The RG20 is designed for clean water suitable for irrigation. The machine is not designed for water
that includes large pieces of debris or foreign objects.
1) Push the machine to the desired location. Position the ma-
chine with the sprinkler cart facing the direction to be irrigated.
Insure that the machine is sitting level in order for the tube to
wrap properly. IMPORTANT: Reel type traveling sprinklers
should always be placed on level ground and always pull the
hose out straight away from the machine as shown in Step 5.
This will ensure that your machine will wrap correctly.
2) Attach garden hose to the inlet as shown to the left.
IMPORTANT: Always make sure hose is free of any debris
that may clog the inlet lter screen. Flush hose with water if
neccessary. Never move the machine with supply hose
connected.
3) Loosen turbine drive wing knob several turns so that the
drive assembly is free to slide as shown in yellow circle to the
left.
4) While holding the drive slide handle, slide the drive assem-
bly towards you as shown in the image at left and re-tighten the
drive wing knob so that it holds the entire drive assembly in the
“disengaged” position. With drive in this position, the drive teeth
are disengaged which allows the sprinkler cart and hose to be
pulled out.
Image at right shows the drive slide
handle in the “disengaged” position
for hose pull out.
Conditions For Machine Operation
Start-Up Procedure/Operation
