Sangean DPR-16 Manuel utilisateur

DPR-16

3A81XF1000000

Operating instruction

Mode d’emploi

Instruccions de manejo

Gebruiksaanwijzing

Bedienungsanleitung

DAB+ / FM-RDS / Digital Receiver

DAB+ / FM-RDS / Récepteur numérique

DAB+ / FM-RDS / Receptor digital

DAB+ / FM-RDS / Digitale ontvanger

DAB+ / UKW-RDS / Digitalempfänger

Important safety instructions

Read these instructions.

Keep these instructions.

Heed all warnings.

Follow all instructions.

Do not use this apparatus near water.

Clean only with dry cloth.

Do not block any ventilation openings. Install in accordance

with the manufacturer’s instructions.

Do not install near any heat sources such as radiators, heat

registers, stoves, or other apparatus (including ampliers) that

produce heat.

Do not defeat the safety purpose of the polarized or grounding-

type plug. A polarized plug has two blades with one wider

than the other. A grounding type plug has two blades and

a third grounding prong. The wide blade or the third prong

are provided for your safety. If the provided plug does not fit

into your outlet. Consult an electrician for replacement of the

obsolete outlet.

Protect the power cord from being walked on or pinched

particularly at plugs, convenience receptacles, and the point

where they exit from the apparatus.

10.

Only use attachments/accessories specied by the manufacturer.

Use only with the cart, stand, tripod, bracket, or table specied

by the manufacturer, or sold with the apparatus. When a cart is

used, use caution when moving the cart/apparatus combination

to avoid injury from tip-over.

Unplug this apparatus during lightning storms or when unused

for long periods of time.

Refer all servicing to qualified service personnel. Servicing is

required when the apparatus has been damaged in any way,

such as power-supply cord or plug is damaged. liquid has been

spilled or objects have fallen into the apparatus, the apparatus

has been exposed to rain or moisture, does not operate

normally, or has been dropped.

To Reduce the Risk of Fire or Electric Shock, Do not Expose

This Appliance To Rain or Moisture.

The Shock Hazard Marking and Associated Graphical Symbol

is provided on the rear of unit.

Apparatus shall not be exposed to dripping or splashing and no

objects lled with liquids, shall be placed on the apparatus.

Excessive sound pressure on ear- and headphones could

impair the hearing ability. Higher setting that idle on the

equalizer leads to higher signal voltages on the output for ear

and headphones.

11.

12.

13.

14.

15.

16.

17.

18.

Controls

Speaker

Nap button

LCD display

Snooze button/Sleep timer button

Alarm button

Menu button/Info button

Band button

Standby button

Charge/Low battery indicator

Volume up/down

Tuning control rotary/Select/Auto tuning

Mute button

Preset button

DC IN socket

Headphone socket

USB socket for software update

Telescopic aerial

Battery compartment

Alkaline/NiMH/NiCad rechargeable battery switch

Display icon

Two line text display

Alarm 1 indicator

Snooze indicator

Sleep indicator

Volume indicator

AM/PM indicator

Nap timer indicator

Alarm 2 indicator

Clock digits

FM indicator

DAB indicator

Battery operation

Battery operation using alkaline batteries

1. Remove the battery cover on the rear of the unit by pressing the

catch.

Note:

Before you insert the batteries, if you use non-rechargeable

batteries, make sure the NiMH/Alkaline switch which located inside

the battery compartment is switched to Alkaline position. If you use

rechargeable batteries, make sure to switch NiMH/Alkaline switch

to NiMH position.

2. Insert four UM-1 (D size) batteries into the spaces in the compartment.

3. Take care to ensure all batteries are inserted with correct polarity

as shown on the rear cabinet. Replace the battery cover.

4. Reduced power, distortion and a “stuttering sound” are all signs

that the batteries need replacing.

5. If the radio is not to be used for any extended period of time, it is

recommended that the batteries are removed from the radio.

Battery operation using rechargeable batteries

1. Slide the battery switch to the NiHM position.

2. Insert 4 UM-1 batteries into spaces in the compartment. Make

sure all batteries are inserted with the correct polarity as shown

on the rear cabinet.

Note:

Do not use a mix of old and new rechargeable batteries.

Do not use a mix of full and empty rechargeable batteries.

Do not use batteries that have a different mAh capacity

Do not use damaged or leaking batteries

3. Make sure the radio is switched off and connected to the AC

adaptor. When the charge indicator flashes yellow indicating

batteries are charging. Batteries will be fully charged in around

10 hours. The battery shows steady yellow light when the battery

charging is complete.

Note:

Duration for charging your battery fully can be varied according to

the mAh capacity of a battery. Higher mAh batteries required longer

charging time.

Using the AC power adaptor

The AC power adaptor required for this unit should be 7.5 volts DC

at 0.8A center pin positive.

Insert the adaptor plug into the DC socket on the left side of the

radio.

Plug the adaptor into a standard mains socket outlet.

Whenever the adaptor is used, the batteries are automatically

disconnected. The AC adaptor should be disconnected from the

main supply when not in use

Setting the clock

Automatically updating the clock

Your radio can set its clock from DAB or FM radio broadcasts. After

a power failure the radio will then set its clock the next time you

turn on the radio in DAB or FM mode. Alternatively you may specify

that the time is not automatically updated. In this case, the clock

must always be set manually after a power interruption.

1. With you radio switched on, press and hold the Menu button to

access the menu for the current mode.

2. Rotate the Tuning Control Rotary until “System” is highlighted on

the display. Press the Tuning Control Rotary to enter the system

setting menu.

3. Rotate the Tuning Control Rotary until “Time” is highlighted on

the display. Press the Tuning Control Rotary to enter the time

setup.

4. Rotate the Tuning Control Rotary until “Auto update” is highlighted

on the display. Press the Tuning Control Rotary to enter the

auto-update menu.

5. Rotate the Tuning Control Rotary to choose an update option

from “Update from DAB”; “Update from FM”; ”Update from Any”

or “No update” as required. Press the Tuning Control Rotary to

conrm your choice. The radio will then exit to the previous menu

display.

Table des matières

Langues :

Autres manuels Sangean Récepteur

Sangean

Sangean ProTravel PT10 Manuel utilisateur

Sangean

Sangean DCR-89+ Manuel utilisateur

Sangean

Sangean U-1 Manuel utilisateur

Sangean

Sangean TRAVELLER 120 Manuel utilisateur

Sangean

Sangean PT-633 Manuel utilisateur

Sangean

Sangean HEDONIC 70 PR-D7 Manuel utilisateur

Sangean

Sangean PR-D4 Manuel utilisateur

Sangean

Sangean ProTravel PT-50 Manuel utilisateur

Sangean

Sangean DPR-25+ Manuel utilisateur

Sangean

Sangean PR-D15 Manuel utilisateur

Sangean

Sangean Sangean SR25V SR25V Manuel utilisateur

Sangean

Sangean TRAVELLER 760 DPR-76 Manuel utilisateur

Sangean

Sangean U-3 Manuel utilisateur

Sangean

Sangean ProTravel PT-80 Manuel utilisateur

Sangean

Sangean WR-1CL Manuel utilisateur

Sangean

Sangean DDR-36 Manuel utilisateur

Sangean

Sangean MMR-77 Manuel utilisateur

Sangean

Sangean ATS-818 Manuel utilisateur

Sangean

Sangean SR-25 Manuel utilisateur

Sangean

Sangean WR-11 Manuel utilisateur

Sangean

Sangean WFR-32 Manuel utilisateur

Sangean

Sangean ATS-405 Manuel utilisateur

Sangean

Sangean ATS-505 Manuel du propriétaire

Sangean

Sangean DT-110 Manuel utilisateur

Manuels Récepteur populaires d'autres marques

Garmin

Garmin GA 23 Manuel utilisateur

Aiphone

Aiphone PS-12F Manuel utilisateur

IMES

IMES TCS-01CA-PMI Manuel utilisateur

BWI Eagle

BWI Eagle AIR-EAGLE SR Manuel

AMIMON

AMIMON AMN12310 WHDI Manuel utilisateur

Dual

Dual DMCPA79BT Mode d'emploi

Sound Associates

Sound Associates SA652P Manuel utilisateur

Sherwood

Sherwood NewCastle R-772 Manuel utilisateur

Audio

Audio A10-RX Series Manuel utilisateur

AllSee

AllSee PushShare PSRV1.1 Manuel utilisateur

DEMAG

DEMAG DRC-DR D2 Manuel utilisateur

Teleco

Teleco TVRCL868A02 Manuel utilisateur

Bosch

Bosch RF3222E Manuel utilisateur

Kramer

Kramer 631R Manuel utilisateur

Xpress

Xpress xmc10 Manuel utilisateur

JVC

JVC KD-MR1BTS Manuel utilisateur

Omega Engineering

Omega Engineering UWTC-REC3 Manuel utilisateur

e-survey

e-survey E300 Pro Manuel utilisateur