RCA D940 Manuel utilisateur

D940

REMOTE CONTROL

SIGNAL SENDER

Use RCA DBS Remote

to control RCA Brand DBS

Receiver from any TV

(Requires TVs

to be prewired to

DBS System Signal).

Operating Precautions ..........2

System Contents ....................4

System Set-Up

Extension Unit....................5

Base Unit ..........................6

Infrared Extender ..............7

Trouble Shooting ..................8

DBS System Signal Splitting....9

DBS Accessories..................10

Warranty............................12

TABLE OF CONTENTS

DBS_D940_IB.QXD 11/5/01 10:27 AM Page 1

When using your Remote Control Signal Sender as with any other electri-

cal device, basic safety precautions should always be followed to reduce the

risk of fire, electric shock and injury to persons, including the following:

1. Read and understand all instructions.

2. Follow all warnings and instructions marked on the product.

3. Unplug this product from the wall outlet before cleaning. Do not use

liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.

4. Do not use this product near water, for example: near a bath tub,

washbowl, kitchen sink, or laundry tub, in a wet basement, or in or

near a swimming pool.

5. Do not place this product on an unstable cart, stand, or table.

The product may fall, causing serious damage to the product.

6. This product should be operated only from the type of power source

indicated on the marking label. If you are not sure of the type of

power supply to your home or building, consult your dealer or local

power company.

7. To reduce the risk of electric shock, do not disassemble this product,

but take it to a qualified serviceperson when some service or repair

work is required. Opening or removing covers may expose you to dan-

gerous voltages or other risks and voids warranty. Incorrect reassembly

can cause electric shock when the product is subsequently used.

Operating Precautions

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER OR BACK

NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

DBS_D940_IB.QXD 11/5/01 10:27 AM Page 2

Operating Precautions

8.Unplug this product from the wall outlet and refer servicing to qualified

service personnel under the following conditions:

A. When the plug is damaged.

B. If liquid has been spilled into the product.

C. The product has been exposed to rain or water.

D. If the product does not operate normally by following

the operating instructions.

E. If the product has been dropped or the cabinet has been damaged.

F. If the product exhibits a distinct change in performance.

• No repairs to the unit(s) should be attempted by the customer.

• This device complies with Part 15 of the FCC Rules. Operation of

this device is subject to the following two conditions: (1) This device

may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause

undesirable operation.

• NOTE: This equipment has been tested and found to comply with the

limits for remote control security devices in accordance with the specifi-

cations in sub parts C and E of part 15 of FCC rules. These limits are

designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accor-

dance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that Radio Frequency

Energy does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and Base Unit.

• Connect the equipment into an outlet on a circuit different from that to

which the Base Unit is connected.

• Consult the dealer or an experienced Radio/TV technician for help.

DBS_D940_IB.QXD 11/5/01 10:27 AM Page 3

Compatible Components

• Television

• VCRs

•Stereo Receivers

• Tape Decks

• CD Players

• Cable Converter

• DBS Receiver

System Contents

Extension Unit

The Extension Unit senses the Infrared signals

from your remote control. An LED lights to

indicate that signals are being detected. The

Extension Unit converts the remote control sig-

nals into Radio Frequency (RF) transmissions

for communication with the Base Unit.

Base Unit

The Base Unit has an antenna, power cord,

and a jack for the Infrared Extender. The Base

Unit receives (RF) transmissions from the

Extension Unit. A light indicates that a signal

is being received. The Base Unit then converts

the RF transmissions back into Infrared sig-

nals used to control your DBS Receiver. The

Base Unit will operate up to 100 ft. away

from the Extension Unit.

Infrared Extender

This device consists of an Infrared Diode

connected to a 4 ft. extension wire and plug.

It plugs into the Base Unit for situations

where placement in front of the DBS Receiver

is difficult.

Your D940 Remote Control Signal Sender consists of an

Extension Unit, a Base Unit and an infrared extender.

DBS_D940_IB.QXD 11/5/01 10:27 AM Page 4

Where to Use

Use in the room where you want to use your

remote control (example: use in the additional

room wired to receive DBS System signal).

How to Install

1. Plug the Extension Unit into a standard

electrical outlet.

2. Place the logo side of the Extension Unit facing

you. It can be placed up to 18 ft. from where

you will be using the remote control.

Extension Unit Set-Up

Remote Control

Maximum 18 ft.

Extension Unit

DBS_D940_IB.QXD 11/5/01 10:27 AM Page 5

Base Unit Set-Up

Where to Use.

Use in the room where the DBS

Receiver is located.

How to Set-Up

1. Plug the Base Unit power cord into standard

electrical outlet.

2. Point the front of the Unit (logo side) facing

the DBS Receiver. Extend the antenna

for best performance.

3. Check the following distances

• Base Unit is within 20 ft. of DBS Receiver.

• Base Unit is within 100 ft. of Extension Unit.

DBS

DISH

NTENNA

Base Unit

DBS Receiver

Maximum 20 FT.

After setting up your Extension and Base Units, operate the Signal

Sender by aiming your remote at the RCA logo on the front of the

Extension Unit.

DBS_D940_IB.QXD 11/5/01 10:27 AM Page 6

Infrared Extender Set-Up

Where to Use

• Use when Base Unit cannot be easily

placed in front of the DBS Receiver.

(Example: when DBS Receiver and Base

Unit are located in a closed cabinet).

• Use when you would prefer to conceal the

Base Unit in a cabinet or behind furniture.

How To Use

1. Plug the Infrared Extender into back of

Base Unit.

2. Place the Infrared Diode (located on the

opposite end of the extension cord) in

clear view of DBS Receiver to enable

signal transmission.

DBS Receiver

Base Unit

Signal Extender Diode

Example of Application: TV & DBS Receiver in Cabinet

DBS_D940_IB.QXD 11/5/01 10:27 AM Page 7

1. Make sure both units are plugged into a standard electrical outlet.

2. If the red light inside the Extension Unit does not light when the

Remote Control is operated:

• Make sure you are pointing at the front of the Extension Unit

(the RCA logo is on the front).

• Make sure you are within 18 ft. of the front of the

Extension Unit.

• Make sure nothing is blocking the path between the remote and

the Extension Unit.

3. If your DBS Receiver does not respond but the red light inside the

Base Unit lights when a remote control is used:

• Make sure the Base Unit is within 20 ft. of your

DBS Receiver.

• Make sure the Base Unit front is pointing at the front of your

DBS Receiver.

• Make sure nothing is blocking the Base Unit and the

DBS Receiver.

4. If the red light on the Extension Unit lights when you operate the

remote but does not light in the Base Unit:

• Extend the antenna all the way up or move the antenna to a

different position for better reception.

• Make sure the Extension Unit is no more than 100 ft. from

the Base Unit.

5. Move the Unit that appears not to be working to another location

and try it again.

6. Attach the infrared extender to the Base Unit for situations where

there is an obstruction (TV Cabinet, etc.).

Troubleshooting

DBS_D940_IB.QXD 11/5/01 10:27 AM Page 8

DBS Signal Splitting

1. Hook up the DBS Receiver as outlined in the Receiver Owners Manual.

2. Using a 2 Way Signal Splitter (RCA Model D800)/4 Way Signal Splitter

(RCA Model D810) connect the splitter “Input” to the DBS Receiver

“Out to TV”. This will require a small length of coaxial cable.

3. Connect one output of the splitter to the original TV and connect the

other output to the second TV via coaxial cable.

REMOTE CONTROL

REMOTE CONTROL SIGNAL

SENDER EXTENSION

REMOTE CONTROL SIGNAL

SENDER BASE UNIT

COAXIAL CABLE

DBS RECEIVER

DBS_D940_IB.QXD 11/5/01 10:27 AM Page 9

To purchase these accessories, contact your local dealer. If no dealer is

available, call the toll free number listed on next page and order by

phone (please allow 2–4 weeks for delivery).

RCU800 Universal Remote

Controls Multiple Brands of TVs

VCRs, Cable Boxes, DVD

Players, and the RCA DBS

Receiver.

D935 DBS Signal Sender Extension Unit

Use with your Base Unit to

control your DBS system receiver

from additional locations.

D800 2 Way Signal Splitter 2 Way or 4 Way signal splitter to

D810 4 Way Signal Splitter run your DBS System“Out To

TV” cable to additional locations.

VH74 Deluxe 2 Way A/B Switch Use to switch between your DBS

system and antenna.

CABLE

ATO

TV CABLE

DBS Accessories

DBS_D940_IB.QXD 11/5/01 10:27 AM Page 10

Autres manuels pour D940

Table des matières

Autres manuels RCA Télécommande

RCA

RCA SystemLink CRCU100 Manuel utilisateur

RCA

RCA RCR312W Manuel utilisateur

RCA

RCA RCR311SR Manuel utilisateur

RCA

RCA RCRN04GR Manuel utilisateur

RCA

RCA RCRPS04GR Manuel utilisateur

RCA

RCA RCR451 Manuel utilisateur

RCA

RCA RCU500 Manuel utilisateur

RCA

RCA SystemLink 6 AV RCU600RS Manuel utilisateur

RCA

RCA RCU704 Series Manuel utilisateur

RCA

RCA RCR414BHE Manuel utilisateur

RCA

RCA RCRN06GR Manuel utilisateur

RCA

RCA RCRP05BR Manuel utilisateur

RCA

RCA RCRP05B Manuel utilisateur

RCA

RCA NiteGlo RCU4GLW Manuel utilisateur

RCA

RCA RCU1010RF Manuel utilisateur

RCA

RCA RCRV06GR Manuel utilisateur

RCA

RCA RCR461 Manuel utilisateur

RCA

RCA RCRN06GR Guide de l'administrateur

RCA

RCA RCRPS02GR Manuel utilisateur

RCA

RCA RCR504BR Series Manuel utilisateur

RCA

RCA rcu1000b Manuel utilisateur

RCA

RCA SYSTEMLINK3 RCU1300 Manuel utilisateur

RCA

RCA RCRPS02GR Manuel utilisateur

RCA

RCA RCU430D Manuel utilisateur

Manuels Télécommande populaires d'autres marques

Panasonic

Panasonic EUR7622KB0 Manuel utilisateur

Bang & Olufsen

Bang & Olufsen Beo4 Manuel utilisateur

Sunwave Tech.

Sunwave Tech. RemoteComm SRC-7000 Manuel utilisateur

Multiplex

Multiplex PROFI TX 9 Manuel utilisateur

One Remote

One Remote RMB4 Manuel utilisateur

FUTABA

FUTABA 9ZAP - PART2 Manuel utilisateur

HR Matic

HR Matic HR MULTI 3 Manuel utilisateur

Yamaha

Yamaha ACC-GNRST-30-20 Manuel utilisateur

EisSound

EisSound KBSOUND Manuel utilisateur

Marantz

Marantz RC101 Manuel utilisateur

Conrad

Conrad FS20 TC6 Manuel utilisateur

Anritsu

Anritsu MP1777A Manuel utilisateur

Niles

Niles WVC100 Guide de dépannage

Bang & Olufsen

Bang & Olufsen BEO6 Manuel utilisateur

GE 94901 Manuel utilisateur

Onbon

Onbon YQ1-75 Manuel utilisateur

FUTABA

FUTABA R7108SB Instructions d'installation

Invacare

Invacare G91S Manuel utilisateur