Samsung SyncMaster 151D Manuel utilisateur
SyncMaster 151D
TFT-LCD Monitor
User's Manual
User’s Manual
Index
Main Page On-Screen Display
Safety Instructions Troubleshooting
Notational Check List
Power Q & A
Installation Self-Test Feature Check
Cleaning
Other
Introduction Specifications
Unpacking General Specifications
Front PowerSaver
Rear
Setup Information
Connecting Your Monitor Service
Installing the Monitor Driver Terms
— Windows XP Regulatory
— Other Operating System Natural Color
Installing VESA compliant
mounting For Better Display
Authority
User’s Manual
Safety Instructions
Failure to follow directions noted by this symbol could result in bodily harm or damage to equipment.
Notational
Warning/Caution
Notation Conventions
Prohibited Important to read and understand at all times
Do not disassemble Disconnect the plug from the outlet
Do not touch Grounding to prevent an electric shock
User’s Manual
Safety Instructions
When not used for extended periods of time, set your PC to DPMS. If using a screen saver,
set it to the active screen mode.
If the size of your monitor is small, or if the same image is present for long periods of time, you
may see afterimages due to damage to the flourescent substance on the inside of the
TFT-LCD.
•Do not use a damaged or loose plug.
•This may cause an electric shock or fire.
•Do not pull the plug out by the wire nor touch the plug
with wet hands.
•This may cause an electric shock or fire.
•Use only a properly grounded plug and recepticle.
•An improper ground may cause electric shock or equipment damage
•Do not excessively bend the plug and wire nor place
heavy objects upon them, which could cause damage.
•Failure to do so may cause an electric shock or fire.
Power
User’s Manual
Safety Instructions
•Disconnect the plug from the outlet during storms or
lightening or if it is not used for a long period of time.
•Failure to do so may cause an electric shock or fire.
•Do not connect too many extension cords or plugs to an
outlet.
•This may cause a fire.
Power
User’s Manual
Safety Instructions
•Do not cover the vents on the monitor cabinet.
•Bad ventilation may cause a breakdown or fire.
•Put your monitor in a location with low humidity and a
minimum of dust.
•An electric shock or fire could result inside the monitor.
•Do not drop the monitor when moving it.
•This may cause damage to the product or human body.
•Place the monitor on a flat and stable surface.
•The monitor can cause injury by falling.
•Set down the monitor carefully.
•It could be damaged or broken.
Installation
User’s Manual
Safety Instructions
•Do not place the monitor face down.
•The TFT-LCD surface may be damaged.
Installation
User’s Manual
Safety Instructions
•Do not spray detergent directly on the monitor.
•Use the recommended detergent with a smooth cloth.
•If the connector between the plug and the pin is dusty or
dirty, clean it properly with a dry cloth.
•A dirty connector can cause an electric shock or fire
•Do not set a glass of water, chemicals or any small metal
objects on the monitor.
•This may cause damage, electric shock or a fire.
•If a foreign substance gets into the monitor, disconnect the plug and
then contact a service center.
Clean
When cleaning the monitor case or the surface of the TFT-LCD, wipe with a slightly
moistened, soft fabric.
User’s Manual
Safety Instructions
•Do not remove cover(or back). No user serviceable parts
inside.
•This may cause an electric shock or a fire.
•Refer servicing to qualified service personnel.
•If your monitor does not operate normally - in particular,
if there are any unusual sounds or smells coming from
it - unplug it immediately and contact an authorized deal-
er or service.
•This may cause an electric shock or a fire.
•Do not place any heavy objects on the monitor.
•This may cause an electric shock or a fire.
•For each hour of looking at the monitor, you should let
your eyes rest for 5 minutes.
•This will reduce eye fatigue.
•Do not use or store inflammable substances near the
monitor.
•This may cause an explosion or fire.
Other
User’s Manual
Safety Instructions
•Do not try to move the monitor by pulling on the wire or
the signal cable.
•This may cause a breakdown, electric shock or a fire due to damage
to the cable.
•Do not move the monitor right or left by pulling only the
wire or the signal cable.
•This may cause a breakdown, electric shock or a fire due to damage
to the cable.
•Never insert anything metallic into the monitor openings.
•This may cause an electric shock, fire or injury.
•Keep the monitor away from any magnetic substances.
•This may cause discoloring or distortion of the image.
Other
Table des matières
Autres manuels Samsung Moniteur
Samsung
Samsung SyncMaster 650MP Manuel utilisateur
Samsung
Samsung 50 Series Manuel utilisateur
Samsung
Samsung MR-16SB2 Manuel utilisateur
Samsung
Samsung C27G5 T Series Manuel utilisateur
Samsung
Samsung SyncMaster 400TSn-2 Manuel utilisateur
Samsung
Samsung SyncMaster TA950 Manuel utilisateur
Samsung
Samsung HPP3761X/XAA Manuel utilisateur
Samsung
Samsung PM32F Manuel utilisateur
Samsung
Samsung HP-S4273 Manuel utilisateur
Samsung
Samsung CKF5607L Manuel utilisateur
Samsung
Samsung LLF19US Manuel utilisateur
Samsung
Samsung S27C650P Manuel utilisateur
Samsung
Samsung QB43R Manuel utilisateur
Samsung
Samsung ME95C Manuel utilisateur
Samsung
Samsung S24C650PLS Manuel utilisateur
Samsung
Samsung 940MW - SyncMaster - 19" LCD Monitor Manuel utilisateur
Samsung
Samsung SyncMaster 2033SN Manuel utilisateur
Samsung
Samsung S32A70 Series Manuel utilisateur
Samsung
Samsung SyncMaster 2243FW Manuel utilisateur
Samsung
Samsung SyncMaster FX2490HD Manuel utilisateur
