Roberts R9941 Manuel utilisateur
R9941
FM Stereo/MW
Personal Radio
ROBERTS
Operating Instructions
Contents
Contents .......................................................................................... 1
Controls ........................................................................................... 2
Battery ............................................................................................. 3
Aerials ............................................................................................. 5
Loudspeaker On/Off switch and earphones ................................... 5
Operating your radio - FM ............................................................... 7
Operating your radio - Medium wave ............................................. 9
Belt clip and neck strap ................................................................. 11
General ........................................................................................... 12
Specification ................................................................................... 13
Guarantee ...................................................................................... 14
1
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
Controls
2
1
3
6
4
5
7
8
1. Stereo/Mono/Speaker switch
2. Earphone socket
3. Volume control
4. Waveband switch
2
5. Tuning control
6. Tuning scale
7. On/Off/DBB switch
8. Battery compartment (on rear)
Battery
1. Open the battery cover located on the rear of the your radio by
sliding it in the direction shown by the arrow.
2. Insert one LR03 (AAA) size battery into the compartment. Ensure
that battery is inserted in accordance with the diagram shown on
the rear of your radio.
3. Close the battery cover
4. Reduced power, distortion and a ‘stuttering’ sound are all signs
that the batteries may need replacing.
5. If the radio is not to be used for any extended period of time it is
recommended that the battery is removed from the radio.
3
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri) 4
Aerials
The lead connecting earphones to your radio acts as an FM aerial
when plugged into the earphone socket. The lead should be extended
as much as possible to increase FM reception. There is a separate
directional aerial built into the radio for AM reception. To achieve the
best MW reception, it may be necessary to rotate the radio.
Loudspeaker On/Off switch & Earphones
Your radio may be operated using the built in loudspeaker or the
earphones supplied.
1. The built in loudspeaker may be switched on by sliding the Stereo/
Mono/Speaker switch to the ‘Speaker’ position.
2. When switched to FM and using the loudspeaker the enclosed pig
tail aerial should be inserted into the earphone jack.
3. To operate your radio via earphones, plug the earphones into the
earphone jack slide the Stereo/Mono/Speaker switch to the ‘Stereo’
position.
Note: Stereo is only available on FM and when using earphones.
5
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri) 6
Operating your radio FM
1. Switch on your radio by sliding the On/Off/DBB switch to the ‘On
‘position..
2. Slide the Waveband switch to the ‘FM’ position.
3. Adjust the Volume control until a sound is heard.
4. Rotate the Tuning control to select the desired station. On FM
the Tuning scale is marked in Megahertz (MHz).
5. For FM reception fully extend the Earphone lead and position for
best reception. When using the built in loudspeaker plug the Pig
tail aerial into the headphone socket as described on page 5.
6. If the station being received is weak some hiss may be audible, to
reduce the hiss slide the Stereo/Mono/Speaker switch to the ‘Mono
position’.
Note: FM stereo is only available when using earphone/headphones
7. To increase bass frequencies slide the On/Off/DBB switch to the
‘DBB’ position .
8. To switch off your radio slide the On/Off/DBB switch to the ‘Off’
position.
7
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri) 8
Operating your radio MW
1. Switch on your radio by sliding the On/Off/DBB switch to the ‘On
‘position..
2. Slide the Waveband switch to the ‘MW’ position.
3. Adjust the Volume control until a sound is heard.
4. Rotate the Tuning control to select the desired station. On FM
the Tuning scale is marked in Kilohertz (kHz).
5. For MW operation rotate your radio for best reception.
6. To increase bass frequencies slide the On/Off/DBB switch to the
‘DBB’ position .
7. To switch off your radio slide the On/Off/DBB switch to the ‘Off’
position.
9
Table des matières
Autres manuels Roberts Radio
Roberts
Roberts Blutube 50 Manuel utilisateur
Roberts
Roberts WM-202 Manuel utilisateur
Roberts
Roberts RD-6R Manuel utilisateur
Roberts
Roberts eco 4 Bt Manuel utilisateur
Roberts
Roberts RD-45 Manuel utilisateur
Roberts
Roberts Revival UNO Manuel utilisateur
Roberts
Roberts Duet 2 Manuel utilisateur
Roberts
Roberts CRD-39 Manuel utilisateur
Roberts
Roberts R9958 Manuel
Roberts
Roberts R701 Manuel utilisateur
Roberts
Roberts Classic FM RD-12CFM Manuel utilisateur
Roberts
Roberts Revival iStream2 Manuel utilisateur
Roberts
Roberts RD-18 Manuel utilisateur
Roberts
Roberts Stream 63I Manuel utilisateur
Roberts
Roberts R9940 Manuel utilisateur
Roberts
Roberts Sports 925 Manuel utilisateur
Roberts
Roberts Digital Radio with Dual Alarms CRD-29 Manuel utilisateur
Roberts
Roberts WM201 Manuel utilisateur
Roberts
Roberts Sovereign Manuel utilisateur
Roberts
Roberts Rambler Manuel utilisateur
