Ravelli HRB160 Manuel utilisateur

Brochure for

HRB160 model

Brochure for HRB160 model

Stove, support and frame:

stove FRAME

STOVE

stove SUPPORT

Brochure for HRB160 model

Manteinance and cleaning:

Before carrying out any maintenance operation take the following precautions:

- Make sure that the general power switch has been disconnected.

- Make sure that all the parts of the stove are cold.

- Make sure that the ashes have cooled completely.

- Always use appropriate tools for maintenance.

- When you have ﬁ nished maintenance reinstall all the safety guards before using the stove again.

The stove requires little maintenance if a good quality pellet is used. Therefore it is difﬁcult to establish how often the stove needs to be

cleaned. The quality of the pellet and the combustion adjustment are crucial.

Cleaning the combustion chamber:

The stove requires simple but frequent cleaning to guarantee an efﬁ cient yield and correct functioning. Therefore, clean the combustion

chamber every day using a drum-type vacuum cleanermaking sure that the ashes have gone out completely.

COMBUSTION CHAMBER

FIRE POT

Cleaning the re pot:

Clean the ﬁ re pot as described in the dedicated chapter of the instruction manual. Only a clean and tidy ﬁ re pot can guarantee

that the pellet stove will run without any problems. Deposits may form while it is running and these must be eliminated immediately.

Correct, daily cleaning will allow the stove to burn properly and to give a good yield, avoiding problems that in the long term

could require the intervention of a technician to repair the stove.

Fire pot GRATE

Brochure for HRB160 model

INSPECTION HATCH

(NR.1 right side)

INSPECTION HATCH

(NR.1 left side)

GASKETS

How to pull out the insert:

In order to pull the stove out push down the unhooking lever (as shown below in the drawing). In order to pull the stove

back into the ﬁreplace, keep the lever pushed down until the stove completely ﬁts in the ﬁreplace.

Access and cleaning of inspection hatches:

In order to access the inspection hatches, you need to ﬁrst pull the stove out.

Brochure for HRB160 model

Cleaning of “T” discharge:

Remove the two “M5” screws that ﬁx the inspection

door and the silicone seal to the discharge in order to

access it and carry out cleaning operations.

INSPECTION HATCH

GASKET

PARTS / FREQUECY Everyday every 2-3 days every 30 days every 60-90 days every season

Fire pot

Ash-drawer

Glass

Suction duct

Door gasket

Tube bundle turbolators

Exhaust pipe

Combustion chamber

Suction of pellet tank

Cleaning of the tube bundle:

The cleaning of the tube bundle is an operation to be carried out daily (WHEN THE STOVE IS COLD)

moving 4-5 times TURBOLATORS mounted on the stove (as shown below in the drawing). In order to

access to the turbolators, you need to pull the stove out from the ﬁreplace. In case the optional pellet

drawer has been mounted on the stove, in order to access to the turbolators you only need to pull the

drawer out.

Turbolators

Brochure for HRB160 model

Access to the debimeter and the electric mother board:

In order to access to the debimeter and the mother board, pull the stove completely out along the entire lenght of the tele-

scopics guides.

DEBIMETER

MOTHER BOARD

Position of automatic air valve

This hydraulic component is placed on the LEFT side of the stove. In order to access the automatic air valve, pull the stove

out.

Brochure for HRB160 model

The cable tightener (optional)

Placed on the rear part of the support, the cable tightener is designed to avoid that, on extracting

the stove, the power supply cable falls between the base of the stove and the support surface of the

stove, resulting in damage and disconnection.

Cable tightener

Assembly of front pellet loading drawer (optional)

Remove the four upper components of the hopper.

Remove the front grate.

Brochure for HRB160 model

Fix the drawer grate and pull the drawer in the dedicated space (as shown below in the drawing).

In order to load the hopper of the frontal drawer, open the drawer pulling the frontal grate. Then load

the pellet and push the pellet inside the hopper using the little shovel supplied togheter.

Assembly of lateral pellet loading kit (optional)

Remove the four upper components of the hopper.

Brochure for HRB160 model

Mount the pellet loading kit and its support as shown below in the drawing:

Brochure for HRB160 model

Frontal view of the stove after having mounted the lateral pellet loading kit. Maximum dimensions are

indicated below.





Table des matières

Autres manuels Ravelli Poêle

Ravelli

Ravelli HRV 180 PLUS Manuel utilisateur

Ravelli

Ravelli HRV 200 Glass Manuel utilisateur

Ravelli

Ravelli MIA 90 Manuel utilisateur

Ravelli

Ravelli Francesca 2015 Manuel utilisateur

Ravelli

Ravelli HOOP 7 STEEL Manuel utilisateur

Ravelli

Ravelli HRV 140 Globe Manuel utilisateur

Ravelli

Ravelli Ecotek FLOW LINE Guide de l'utilisateur

Ravelli

Ravelli BLOCK 7 STONE Manuel utilisateur

Ravelli

Ravelli HRV 160 Touch Manuel utilisateur

Ravelli

Ravelli RBH 150 V Manuel utilisateur

Ravelli

Ravelli HR70 Manuel utilisateur

Ravelli

Ravelli Magnus Manuel utilisateur

Ravelli

Ravelli Sphere V Deco Manuel utilisateur

Ravelli

Ravelli HRV 140 Silhouette Manuel utilisateur

Ravelli

Ravelli Hydro Manuel utilisateur

Ravelli

Ravelli COMPACT RBV 710 Manuel utilisateur

Ravelli

Ravelli SARA 700 Manuel utilisateur

Ravelli

Ravelli Dual 7 Guide de démarrage rapide

Ravelli

Ravelli HRV170 Manuel utilisateur

Ravelli

Ravelli AURORA CANALIZZATA Mode d'emploi

Ravelli

Ravelli Circular 7 Manuel utilisateur

Ravelli

Ravelli SPILLO Manuel utilisateur

Ravelli

Ravelli HRV 180 PLUS Manuel utilisateur

Ravelli

Ravelli VELA 7 series Manuel utilisateur

Manuels Poêle populaires d'autres marques

Arada

Arada Cassette Stove Manuel utilisateur

Parmco

Parmco FS 600 Manuel utilisateur

MCZ

MCZ SUITE AIR 10 M2 Manuel utilisateur

HearthStone

HearthStone Stowe DV 8321 Guide de dépannage

Cattara

Cattara FAMILY Manuel utilisateur

Stanley

Stanley Argon F500 OVAL Manuel utilisateur

Avalon

Avalon B-VENT Manuel utilisateur

Nordpeis

Nordpeis Vega Manuel utilisateur

Exquisit

Exquisit EKC601-5 Manuel d'utilisation

Stanley

Stanley Oisin Oil MK II Manuel du propriétaire

Thermocet

Thermocet Brookfield S/CC Manuel utilisateur

HASE

HASE delhi Manuel utilisateur

Vermont Castings

Vermont Castings Intrepid 2 Manuel utilisateur

Italiana Camini

Italiana Camini CLASSICA Guide de démarrage rapide

Avalon

Avalon Vashon Avanti DVS FS Manuel utilisateur

Spartherm

Spartherm ambiente a1 Manuel utilisateur

Dimplex

Dimplex MCFSTV12AU Manuel utilisateur

Warmlite

Warmlite WL46040 Manuel utilisateur