Ranger design MAX RACK 2.0 Manuel utilisateur

™

MAX RACK 2.0

OPERATOR’S MANUAL

1-800-565-5321 / rangerdesign.com

MAX RACK 2.0

LOADING INSTRUCTIONS



™

Please place provided label

on your ladder to mark the

hook mounting point.

Load ladder on front hook (Sticker

can be applied for easy reference).

Lift the ladder from the rear

and push the ladder forward.

THE LADDER LOCK

MUST LINE UP

IN THE MIDDLE OF

TWO RUNGS WHEN

LOADING THE LADDER

™

Ensure the anti-theft pin is

engaged and locks your ladder.

Rotate the ladder over

the rear hook and settle

it into the anti-theft.

MAX RACK 2.0

OPERATING INSTRUCTIONS

STEP TWO

With both hands, insert the

handle into the Max Rack and

turn to secure.

STEP THREE

Pull the handle down

towards you.

1-800-565-5321 / rangerdesign.com

STEP ONE

Release positive lock before

operating the rack.

LOWER LADDER

STEP FOUR

Turn around. Push the handle

forward.

STEP FIVE

Continue to push the handle until

the Max Rack has ﬁnished its

descent. Do not let go of handle

until ladder has fully descended.

STEP ONE

Push the handle, don’t pull it.

™

RAISE LADDER

1-800-565-5321 / rangerdesign.com

MAX RACK 2.0

MAINTENANCE SCHEDULE

WEEKLY

INSPECT CYLINDERS FOR

OIL OR DIRT ON PISTON.

Wipe the cylinders with a paper to verify

for leaks. If there is a leak, your cylinder

is failing. Plan for a replacement.

OPERATE RACK TO HALF-POINT POSITION.

Push ladder and mechanism back onto roof and check for loose

or rattling parts.

INSPECT INTERLOCKING

HOOKS TO ENSURE THEY ARE

TIGHT AND DO NOT RATTLE.

Disclaimer Carrying ladders on your roof can be dangerous. While minimizing the risks is Ranger Design’s

top priority, ladder rack safety is ultimately the user’s responsibility. Regular maintenance can also help

prevent accidents and extend the life of your rack and ladders.

MONTHLY

™

INSPECT CYLINDERS, FOUND

ON THE FRONT AND REAR

MECHANISMS.

Check for leaks and tighten nuts if loose.

INSPECT BOLTS AND NUTS

ON THE SHAFT AND FRAME.

TIGHTEN IF LOOSE.

INSPECT ELBOW FOR ANY CRACK

AND ENSURE THE SLEEVE RESTS

FLUSH TO THE PIPE KEEPING THE

PIN KEY IN PLACE.

MAX RACK 2.0

LADDER INSTALLATION

CORRECT HOOK POSITION

YOU MUST ENSURE:

The arm socket and the ladder do not extend beyond the rear bumper of the vehicle.

The center of the ladder must be minimum 15" behind the front hook when the ladder

is loaded.

REAR FRONT

FLUSH

FRONT HOOKCENTER OF THE LADDER

MINUMUM 15"

END OF THE LADDER

FLUSH

END OF THE LADDER MINIMUM 15"

FRONT HOOK

CENTER OF THE LADDER

1/16"

1.5"

FLUSH

1-800-565-5321 / rangerdesign.com

Failing to comply with the hook adjustment settings can result in unrestrained ladder as shown

in Figure 1 and Figure 2. In these conditions the ladder can dislodge from the vehicle, causing

serious injuries to road user and can be life threatening.

FIGURE 1 FIGURE 2

™

MAX RACK 2.0

WARNING

1-800-565-5321 / rangerdesign.com

MAX RACK 2.0

MAXIMUM LADDER LENGTH

Max Rack Maximum Ladder LENGTH

Page 1 of 3

Max Rack Maximum Ladder LENGTH

Page 2 of 3

Max Rack Maximum Ladder LENGTH

Page 1 of 3

Max Rack Maximum Ladder LENGTH

Page 1 of 3

VEHICLE MODEL

(RACK MODEL SHOWN)

16ft

(32ft LADDER)

12ft

(24ft LADDER)

APPROX. 15"

CENTER OF MASS

OF THE LADDER

CENTER OF MASS

OF THE LADDER

FRONT HOOK

OF THE RACK

FRONT HOOK

OF THE RACK

MAXIMUM

LADDER LENGTH

32ft

MERCEDES

SPRINTER

(1870-DH)

NISSAN

(1870-NH)

FORD

TRANSIT

REGULAR WHEELBASE

(1870-FTR)

FORD

TRANSIT

LONG/EXTENDED

WHEELBASE

(1870-FTL)

24ft

32ft

12ft

(24ft LADDER)

APPROX. 15"

CENTER OF MASS

OF THE LADDER FRONT HOOK

OF THE RACK

16ft

(32ft LADDER)

APPROX. 15"

CENTER OF MASS

OF THE LADDER FRONT HOOK

OF THE RACK

Table des matières

Autres manuels Ranger design Support et étagère

Ranger design

Ranger design 1530-PC Manuel utilisateur

Ranger design

Ranger design 1530-NL Manuel utilisateur

Ranger design

Ranger design C5-BA13-4 Manuel utilisateur

Ranger design

Ranger design 76-U1236 Manuel utilisateur

Ranger design

Ranger design C4-BA11-3 Manuel utilisateur

Ranger design

Ranger design 1050-FS Manuel utilisateur

Ranger design

Ranger design C4-BA11-4 Manuel utilisateur

Ranger design

Ranger design 84-U0063 Manuel utilisateur

Ranger design

Ranger design 1530-NSX Manuel utilisateur

Ranger design

Ranger design S2-RS60-2 Manuel utilisateur

Ranger design

Ranger design C4-BA13-3 Manuel utilisateur

Manuels Support et étagère populaires d'autres marques

Salamander

Salamander Acadia AC/W/L400/WH Manuel utilisateur

Fohhn

Fohhn VAT-09 Guide de l'utilisateur

ricoo

ricoo FS0522 Manuel utilisateur

AMSOIL

AMSOIL BMK-22 Guide rapide

Kargo Master

Kargo Master 48220 Manuel utilisateur

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manuel utilisateur

ricoo

ricoo S1222 Manuel utilisateur

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manuel utilisateur

VidaBox

VidaBox VB MNT FFS2 Manuel utilisateur

Welch Allyn

Welch Allyn 48960 Manuel utilisateur

Arkon

Arkon CM035-ST-2 Manuel utilisateur

PROEL

PROEL PLWIN60C Manuel utilisateur

Agilent Technologies

Agilent Technologies E2609B Manuel utilisateur

Mustang

Mustang MV-ARM4 Manuel utilisateur

Mounting Solutions

Mounting Solutions WRM-320 Manuel utilisateur

Pyle

Pyle PMKSPAD1 Manuel utilisateur

ShelterIt

ShelterIt 21208 Manuel utilisateur

SPL

SPL RackPack?4 1040 Manuel utilisateur