Rosewill RC-100 Manuel utilisateur

USB 2.0 2-Port PCI Adapter RC100

User Manual

USB 2.0 2-Port PCI Adapter RC100

System Requirements

• Windows® 98SE, 2000, ME, XP(Pentium® or K6® - class processor -266 MHz or higher)

• Mac® OS 10.1 or Above

• 32MB of RAM

• Available PCI Slot

• CD-ROM Drive(for driver installation)

Speciﬁcations

• VIA VT6212L chipset

• USB 1.1 and 2.0 Compliant

• Up to 480 Mbps (Megabits-Per-Second) Data Transfer Rate

• 40 Times Faster Than The USB 1.1

• Hot Swappable Plug-n-Play

• 2 External Type A USB 2.0 Ports

• 2 Type A USB 2.0 Ports by connecting an optional 2-Port USB cable to connector USB3

Package Contents

• 1 x USB 2.0 PCI Card

• 1 x Driver CD

• 1 x User Manual

Hardware Installation

Be careful with polarity of the USB connector (USB3). Check the pin assignment while you connect the USB cable.

User Manual

USB 2.0 2-Port PCI Adapter RC100

Pin No. Deﬁnition

1 Power

2 Power

3 USB3 D-

4 USB4 D-

5 USB3 D+

6 USB4 D+

7 GND

8 GND

9 No Pin

10 NC

1. Remove your computer’s cover. (Note: If necessary, consult your computer’s manual for

help in removing the cover)

2. Locate an available PCI slot and, if necessary, remove the expansion slot bracket.

3. Insert the USB 2.0 Card gently but ﬁrmly until the card is fully seated.

4. Fasten card to the computer case using a screw.

5. Replace the computer cover.

Driver Installation

Windows®98SE Installation

Make sure your version of Windows® is 98 Second Edition by check the “Properties” of “My

Computer”.

1. Windows will detect new hardware and start the “VIA Tech 3038 PCI to USB Universal Host

User Manual

USB 2.0 2-Port PCI Adapter RC100

Controller” driver search program. Click “Next”.

2. Select “Search for the best driver for your device”. Click “Next”.

3. Don’t select any location and click “Next”.

4. Select “The updated driver (Recommended) VIA Tech 3038 PCI to USB Universal Host

Controller”. Click “Next”.

User Manual

USB 2.0 2-Port PCI Adapter RC100

5. Click “Next” again to conﬁrm the driver and begin installation. Please insert the disk labeled

“Windows 98 CD disk”.

6. After driver installation ﬁnished, click “Finish”.

7. Next, you will see Windows ﬁnd a “VIA Tech 3038 PCI to USB Universal Controller” device

again. Repeat the above process for the second “VIA Tech 3038 PCI to USB Universal

Controller”.

8. As “PCI Universal Serial Bus” driver search program shows up, as Figure 5. Click “Cancel” to

cancel the driver installation for this device. This driver will be installed from the included Driver

CD.

9. Insert the Driver CD into the CD-ROM drive of your computer. Browse to the VIA USB 2.0

Driver Folder “\PCI_IO\Viausb20” on the Driver CD, then double-click the installation ﬁle “Setup.

exe”. Follow the on-screen instructions, then reboot when prompted. This will automatically

install the driver for the “PCI Universal Serial Bus” device found in step 8.

User Manual

USB 2.0 2-Port PCI Adapter RC100

10. Once you have rebooted, your USB 2.0 Four Port PCI Card is ready to be used. If you open

the Device Manager, you will see the newly installed devices. To locate the Device Manager right

click “My Computer” and select “Properties”, then the “Device Manager” tab.

Windows® ME Installation

1. Windows will detect the USB 2.0 Four Port PCI Card and automatically install drivers for all

known USB devices. Follow the installation to restart the computer.

User Manual

USB 2.0 2-Port PCI Adapter RC100

2. After you have rebooted, Please insert the Driver CD into the CD-ROM drive of your computer.

Browse to the VIA USB 2.0 Driver Folder “\PCI_IO\Viausb20” on the Driver CD, then double-click

the installation ﬁle “Setup.exe”. Follow the on-screen instructions, then reboot when prompted.

This will automatically install the driver for the “PCI Universal Serial Bus” device found in step 1.

3. Once you have rebooted, your USB 2.0 Four Port PCI Card is ready for operation. Open Device

Manager, you will see the newly installed devices.

Windows® 2000 Installation

Windows® 2000 operating system natively supports this USB 2.0 Four PCI Card.

• No Drivers are necessary

However, please ensure you have the latest Service Pack installed.

• Windows® 2000 Service Pack 4 (or later)

User Manual

USB 2.0 2-Port PCI Adapter RC100

Windows® XP Installation

Windows® XP operating system natively supports this USB 2.0 Four Port PCI Card.

• No Drivers are necessary

However, please ensure you have the latest Service Pack installed.

• Windows® XP Service Pack 1 or later

When you start the PC, the drivers are installed automatically by the Hardware Wizard.

Thank you for purchasing Rosewill Product.

Please register your product at www.rosewill.com for complete warranty information and future

support for your product.

Table des matières

Autres manuels Rosewill Carte PCI

Rosewill

Rosewill RNX-N150PCe Manuel utilisateur

Rosewill

Rosewill RNWD?N9003PCE Manuel utilisateur

Rosewill

Rosewill RC-20003 Manuel utilisateur

Rosewill

Rosewill RNX-N150PCe Manuel utilisateur

Rosewill

Rosewill RC-305 Manuel utilisateur

Rosewill

Rosewill RC-300 Manuel utilisateur

Rosewill

Rosewill RC-NIC412 Manuel utilisateur

Rosewill

Rosewill RNX-N300X Manuel utilisateur

Rosewill

Rosewill RC-223 Manuel utilisateur

Rosewill

Rosewill RNX-G100 Manuel utilisateur

Rosewill

Rosewill RC-110 Manuel utilisateur

Rosewill

Rosewill RC-20002 Manuel utilisateur

Rosewill

Rosewill SATA 150 RAID 2 Port PCI Host RC201 Manuel utilisateur

Rosewill

Rosewill RC214 Manuel utilisateur

Rosewill

Rosewill RC500 Manuel utilisateur

Rosewill

Rosewill RC-303 Manuel utilisateur

Rosewill

Rosewill RC303 Manuel utilisateur

Rosewill

Rosewill RC-304 Manuel utilisateur

Rosewill

Rosewill RC503 Manuel utilisateur

Rosewill

Rosewill RC-305E Manuel utilisateur

Rosewill

Rosewill RNX-N300 Manuel utilisateur

Rosewill

Rosewill RNX-N250PC2 Manuel utilisateur

Rosewill

Rosewill RC-400 Manuel utilisateur

Rosewill

Rosewill RC302 Manuel utilisateur

Manuels Carte PCI populaires d'autres marques

ERMA

ERMA SSI 1417 Manuel utilisateur

SIIG

SIIG CyberSerial Dual PCI Instructions de montage

Moxa Technologies

Moxa Technologies CP-102E Manuel utilisateur

I-Bus

I-Bus IBC2602 Manuel utilisateur

Exsys

Exsys EX-60102 Manuel utilisateur

Chelsio Communications

Chelsio Communications T5 Series Manuel utilisateur

Conrad Electronic

Conrad Electronic 97 46 71 Manuel utilisateur

Micro Innovations

Micro Innovations USB650A Manuel utilisateur

KTI Networks

KTI Networks KF-310 Manuel utilisateur

Asus

Asus SpaceLink WL230 Manuel utilisateur

SIIG

SIIG SC2475 Manuel utilisateur

TRENDnet

TRENDnet TEW-703PI Manuel utilisateur

Belkin

Belkin F5D7000F Manuel utilisateur

Pericom

Pericom PI7C7100 Manuel utilisateur

ADLINK Technology

ADLINK Technology cPCI-3548 Manuel utilisateur

Digium

Digium TE200 Series Manuel utilisateur

Allo.com

Allo.com 2nd Gen E1/T1/J1 Manuel utilisateur

Western Digital

Western Digital FireWire PCI Adapter Manuel utilisateur