Sänger MyOS 2022 Manuel utilisateur
2
3
Table of Contents
8” Display____________________ pg. 3
Night Mode ______________pg. 4
Gauges Screen ____________pg. 4
Controls Screen _______________pg. 4
Ballast Screen ________________ pg. 5
Cruise Control ____________ pg. 5
User Presets _________________ pg. 6
Audio Screen _________________ pg. 7
Audio Adjustment __________ pg. 8
Bluetooth ________________ pg. 9
USB/AUX Input ___________ pg. 9
Sirius XM Radio ______________ pg. 10
Activation _______________pg. 11
Operation ________________pg. 11
Parental Control __________ pg. 12
Trouble Shooting __________ pg. 13
Settings__________________ pg. 14-16
12 Button Pad _______________ pg. 17
4
1- Cruise Control On/Off
2- Audio Menu
3- Gauge Menu
4- Controls Menu
5- Depth Screen
6- Presets Menu
7- Settings Menu
8- Engine Start/Stop
9- Preset Selection
10- Day/Night Mode
Night Mode
The NIGHT MODE button at the bottom right of
the display toggles the backlighting between the
DAYTIME and NIGHTTIME set points that can be
found in the SETTINGS MENU. NIGHT MODE not only
controls the brightness of the screens, but also the
lighting of the various buttons found on the DASH.
8” Display
1 2 3 4 5 6 7
8910
Gauges Screen
Touch the GAUGES button at the
top of the screen to view the current
data of your boat systems.
This page will show coolant
temperature, voltage, oil pressure,
engine hours, and engine RPMs.
To change the units between Imperial
and Metric, see the UNITS & DEPTH
menu in SETTINGS > CONFIGURATION
5
Controls Screen
1- All Off
2- Nav Lights
3- Anchor Lights
4- Blower
5- Floor Lights
6- Courtesy Lights
7- Cup Holder Lights
8- Seat Heater
9- Docking Light
10- Underwater Lights
11- Bilge
Touch ALL OFF to turn OFF any devices that are running on the CONTROLS page.
Ballast Screen
Navigate to the BALLAST page by
selecting the BALLAST button at the
top of the display
Use the on-screen controls to
adjust the ballast to the desired levels.
1
5
8
2
6
9
3 4
11
7
10
-To FILL the floor tanks the boat must be below 2 mph. When below 2 mph,
FILLING will be displayed. After its done the FILLING will change to FULL
-To DRAIN the floor tanks the boat must be above 10 mph. When the boat is above 10 mph
DRAINING will be displayed. After the tank has finished DRAINING, EMPTY will be displayed.
-If the tanks are not empty, you are not at the proper speeds, or are in the OFF position,
you will see HALF displayed.
6
Tabs Screen
Cruise Control
Toggle cruise ON/OFF by tapping the
CRUISE CONTROL icon in the top left of
the display. GREEN indicates that cruise
control is on.
Once Cruise Control is on, control the set
speed by pressing the PLUS and MINUS
icons. The set speed will be displayed in
GREEN above the speedometer.
Navigate to the Tabs page by selecting the
TABS button at the top of the display
Use the on-screen controls to
adjust the LEFT/RIGHT SURF TABS and
the CENTER TAB to the desired levels.
Tabs will retract when speeds go above `15
MPH or below 7 MPH.
NOTE:
the CENTER TAB can also be adjusted
with the swtich on the THROTTLE..
7
User Presets
Navigate to the USER PRESETS page
by selecting the PRESETS button at the
top of the display or by tapping the blue
preset icon beneath the Speedometer.
GO HOME MODE
Stows the surf tabs to allow the Captain to drive without creating a surf wave.
SURF RIGHT/LEFT
Adjusts the surf tabs to control which side of the boat the surf wave is on.
LOAD A PRESET
1. View the available PRESETS in the list box. The the UP and DOWN ARROWS to scroll through.
2. select the PRESET that is to be applied. It will be highlighted ORANGE.
3. Touch the LOAD button. The running preset will now be displayed under the speedometer.
4. The system will begin to take action to match the defined PRESET (BALLAST LEVELS and
CRUISE SPEED).
SAVE A PRESET
1. Create a desired ride setting on the BALLAST SCREEN and a desired CRUISE SPEED(optional).
2. Select PRESET 1, PRESET 2, or PRESET 3 from the list of presets. Choose the one that you
want to create/change to your new settings.
3. When the desired PRESET is selected, select SAVE.
4. A pop-up will appear asking if you want to “Save Over Selected Preset?” Select YES or NO
accordingly. If you selected yes, you may now load the PRESET with your personal settings.
On-Board Presets
Custom Presets
8
AM/FM/Weather
Audio Screen
Navigate to the AUIDIO page by selecting
the AUDIO button at the top of the display.
1- Equalizer
2- Volume DOWN/UP
3- Volume Mixer
4- Audio Power ON/OFF
5- Audio Source
32 4 5
1
When the user powers the audio on and taps SOURCE on the
right of the tachometer, it will bring up the SOURCE MENU.
Here is where the user can select which Audio Source they
want to listen to.
3
1
4
21- Frequency
2- Seek FWD/BACK
3- List Items
4- Scan FWD/BACK
The LIST ITEMS saves your favorite stations from AM, FM, or WEATHER. Up to 15 stations are able
to be saved. To save a station, select or tune to the stations channel, then PRESS AND HOLD on the
desired location in the list. This will copy and paste the currently active station. Storing it for later recall.
9
Sound Adjustment
Bluetooth
From the EQUALIZER page, the USER is able to adjust the TREBLE, MID, BASS and
BALANCE. It is recommended to leave the TREBLE and BASS centered at 0.
The MIX VOLUME page allows the DRIVER the ability to change the volume level for the
FRONT, REAR, SUB, and TOWER, or the USER can touch SYNC to bring all volume
sliders to the same level.The MAIN slider moves all volume levels together.
Touch BT AUDIO to play songs on your phone or favorite mobile device with Bluetooth technology.
The user is able to initiate the pairing process from the BT AUDIO page by selecting PAIR. A pop-up will
appear with the BLUETOOTH name for the vessel. Once a device is successfully PAIRED, this pop up will
disappear.
PLAY/PAUSE, SEEK FORWARD, and SEEK BACK allow the user to control the BLUETOOTH device.
10
USB Input
Auxiliary Input
1- Browse USB device files
2- Replay
3- Shuffle Playlist
Touch USB to access a device plugged into the DASH USB PORT. USB INPUT DEVICES with music
stored on them are able to be accessed from this screen.
If a USB INPUT DEVICE is plugged in that has music stored on it, the AUDIO SOURCE will automatically
switch to USB.
The System supports the following media formats for audio playback:
.ac3 (dolby digital) / .hdcd / .lpcm / .mpeg / .mpeg 2.5 /.pcm /.wmv
Touch AUX to access the AUXILIARY INPUT PORT that is located in the GLOVEBOX.
1 2 3
Table des matières
