Rainware Pty Ltd
ABN: 96 640 055 079 ACN: 134 925 705
Unit 1 9 Newing Way
Caloundra Qld Australia 4551
Phone: 0754 926 200
Fax: 0754 926 788
Mobile Phone: 0411 660 933
Email: admin@rainware.com.au
Web Site: www.rainware.com.au
Marengo Shower Rose Installation & Assembly Instructions
1. Marengo shower is disassembled for packaging please follow instructions to make assembly
and installation easier. Please do not disable the rose head it has been pretested for leaks.
2. Before assembling the rose head to the tubing, screw the tubing to the ½” BSP thread on
the wall clock wise. Position the hole marked top at the top.
3. For Masonry walls: Mark the wall to drill 3 x 8mm holes for the plastic wall plugs provided.
Holes need to be at least 45mm deep.
4. For Timber walls: Mark the wall and drill 3 x 3mm holes to limit splitting of timber.
5. Unscrew the tubing off the wall to make assembly easier.
6. Drill holes in wall and insert plastic wall plugs if required.
7. To assemble the rose to the tubing follow the next steps.
8. Remove button head screws in Tubing (A) and Rose head (B) refer to picture page.
9. Leaving the brass wall body attached to the hose inside the tube. Slide the hose out of
tubing at the rose end.
10. Attach the rose head to the hose (Diagram C), connection should be hand tight then ½ turn
with spanner. Do not over tighten, Do not use thread sealer or thread tape.
11. Slide the hose back into the tube so the rose head is flush with end of tubing.
12. Screw in button head bolt through hole in tubing into black plastic body on rose head
(Bolt B).
13. At the wall end (Flanged end) push in brass wall body into tube and rotate so the holes line
together. Screw in button head bolt through tubing into brass wall body locating it into
position(Bolt A).
14. Your Marengo shower rose is now assembled and ready to attach to the wall.
15. Important: Flush pipe work before attaching to the wall.
16. Check the flow regulator is in position in the brass wall body and held in place by a green
washer.
