Raymarine Raystar 114 Manuel utilisateur
Distributed by
Any reference to Raytheon or
RTN in this manual should be
interpreted as Raymarine.
The names Raytheon and RTN
are owned by the
Raytheon Company.
Combined GPS
& Differential
Beacon Receiver
Installation
Guide
Document number: 81151_3
Date: 4th Aug 1999
Installation Guide 1
IMPORTANT NOTICE
This device is only an aid to navigation. Its accuracy can be
affected by many factors, including equipment failure or defects,
environmental conditions and improper handling or use.
It is the user’s responsibility to exercise common prudence and
navigational judgement, and this device should not be relied upon
as a substitute for such prudence and judgement.
1. EMC Installation & Service Guidelines
All Raytheon equipment and accessories are designed to the best
industry standards for use in the leisure marine environment.
Their design and manufacture conforms to the appropriate
Electromagnetic Compatibility (EMC) standards, but correct
installation is essential to maintain EMC performance and CE
compliance. Although every effort has been taken to ensure that they
will perform under all conditions, it is important to understand what
factors could affect the operation of the product.
Installation
All Raytheon equipment and cables connected to it should be;
• At least 1m (3ft) from any equipment transmitting or cables carrying
radio signals eg. VHF radios, cables and antennas. In the case of
SSB radios, the distance should be increased to 2m (7ft).
• More than 2m (7ft) from the path of a radar beam.
• The equipment should be supplied from a different battery than the
one used for engine start. Voltage drops below 10.7V in the power
supply to our products can cause the equipment to reset. This will
not damage the equipment, but may cause the loss of some
information and can change the operating mode.
• Genuine Raytheon cables should be used at all times. Cutting and
rejoining these cables can compromise EMC performance and so
should be avoided unless doing so is detailed in the installation
manual.
2Raystar 114
Check Before Going to Sea
• Always check the installation before going to sea to make sure that it
is not affected by radio transmissions, engine starting etc.
• In some installations, it may not be possible to prevent the
equipment from being affected by external influences. In general
this will not damage the equipment but can lead to it resetting, or
momentarily may result in faulty operation.
Servicing and Safety
• This product contains no user servicable parts.
• Raytheon equipment should be serviced only by authorised
Raytheon service engineers. They will ensure that service
procedures and replacement parts used will not affect performance.
There are no user serviceable parts in any Raytheon product.
• Always report any EMC related problem to your nearest Raytheon
dealer. We will use any such information to improve our quality
standards.
Installation Guide 3
2. Package Contents
Checking your Raystar 114 Package
The Raystar 114 Combined GPS and Differential Beacon Receiver
package contains the following standard items:
1. Raystar 114
2. Beacon Aerial
3. Ground screw with eyelet
4. Installation Guide including Warranty document
Items Missing?
If any of the above items are missing or damaged, please contact your
Raytheon dealer or our Product Support Department to obtain
replacement parts. Please note that missing or damaged items
cannot be replaced without proof of purchase.
Registering this Product
When you have checked that you have all of the listed components,
please take the time to complete the warranty document and return it to
your national distributor.
By returning this document you will receive prompt and expert
attention should you ever experience any difficulties with this product.
Also, your details are added to our customer database so that you
automatically receive new product brochures as and when they are
released.
4Raystar 114
3. Summary of Features
GPS
Receiver type: 12 Parallel channels
Frequency: 1575.42 MHz +/- 1 MHz (C/A code), L1
Sensitivity: -130dBm
Signal acquisition: Automatic
Time to first fix: 15 minutes maximum,
typically 2 minutes
Standard GPS
Position accuracy: 15 m RMS. (L1, C/A code
HDOP <2.5 without SA)
Speed accuracy: 1 knot RMS. (L1, C/A code
HDOP <2.5 without SA)
Differential GPS
Position accuracy: <7.5 m RMS. (L1, C/A code
HDOP <2.5 with SA)
Speed accuracy: 0.5 knot RMS. (L1, C/A code
HDOP <2.5 with SA)
Geodetic Datum: WGS-84
(190 alternatives programmable)
Power Requirements: 12 Vdc, 0.3 A nominal
(10-16 V input range)
Cable length: 15 m (49 ft 3 in)
Operating Temp.: -10 to 700C (14 to 1580F)
Storage Temp.: -10 to 700C (14 to 1580F)
CE mark: Conforms to 89/336/EEC(EMC),
EN60945:1997
Data Input/Output:
NMEA Mode NMEA0183 V2.3 Output
Non-isolated NMEA Input
SeaTalk mode SeaTalk Bus
Memory Backup: Lithium battery (10 year life)
Disposal Note: Care should be taken when disposing of this equipment
as a Lithium battery is fitted internally.
Local regulations may apply and must be adhered to.
Installation Guide 5
Differential Beacon Receiver
Frequency Range: 283.5 to 325.0 kHz
MSK Bit Rate: 100, 200 bps
Frequency Resolution: 0.5 kHz
Sensitivity: 2.5 mV/ m @10dB SNR @ 100 bps
Frequency Selection: Automatic / Manual (user-selectable)
6Raystar 114
4. Raystar 114 Installation
The Raystar 114 is designed to receive the signals emitted from the
satellites in a direct path. Ideally, the unit should be mounted upright in
a location that is open and clear of any masts, search lights, or other
structures that could block the line-of-sight reception of the antenna
unit. The height of the receiver is not as important as the receiver having
a clear view horizon to horizon for optimum signal reception. In fact,
the lower the unit can be mounted and have a clear view to satellites, the
better. The more stable the internal GPS antenna, the easier it is to track
satellites lower to the horizon.
Installation of the Raystar 114 should only be undertaken by a
competent installer.
D1340-2
The unit should be separated by at least 7ft (2m) from other
communication antennas and should not be mounted in the direct path
of a Radar’s antenna beam.
While planning the location for the unit, consider finding a convenient
pathway for running the interconnecting cable which will connect the
receiver to the GPS display unit or to the rest of an integrated system.
Installation Guide 7
Ideally the cable should be run in a manner so that it can be hidden from
view and, if possible, be in a direct path to the point of connection. It is
important to keep the cable separated from other shipboard cables as
much as possible to prevent interference pick-up.
CAUTION
Care should be taken that the unit is sited to avoid personal injury
caused by falling on the aerial.
Note: Mounting on the mast of a sailboat is not recommended.
Grounding the System
For optimum operation the unit should be connected to the ship’s
ground system. You can ground the unit using one of the following
three methods:
1. A 24 AWG wire can be connected via the screw connection found
in the base of the unit, as shown in the following illustration. A
suitable wire with eyelet is attached to the unit. If this length is
insufficient, use similar wire and connect with the additional eyelet
and screw provided.
D4435-2
Grounding
screw
2. The cable screen can be connected to ground.
Note: This will require the insulation to be cut back to obtain
access to the screen.
3. A conducting pole mount, which is connected to ground, can be
screwed into the base of the unit.
Table des matières
Autres manuels Raymarine GPS
Raymarine
Raymarine GPS 15 Manuel utilisateur
Raymarine
Raymarine GPS navigation Manuel utilisateur
Raymarine
Raymarine Raychart 320 Manuel utilisateur
Raymarine
Raymarine Raystar 590 Manuel utilisateur
Raymarine
Raymarine A65 Manuel utilisateur
Raymarine
Raymarine RC400 Guide de l'utilisateur
Raymarine
Raymarine Raynav 7000 Manuel utilisateur
Raymarine
Raymarine E90W Manuel utilisateur
Raymarine
Raymarine Pathfinder Manuel utilisateur
Raymarine
Raymarine E90W Manuel utilisateur
Raymarine
Raymarine Raytheon NAV 398 Manuel utilisateur
Raymarine
Raymarine PowerPilot Manuel utilisateur
Raymarine
Raymarine G-Series system Manuel utilisateur
Raymarine
Raymarine AXIOM Manuel utilisateur
Raymarine
Raymarine Apelco 6700 Manuel utilisateur
Raymarine
Raymarine RS130 GPS Manuel utilisateur
Raymarine
Raymarine RS130 GPS Manuel utilisateur
Raymarine
Raymarine RC435 Guide de l'utilisateur
Raymarine
Raymarine A60 Manuel utilisateur
Raymarine
Raymarine 530 Guide de l'utilisateur
