Renaissance Cooking Systems RJC Series Instructional Book
The self-contained LP system barbeque grill is design certified to be used with a
standard 20 lb, 12 1/4" diameter, 18" high cylinder with fight handed connection threads.
The cylinder must be marked in accordance with the latest U.S. Department of
Transportation specifications for LP gas cylinders. (DOT. CFR49 or National Standards
Of Canada CAN/CSA-B359 Cylinders, Spheres and Tubes for the Transportation of
Dangerous Goods) The LP hose supplied by the manufacturer has a shut-off valve as part
of the hose assembly and should be turned to the OFF position when not in use.
Natural Gas Requirements
Always check the rating plate to make sure the gas supply you are hooking up to is the
gas type the grill is manufactured for.
The installation of this appliance must conform with local codes or, in the absence of
local codes, to the national fuel gas code, ANSI Z223.1a-1998. Installation in Canada
must be in accordance with the standard CAN/CGA-B149.2, Propane Installation Code.
IMPORTANT: Never connect the grill to an unregulated gas supply.
A licensed contractor or local gas company representative must perform all natural gas
connections.
Ensure that the service supplying the grill is fitted with a shut off valve conveniently
positioned near the grill and giving ease of access.
The grill must be isolated from the gas supply piping system by closing its individual
manual shutoff valve during any pressure testing of the gas supply piping system at test
pressures equal to or less than 0.5 psi (3.5 kPa).
The grill and its individual shutoff valve must be disconnected from the gas supply
piping system during any pressure testing of that system at test pressure in excess of
0.5 psi (3.5 kPa).
Slide the grill forward to gain access to the regulator and gas connection point in the
Connection
rear. Connect a suitable natural gas flex connector to the grill regulator.
Check the grill controls to ensure all control valves are in the full OFF position.
Turn on the main gas supply and check all connections for leaks using soapy water as
described in the leak testing procedure section.
Warning: If you see bubbles in the soapy solution at any of the connections, turn
off the gas supply and tighten the connection. If tightening the connection does
not seal the leak, it may be necessary to replace the flex hose.
