Radiant R1K 50 Manuel utilisateur

R1K 50 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS

Use Manual for model

Premix condensing system boiler

only heating, suitable for outdoor installation

R1K 50 RAIN

R1K 50 RAIN_Man.Ut._AHS_EN

Contact Details

Office Address: 10 Frankston Gardens Drive,

Carrum Downs, Victoria, Australia, 3201

Email Address: sales@hydronicsupplies.com.au

Website: www.hydronicsupplies.com.au

Phone: (+61 3) 9708 2600

Fax: (+61 3) 9708 2700

R1K 50 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS

R1K 50 RAIN_Man.Ut._AHS_EN

TABLE OF CONTENTS

1.1. USE 5

1.1.1. GENERAL USE WARNINGS 5

1.1.2. CONTROL PANEL 6

1.1.3. DISPLAY ICONS 7

1.1.4. INFO MENU DISPLAY DATA 8

1.1.5. START-UP 9

1.1.6. OPERATING MODE 9

1.1.7. INFORMATIONAL NOTE ON ANTI-FREEZE FUNCTION 10

1.1.8. FAULT SIGNALLING CODES 11

1.1.9. ACTIVE FUNCTIONS SIGNALLING CODES 13

3.1.10. COVER CLEANING 14

3.1.11. DISPOSAL 14

R1K 50 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS

R1K 50 RAIN_Man.Ut._AHS_EN

TABLE OF CONTENTS

R1K 50 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS

3 Avvertenze generali per l'utilizzo_EN

3. USE

USER

1.1. USE

1.1.1. GENERAL USE WARNINGS

WARNING

Before starting the boiler the User must

make sure that the First start-up certificate has the

stamp of the technical Support Centre proving the

testing and the first start-up of the boiler.

WARNING

To validate the warranty, the boiler must

be started by a technical Support Centre authorized

by RADIANT no later than 30 days from the date of

installation.

WARNING

In order to take advantage of the guarantee

provided by the manufacturer, the customer should

carefully and exclusively observe the instructions

given in the USER section of the manual.

ATTENTION

This machine may be used only for the

purpose for which it has been designed: heat water

to a temperature below boiling point at atmospheric

pressure. Any other use is considered wrong and

dangerous. The manufacturer is excluded from

any contractual or out of contract responsibility for

damage caused to people, animals or property due to

incorrect use.

DANGER

The boiler should not be used by persons

(including children) with reduced physical, sensory or

mental capacities or without suitable knowledge or

experience unless they are instructed on the device

use or monitored by a person responsible for their

safety.

DANGER

DO NOT obstruct the air vents of the

location in which the gas device is installed to prevent

the formation of toxic explosive mixes.

DANGER

If you sense a gas odour in the location in

which the boiler is installed, proceed as follows:

› DO NOT use electrical switches, the telephone or

any other device that might generate electrical

discharges or sparks;

› Immediately open all doors and windows to

create an air exchange that can quickly clean the

location;

› Close the gas valves;

› Request immediate intervention of qualified

staff.

DANGER

The use of the electrical power boiler

implies respecting some fundamental rules such as:

› DO NOT touch the device with wet and/or humid

parts and/or with bare feet;

› DO NOT pull the electrical cables;

› DO NOT leave the device exposed to atmospheric

agents (rain, sun, etc.) unless specifically

intended;

› in case of cable damage, turn off the device and

contact qualified professional staff to replace it.

R1K 50 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS

3Pannellocomandi_solorisc_MIAH4_R2_G_EN

3. USE

USER

1.1.2. CONTROL PANEL

KEY

1. HEATING TEMPERATURE ADJUSTMENT KEYS

2. INFO KEY: PRESS ONCE TO VIEW THE

TEMPERATURES AND OTHER INFORMATION

(see chapter ‘INFO MENU DISPLAY) - HOLD

FOR 5 SECONDS, IN OFF OPERATING MODE,

TO VIEW THE LAST 5 FAULTS

3. OPERATING MODE SELECTION KEY: ONLY

HEATING / OFF

4. RESET KEY: FAULTS RESET - CHIMNEY

SWEEP FUNCTION ACTIVATION (HOLD FOR 7

SECONDS)

5. VALUE OF THE PARAMETERS ADJUSTMENT

KEY / HOLD THE KEYS AT THE SAME TIME

FOR 5 SECONDS TO ACTIVATE DISPLAY BACK

LIGHT FOR 10 MINUTES

6. DISPLAY

2 3 4

R1K 50 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS

3 Icone del display_solo risc_MIAH4_EN

3. USE

USER

1.1.3. DISPLAY ICONS

KEY

1. INDICATION OF PARAMETER NUMBER OR

DISPLAYED INFO CODE

2. PARAMETERS PROGRAMMING FUNCTION

ACTIVE

3. SIGNALLING CONNECTED SOLAR BOARD /

SOLAR COLLECTOR TEMPERATURE DISPLAY

(d5)

4. SOLAR PUMP ACTIVE

5. BOILER LOWER TEMPERATURE DISPLAY (d6)

/ BOILER UPPER TEMPERATURE DISPLAY (d7)

6. EXTERNAL PROBE INSTALLED / EXTERNAL

PROBE TEMPERATURE (d1)

7. TEMPERATURE DISPLAY / SET POINT /

PARAMETER VALUE

8. OPEN THERM COMMUNICATION PRESENT

(REMOTE CONTROL / AREA CONTROL UNIT)

9. INSUFFICIENT SYSTEM WATER PRESSURE

SIGNALLING

10. FLAME PRESENT SIGNALLING / IT ALSO

INDICATES, ON 3 PERCENTAGE LEVELS, THE

MODULATING POWER LEVEL OF THE BOILER

(fig.2)

11. ERROR DISPLAY THAT CAN BE RESET

12. OFF OPERATING MODE

13. ERROR DISPLAY THAT CAN NOT BE RESET

14. OPERATION IN HEATING MODE ENABLED

456 7

111213

≤ 33% >33%<66% >66%<100%

fig. 1

fig. 2

R1K 50 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS

3VisualizzazionidelmenùInfo_MIAH4_firm.L224C_EN

3. USE

USER

1.1.4. INFO MENU DISPLAY DATA

To view the boiler data from info menu you just have to press the INFO ‘ ’ key. The info code will be

displayed on the left side of the screen and its relative value will be displayed on the centre of the screen.

Use keys ‘ ’ and ‘ ’ of the heating circuit to scroll through the list of displayed data. To exit display

mode press the INFO ‘ ’ key.

LIST OF DISPLAYED DATA

INFO CODE ICON DESCRIPTION

d0 DOMESTIC CIRCUIT PROBE TEMPERATURE

d1 EXTERNAL PROBE TEMPERATURE

d2 FAN SPEED

d3 BOTTOM AREA PROBE TEMPERATURE [IF AREA BOARD INSTALLED]

d4 RETURN PROBE TEMPERATURE

d5 SOLAR COLLECTOR TEMPERATURE [IF SOLAR BOARD INSTALLED] (SCS)

d6 SOLAR BOILER TEMPERATURE (BOTTOM) [IF SOLAR BOARD INSTALLED] (SBSI)

d7 SOLAR BOILER TEMPERATURE (TOP) [IF SOLAR BOARD INSTALLED] (SBSS)

d8 SOLAR COLLECTOR PROBE TEMPERATURE 2 [IF SOLAR BOARD INSTALLED] (SCS2)

d9 EXTRA SOLAR BOILER TEMPERATURE [IF SOLAR BOARD INSTALLED] (SBS3)

dA INERTIAL STORAGE SENSOR TEMPERATURE

dB LOW-TEMPERATURE HEATING CIRCUIT RETURN SENSOR TEMPERATURE (IN HYBRID SYSTEM BOX

MODE) - HEATING PUMP RETURN SENSOR TEMPERATURE (IN HYBRID DOMESTIC SYSTEM MODE)

dC HYBRID SYSTEM BOX D.H.W. TANK SENSOR TEMPERATURE - HOT WATER TEMPERATURE OUT OF

THE REMOTE TANK TO THE BOILER (ONLY FOR HYBRID DOMESTIC SYSTEM WITH OPTIONAL SENSOR)

dD POWER SUPPLIED BY THE HEATING PUMP IN KW/H (ONLY FOR HYBRID DOMESTIC SYSTEM)

dE HEATING FLOW RATE DISPLAY EXPRESSED IN L/MIN (IF THERE IS A FLOWMETER).

R1K 50 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS

3Accensione_Modalitàdifunzionamento_Antigelo_solorisc_MIAH4_MIAH6_EN

3. USE

USER

1.1.5. START-UP

Before starting the boiler make sure that it is

powered and that the gas tap below the boiler is

open.

To start the boiler press the function key ‘ ’ and

select the desired operating mode. If the symbol

is displayed fixed, it means that the function was

activated.

1.1.6. OPERATING MODE

ONLY HEATING MODE

In this mode the boiler meets only the demands of

heating.

To switch the boiler to ONLY HEATING operating

mode, press the function key ‘ ’, the symbol ‘

’ will appear fixed on the display, indicating that

the function is enabled.

Whenever heating energy is needed to heat the

rooms the automatic start-up system will start the

burner; this is indicated by displaying the symbol ‘

’ blinking.

ADJUSTING THE HEATING TEMPERATURE

You can adjust the temperature using keys ‘ ’ and

‘’ of the heating circuit :

· press key ‘ ’ to decrease the temperature.

· press key ‘ ’ to increase the temperature.

The heating temperature adjustment field ranges

from 30 °C to 80 °C (25 °C – 45 °C for floor systems).

OFF MODE

In this mode the boiler no longer meets the heating

demands, the anti-freeze and pump anti-locking

systems still remain active.

To switch the boiler to OFF operating mode, press

the function key ‘ ’, the symbol ‘ ’ will

appear fixed on the display, indicating that the

function is enabled (for non condensing models

will appear the message ‘OFF’).

If the boiler was previously running, it will be turned

off and the post-ventilation and post-circulation

functions will be enabled.

If you have to deactivate the boiler for a long period

of time, proceed as follows:

› contact the Technical support centre that will

empty the water system, where no anti-freeze is

intended, and will cut off the power, water and

gas supply.

› Or leave the boiler in OFF operating mode

keeping active the electrical and gas supplies so

that the anti-freeze function may activate.

R1K 50 RAIN - RAD - ING - Man.Ut. - 1901.1_firm.L224C_AHS

3Accensione_Modalitàdifunzionamento_Antigelo_solorisc_MIAH4_MIAH6_EN

3. USE

USER

1.1.7. INFORMATIONAL NOTE ON

ANTI-FREEZE FUNCTION

The boiler is protected against freezing thanks to

the electronic board preparation with functions

that start the burner and heat the concerned parts

when their temperature goes below the minimum

pre-set values.

WARNING

This function is available only if:

› the boiler is powered;

› the gas supply is open;

› the pressure of the system is proper;

› the boiler is not blocked.

Autres manuels pour R1K 50

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Radiant Chaudière

Radiant

Radiant R1K 100 RAIN Manuel

Radiant

Radiant R1K 50 Manuel utilisateur

Radiant

Radiant R2KA 28/20 Guide de démarrage rapide

Radiant

Radiant R2C 28 Manuel utilisateur

Radiant

Radiant RBS 20 E Manuel utilisateur

Radiant

Radiant Slim RBA CS 24 E Manuel

Radiant

Radiant R1K 75 Manuel utilisateur

Radiant

Radiant RKA 25 Manuel utilisateur

Radiant

Radiant RMAS 21 E Manuel

Radiant

Radiant RKA 34 Manuel utilisateur

Radiant

Radiant RSF 30 E Manuel

Radiant

Radiant RK 50 Manuel utilisateur

Radiant

Radiant R1BK 50 Manuel utilisateur

Radiant

Radiant R1K 75 Manuel

Radiant

Radiant R1KG 24 Manuel de service

Radiant

Radiant RSF 24 E Manuel

Radiant

Radiant RK 25 Manuel utilisateur

Radiant

Radiant RBS 20 E Manuel

Radiant

Radiant SF 16 E Manuel utilisateur

Radiant

Radiant RK 55 Manuel utilisateur

Radiant

Radiant RSF 30 E Manuel utilisateur

Radiant

Radiant Ekoflux RK 34/B Manuel utilisateur

Radiant

Radiant R2KA 24 /20 Manuel

Radiant

Radiant RMAS 21 E Manuel utilisateur

Manuels Chaudière populaires d'autres marques

Vaillant

Vaillant uniSTOR VIH SW GB 500 BES Manuel utilisateur

Radijator

Radijator BIO max 23.1 Manuel utilisateur

Brunner

Brunner BSV 20 Manuel utilisateur

Buderus

Buderus Logamax GB062-24 KDE H V2 Manuel utilisateur

Potterton

Potterton 50e Fiche technique

UTICA BOILERS

UTICA BOILERS TriFire Manuel utilisateur

Joannes

Joannes LADY Series Manuel

ECR International

ECR International UB90-125 Manuel d'instructions

Froling

Froling FHG Turbo 3000 Manuel utilisateur

Froling

Froling P4 Pellet 8 - 105 Manuel utilisateur

U.S. Boiler Company

U.S. Boiler Company K2 Manuel utilisateur

Henrad

Henrad C95 FF Manuel utilisateur

NeOvo

NeOvo EcoNox EF 36 Manuel utilisateur

Potterton

Potterton PROMAX SL 12 Manuel utilisateur

Eco Hometec

Eco Hometec EC 25 COMPACT Manuel utilisateur

Viessmann

Viessmann VITODENS 200 Mode d’emploi

Baxi

Baxi Prime 1.24 Manuel utilisateur

REXNOVA

REXNOVA ISA 20 BITHERMAL Manuel utilisateur