RedBack Lasers 2L360 Manuel utilisateur
CONTENTS
User Safety 2
Introduction and 2L360™ Accessories 3
2L360™Diagram 4
Operating Instructions 7
Batteries 7
Power 8
Manual Mode. 9
Pulse Mode 10
LLR705 Receiver (optional 2L360R only) 11
Mounting Options 12
Calibration Self Check & Technical Specications 13
Care & Maintenance, Trouble Shooting 15
Warranty 16
User Safety
• Laser output sign lies near the output aperture.
• Do not stare directly into laser beam.
• Do not disassemble the instrument or attempt to
perform any internal servicing. Repairs and service
should be performed only authorised service
centres of Redback Lasers.
• This instrument complies with the safety
Classication standards of laser radiation.
2
2L360R CAUTION: Class 3r laser <5mW at 635nm.
2L360G CAUTION: Class 3r laser <5mW at 522nm.
Do NOT stare into laser beam or aim at another
person.
Follow relevant Australian Standards
Copyright © CMI LasersTM RedBack lasersTM and Level1LasersTM . All rights reserved CMI Industries Pty Ltd 2016
No artwork or photographs produced by CMI Industries Pty Ltd may be used copied or reproduced without the written consent
from CMI Industries Pty Ltd
3
2L360TM INTRODUCTION
Congratulations on purchasing one of the RedBack 2L360™ Auto Levelling
2x 360 line laser models. These instructions cover both the 3L360R (red
beam) and 2L360G (green beam) models. Please note that some of the
features described in this manual may be specic to just one of these
models and will be indicated as so.
Both the 2L360R and 2L360G feature two full 360olines, one horizontal and
one vertical. The 2L360R has a red beam laser and the 2L360G has a high
visibility green beam laser.
The 2L360 models are ideal for all manner of internal t out and installation
application by providing a fast self levelling horizontal line around the whole
room as well as a vertical line again 360ocoverage for alignment. In addition
the 2L360R (red) model has pulse mode and so can be used outdoors with
an optional line receiver such as the LLR705 by RedBack.
The 2L360’s Comes with superior Li-ion rechargeable batteries and charger
as well as being able to operate with standard “AA” Alkaline batteries.
The 2L360’s feature manual mode for setting on a manual slant and comes
with an elevating magnetic base which can also be mounted on an optional
tripod such as the RedBack IET68.
2L360™ Kit Included Accessories
• a 2L360™ Laser Unit (either R or G)
• Protective Carry Case
• Rechargeable Li-ion Batteries
• Charger
• Std Battery Compartment
• Elevating Magnetic Base
• Laser Target (either Red or Green)
• Instruction Manual
www.redbacklasers.com.au
4
2L360TM DIAGRAMS
2L360R & 2L360GTM Laser Units
1
2
3
1. Laser Output Windows
2. Control Keypad
3. Pendulum Locking Knob
4. Battery Compartment
5. Tripod/Mounting Threads 5/8”, 1/4”
4
5
5
Keypad
www.redbacklasers.com.au
Power LED
Pulse Mode LED
2L360R (red beam)
Laser Line Function
Button
Pulse Mode &
Manual Mode
Function Button
Manual Mode LED
2L360G (green beam)
Power LED
Laser Line Function
Button
Manual Mode LED
Manual Mode
Function Button
6
2L260TM DIAGRAMS
Mounting Bracket
5/8” Thread
Magnetic
Mount
Tripod Mounts
5/8” Thread &
1/4” Thread
Lock for Elevating
Laser Level Platform
Locking Knob
3L360 to Bracket
7
www.redbacklasers.com.au
2L360TM OPERATING INSTRUCTIONS
Battery Instructions
To charge this battery pack simply insert the charger plug into the charging
socket on the Li-ion battery pack itself. The LED on the charger is illuminated
red during the charging process and will turn green once the battery is fully
charged.
When the power LED on the keypad ashes, the rechargeable battery pack
needs recharging or standard “AA” batteries need replacing. Note the
charger will only charge the supplied rechargeable battery pack.
Handy Hints
•
Prior to initial use, fully charge the rechargeable battery.
•
If when you insert a battery pack the laser does not power up try re-
loading the battery pack to make sure there is a good connection.
•
Remember the 2L360™ can operate using standard “AA” batteries
when rechargeable pack is out of charge or charging.
•
When laser is not going to be used for an extended period of time it is
best to remove both “AA” and Rechargeable pack if installed.
The 2L360’s have two battery options either 4 x standard “AA” size Alkaline
or the Li-ion rechargeable pack. For standard 4 x “AA” alkaline operation
simply insert “AA” batteries into standard battery holder in the direction
indicated and slide the holder into battery recess and close the battery
compartment cover.
To use the rechargeable
battery pack rst
remove standard pack
if inserted and place
into the same battery
recess in direction
indicated and close the
battery compartment
cover.
5/8” Thread
Tripod Mounts
5/8” Thread &
1/4” Thread
Locking Knob
3L360 to Bracket
8
Turning On the 2L360
To power up, simply unlock the pendulum by moving it to the “ON” position,
this will automatically self level the laser and power up the horizontal beam.
If when you unlock the pendulum all laser ash and a beeping sound is
emitted then the laser is out of self levelling range, place the laser on a more
level surface for the device to self level and power up.
To power up the vertical laser press the right function button on the keypad,
each press will cycle trough the dierent lasers. 1st press powers up the
vertical, 2nd press both vertical and horizontal laser lines. To power down
the laser level simply re-lock the pendulum by switching it to the “OFF”
Position.
Always transport the 2L360 laser level with the pendulum in the locked “OFF”
position to protect the device when not being used.
2L360TM OPERATING INSTRUCTIONS cont.
2L360G
(green beam)
2L360R
(red beam)
9
www.redbacklasers.com.au
Manual Mode
Manual mode allows you to turn on one or more of the 360 degree lines with
the pendulum in the locked position and so allows you to set up a laser line
at an angle such as for installing balustrades. Manual mode is activated by
pressing the manual mode left button when the pendulum is in the locked
“OFF” position. The manual mode LED light will ash warning you that the
laser is not self levelling. You can turn on the various lines in the normal way
by using the right laser function button.
Note that the 2L360R left button has two functions, Manual Mode and Pulse
Mode. See page 10
Unit featured is 3L360R in manual mode. Also pictured is an optional iet68 elevating tripod and
optional GD12 grade dial plate; a camera style tripod with pan and tilt will provide a similar result.
10 www.redbacklasers.com.au
2L360TM OPERATING INSTRUCTIONS cont.
Pulse Mode (3L360R only)
Pulse mode is only available on the 2L360R red beam model. Pulse mode
allows the 2L360R to be used with a line receiver such as the RedBack
LLR705 and so allowing the laser to be used outside for general site levelling,
patios, decking etc.
To enable pulse mode you press the left function button once when the laser
is powered up. The Pulse LED light on the left will indicate when pulse mode
is enabled, to disable once again press the left function button.
Ce manuel convient aux modèles suivants
2
Autres manuels RedBack Lasers Instrument de mesure
Manuels Instrument de mesure populaires d'autres marques
Endress+Hauser
Endress+Hauser Proline Promag 50 Caractéristiques techniques
Siemens
Siemens SITRANS F Coriolis FCT030 Manuel de la liste des pièces
KLINGER
KLINGER CMF V Series Manuel utilisateur
EXFO
EXFO FTB-2 Manuel d'exploitation et d'entretien
Keysight
Keysight M8290A Manuel utilisateur
ADTEK
ADTEK MW-5 Manuel utilisateur