateur

Sanyo

Sanyo PLC-HF15000L - 15000 Lumens Manuel utilisateur

Sanyo

Sanyo LC-XBL20 Manuel utilisateur

Sanyo

Sanyo PLC-XW250 Manuel utilisateur

Sanyo

Sanyo PLC-8810N Manuel utilisateur

Sanyo

Sanyo PLC-WM5500/L Mode d’emploi

Sanyo

Sanyo PLC-XC56 - 3100 Manuel utilisateur

Sanyo

Sanyo PLC-XP40 Manuel utilisateur

Sanyo

Sanyo PLV-Z2 Manuel utilisateur

Sanyo

Sanyo PLC-XW55A Manuel utilisateur

Sanyo

Sanyo PLC-XU32 Manuel utilisateur

Sanyo

Sanyo PLC-XL51 - 2700 Lumens Manuel utilisateur

Sanyo

Sanyo PLC-WXL46 Guide de configuration

Sanyo

Sanyo PLV-Z3000 Manuel utilisateur

Sanyo

Sanyo PLC-XW20 Manuel utilisateur

Manuels Projecteur populaires d'autres marques

iEmmet

iEmmet MP-312 Manuel utilisateur

Epson

Epson VS400 Manuel utilisateur

Sony

Sony VPL-HS10 Marketing Specifications & Features Manuel utilisateur

Sony

Sony VPL-HW65ES Manuel de service

Toshiba

Toshiba TLP-791U Manuel utilisateur

Philips

Philips LC1341 Guide de référence

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Manuel utilisateur

NEC

NEC NP600S EDU Manuel utilisateur

BenQ

BenQ SH753P Manuel utilisateur

Eiki

Eiki EK-623U series Manuel utilisateur

Epson

Epson PowerLite Pro Cinema 6020UB Manuel utilisateur

Epson

Epson PowerLite Home Cinema 705HD Manuel utilisateur

Christie

Christie LHD700 Manuel utilisateur

Navitar

Navitar FX Manuel utilisateur

InFocus

InFocus LitePro 560 Manuel utilisateur

Sony

Sony SRX-R815P Manuel utilisateur

Vivitar

Vivitar DP1500 X Manuel utilisateur

Acer

Acer C20 Series Manuel utilisateur