PLEASE READ BEFORE USE AND FILE FOR FUTURE USE
IMPORTANT NOTES
BEFORE USE
SPECIFICATION
ATTENTIONSET UP
Unpack the water distiller and check if all the components are present and undamaged. The box
should contain: Please note: The unit must be allowed to cool down below 60°C before starting another distilling
cycle. (This will prevent injuries from scalding water and prolong the life of the distiller)
• Keep the body of the unit dry-only ll with water using a jug (Please use the kettle to pick up
water instead of the machine body.)
• Please use the suitable electric outlet, and do not plug in with other electronics at the same
time in order to avoid overload.
• The unit will automatically turn off once the cycle is nished. You can remove the power cord
from the socket to stop mid—cycle.
• Leave the power cord unconnected when the unit is not in use.
• Do not immerse any part of the unit in water.
• Keep it away from children in order to avoid scalding injuries.
• Do not remove the top cover while the machine is running. It must be cooled down for at least
10 minutes after a distilling process is nished in case of scalding injuries.
• Do not use a wire brush to clean the stainless tank, it will damage the surface of the tank and
will clog the drain.
• Use unit in a dry, well ventilated area.
The distiller is now ready to create distilled water.
Note: The chamber cleaning powder should be purchased by customer. You can buy citric acid pow-
der that is food safety grade or white vinegar to clean the distiller.
1. Distiller
2. Water Bottle
3. Discharge Cap
4. Bottle Cap
Rating Voltage: 220 V
Rating frequency: 50 Hz or 60 Hz
Power: 750 W
1. Remove the storage bottle from the inside of
the water distiller.
2. Fill up the tank inside the distiller with
water to the highest of the water line and
be very careful not to overll the tank.
(Please note that hot water is not recommended
here because it may lead to malfunction of the
high temperature protective function.)
7. After the storage bottle is fully lled with
distilled water, the starting button is still on
power. For your own safety, please disconnect
the power wire of the top cover and main power
wire to prevent injuries from scalding water.
8. Do not use the rst bottle of the distilled
water. It will take one distilling cycle for the
unit to “self-clean”. Wipe out the tank and
rinse/discard the water in the storage bottle.
5. Connect the main power wire to the
machine’ s body and plug in the electric
outlet. The fan starts to run and the tank
begins to heat. To start another distilling
cycle, press the “Start/Reset“ Button.
6. Water will begin to drip into the storage
bottle after approximately 30 minutes. It
will take approximately 4 hours to distill
4 liters of water. The unit will automatically
shut down when the cycle has nished.
3. Place the top cover on the machine’ s body,
please make sure the silicone seal is placed
correctly around the entire rim. Check to make
sure the unit is on a stable surface.
Then connect the power cord from the top
cover into the machine’ s body.
4. Set up the storage bottle as shown.
5. Filter
6. Main Power Wire
7. Instruction Manual
8. Chamber Cleaning Powder
Volume: 4 l
Degree of evaporation: 1 l/hour
Over-temperature safe: cut off at 160°C
