QuietFlo 30401 Manuel utilisateur

Programmable

HEPA Air Purifier

www.hunterfan.com

Model 30400 & 30401

41451-01 2

Table of Contents

Safety Instructions..................................................................................................3

Introduction ............................................................................................................3

Description of Air Filtration System

How theAir Purifier Works............................................................................4

Air Purifier Components ................................................................................4

Display and Control Keys ..............................................................................5

Operation

Initial Operation .............................................................................................6

Display Modes................................................................................................8

Manual and Auto Operating Modes ...............................................................9

Override ofAuto Mode ................................................................................10

Filter Run-time Counters..............................................................................11

Electrical Cord Storage ................................................................................11

Programming

Setting Day and Time ...................................................................................12

Pre-set Programming....................................................................................13

User Programming .......................................................................................14

Reviewing Programs ....................................................................................16

Locking/Unlocking the Keypad ...................................................................16

Resetting the Air Purifier .............................................................................17

Air Purifier Maintenance

Cleaning your Air Purifier............................................................................18

Changing the Pre-Filter ................................................................................18

Changing the Filter.......................................................................................19

Obtaining Replacement Filters.....................................................................20

Troubleshooting

Problems and Solutions ................................................................................21

Technical Support .........................................................................................21

Warranty Information .........................................................................................22

41451-01_Rev 8-6-04.pmd 8/5/04, 5:05 PM2

341451-01

SAFETY INSTRUCTIONS

IMPORTANT!

READALL INSTRUCTIONS BEFORE USING THIS AIR PURIFIER.

1. This air purifier is designed for use on a flat level floor and may not work properly on

an uneven floor. ALWAYS place the air purifier on a firm level floor. ALWAYS place

the air purifier at least six (6) inches away from walls and heat sources such as stoves,

radiators, or heaters.

2. Place the air purifier in an area that is out of the reach of children.

3. Before using the air purifier, extend the cord and inspect for any signs of damage. DO NOT

use the product if the cord has been damaged.

4. This product has a polarized plug (one blade is wider than the other) as a safety feature.

This plug will fit into a polarized outlet only one way. If the plug does not fit fully into the

outlet, reverse the plug. If the plug still does not fit, contact a qualified electrician. DO

NOT attempt to defeat or override this safety feature.

5. ALWAYS UNPLUG the air purifier when it is not in operation, while the filter is being

changed, and while it is being cleaned.

6. DO NOT move or tilt the air purifier while it is in operation. Turn off and unplug

before moving.

7. DO NOT immerse the air purifier in water at any time because permanent damage will

occur. To properly clean your air purifier, follow the instructions in the Maintenance section

of this manual (pg. 18).

READ AND SAVEALL INSTRUCTIONS.

Introduction

Thank you for purchasing the programmable

QuietFlo

HEPA Air Purifier from Hunter Fan

Company.You have purchased our latest development in portable air purification which has been

designed to improve the quality of the air that you breathe. The following innovative features are

included in your Hunter Air Purifier.

•High Particulate Efficiency: The HEPA filter will remove 99.97% of 0.3 micron particles

from the air that passes through the filter.

•Odor Removal: The activated carbon pre-filter helps remove odors such as cooking, smoke,

and pet smells from the air. It also traps lint, hair, and other large particles to help extend the

life and performance of the HEPA filter.

•Programmable: To help match your lifestyle, this air purifier can be programmed to automati-

cally adjust the blower speed 4 different times each day. You can choose to have the same pro-

grams for every dayoftheweekor youcanhave differentprogramsfor theweekdaysandthe weekend.

•Quiet: The air purifier has been designed to operate quietly and efficiently. You can choose

among three speeds to best meet your needs at different times.

•Filter Counters: Filter maintenance is critical to the performance of the air purifier. To help

you determine when to change the filters, the pre-filter and HEPA filter have built in run time

counters that keep track of how long each filter is in use.

41451-01_Rev 8-6-04.pmd 8/5/04, 5:05 PM3

41451-01 4

Description of Air Filtration System

How the

QuietFlo

HEPA Air Purifier System Works

As the air is pulled into the purifier, the activated carbon pre-filter absorbs odors and catches

large particles. Then, the air travels through the HEPA filter where the smaller particles are

collected. Finally, the clean purified air is released back into the room.

Air Purifier Components

The exploded view of the air purifier represents the various components for all air purifier

models.

Fig. 1 - Illustration of the Air Filtration System

Fig. 2 - Air Purifier Components

CONTROL

AREA

HEPA

FILTER

PRE-

FILTER

RECESS FOR

FINGERS TO

PULL OPEN

FRONT GRILL

FRONT

GRILL

Fig. 3 - Inside Surface

of Front Grill

GRILL

VENTS

HOOK

TAPE

TABS

HOOK

TAPE

541451-01

Description of Air Filtration System

41451-01 6

Operation

Initial Operation

This section provides basic instructions on the use of your air purifier.After following these

initial directions, please continue reading this booklet to learn how to operate the more

advanced features of your air purifier.

Basic Operation of the Air Purifier:

1. Take the air purifier out of the box and remove the clear plastic protective bag.

Place the unit on a firm level floor.

2. Before turning on the air purifier, you need to confirm that the filters are firmly

in place and have not become loose during shipping. To check the filters, first

open the front grill. For Models 30400 and 30401, release the front grill by plac-

ing your fingers behind the tabs and pulling forward. For all other models, gently

press the push tabs until the front grill slides pass them and is released. Refer to

Fig. 2 (pg. 4).

3. Next, check the HEPA filter by pressing firmly on all four corners of the filter to

ensure that it is fully inserted into the filter opening.

4. The carbon pre-filter is mounted inside the front grill with hook tape. Confirm

that it properly covers the grill vents.You may notice a few black particles com-

ing off the pre-filter. Those particles are part of the odor-removing activated car-

bon and will be collected on the filter during use.

5. Place the front grill back onto the unit. First, line up the tabs on the bottom of

the grill with the openings on the purifier base and then push the top of the

grill forward until it is closed. NOTE: This unit will not operate unless the

grill is in the correct position. The display will read “door” if the grill is not

attached properly.

6. Plug the unit into a 120V electrical outlet and press

the ON/OFF key. The air purifier will start with a low

blower speed.

7. Use the UP/DOWN keys to adjust the blower speed to

the desired level.

If this is the first time you have used the air purifier or if the air purifier has been without

power for over 12 hours, you will need to set the day and time. The day and time will flash

to indicate that it should be set.

Fig. 6

ON / OFF

41451-01_Rev 8-6-04.pmd 8/16/04, 3:16 PM6

741451-01

Operation

Adjusting Day and Time: (For example,Wednesday at 3:45 pm)

1. To set the day or time, press the DAY/TIME key. All

display features except the day and time will go blank

and the hour will flash.

2. Use the UP/DOWN keys to adjust the hour. Tapping

the key will advance the hour by increments of one.

Holding down the key will change the hour rapidly.

Note the AM/PM indicator as you cycle through a 24

hour period.

3. Press the DAY/TIME key again. Now, the minutes will

be flashing. Use the UP/DOWN keys to adjust the

minute. Tapping the key will change the minute by

increments of one and holding the key will change

the minute rapidly.

4. Press the DAY/TIME key to accept the minute setting

and go to the day of the week. Use the UP/DOWN keys

to set the current day.

5. Press the DAY/TIME key a final time to accept the day

setting and return to Normal mode.

Fig. 7

Fig. 8

Fig. 9

Fig. 10

DAY/ TIME

DAY/T

IME

DAY/ TIME

DAY/T

IME

41451-01_Rev 8-6-04.pmd 8/5/04, 5:05 PM7

41451-01 8

Operation

Display Modes

Your air purifier has 3 display modes – Clock Display, Pre-Filter Display, and Filter Dis-

play. When the unit is running, the display also provides additional information about the

settings of the air purifier. The features for each mode and how to change modes is de-

scribed below.

Clock Display: The default mode of the unit is the Clock Display.

In this mode, the day indicator, time, andAM/PM indicator will be

lit. If military time has been chosen (See Setting Day and Time, pg.

12), the AM/PM indicator will not be visible.

Pre-Filter Display: This display shows the number of hours that

the pre-filter has been in use. In addition to the run hours, you will

see the Pre-Filter indicator. If the run hours have reached 2000 hours

(approximately 3 months of use), the Pre-Filter indicator will flash

to show that the pre-filter should be changed. Refer to Filter Run-

Time Counters for additional information (pg. 11).

Filter Display: The Filter Display mode tells you how many hours

the filter has been in use. In addition to the run hours, you will see

the Filter indicator. If the run-hours have reached 8000 hours (ap-

proximately 1 year of use), the Filter indicator will flash to remind

you to check the filter. Refer to Filter Run-Time Counters for more

details (pg. 11).

Changing Display Mode:

1. To toggle from Clock Display to Pre-Filter Display to Filter Display, press the

DISPLAY key.

2. The DISPLAY key is active any time that the display is visible.

When the air purifier is turned on, the following features are also shown. If the unit is turned

off by the On/Off key, these features are not displayed.

•Speed Indicator to show blower setting (0, 1, 2, or 3).

•Animated Blower Wheel will rotate when blower is on.

•Control Mode is indicated by AUTO or MANUAL.

•The Current Program number is visible when the unit is in Auto Mode.

Fig. 11

Clock Display

Fig. 12

Pre-Filter Display

941451-01

Operation

Manual and Auto Operating Modes

Your Hunter Air Purifier has two distinct operating modes – Manual and Auto. The Manual

Mode allows you to override the control programs that have been set and to hold the settings

until you adjust them. In Manual Mode, the automatic programs are not active. You select

whether the unit is on or off and choose the blower speed. In Auto Mode, your air purifier is

capable of running 4 separate programs for the weekdays and an additional 4 programs for

the weekend. You can choose to have the same programs for every day or you can have

different programs for the weekdays and the weekend. The air purifier is pre-programmed

for all 7 days of the week as shown below. Refer to User Programming on pg. 14 for instruc-

tions on changing the programs.

Table 1: Pre-set Programming Provided for Each Air Purifier

To switch between Manual and Auto Modes:

1. To change operating modes, press the AUTO key. The

current operating mode will appear on the display (ei-

ther AUTO or MANUAL).

2. When changed to Auto Mode, the unit will automati-

cally adjust its controls to the appropriate program for

the day and time.When Manual Mode is active, the unit

will maintain current settings until you change them.

Program SetpointTime Blower Speed

18:00 am 2 (Medium)

23:00 pm 3 (High)

35:00 pm 2 (Medium)

410:00 pm 1 (Low)

AUTO

Fig. 14

Auto Mode

Fig. 15

Manual Mode

41451-01_Rev 8-6-04.pmd 8/5/04, 5:05 PM9

41451-01 10

Operation

Override of Auto Mode

You can use two different methods to override Auto Mode. If you choose temporary over-

ride, the air purifier will run at the temporary setting until the next scheduled program change.

Permanent override will remain in effect until you return the unit to auto mode.

Fig. 16

Fig. 17

AUTO

Temporary Override

•To temporarily override the settings:

1. While theAuto Mode is active, use the UP/DOWN

keys to adjust the blower speed. To temporarily turn

the blower off, turn the blower speed to 0. This will

allow the program to automatically continue at the

next scheduled program change.

2. The air purifier will automatically adjust to the new

setting. The current program number will flash to

signify the temporary override.

•To end the temporary override:

1. The temporary override will automatically end at

the next scheduled program change.

2. To immediately end the temporary override and re-

turn to the program, press theAUTO key twice. The

air purifier will return toAuto Mode and the sched-

uled program.

Permanent Override

•To begin permanent override:

1. Press theAUTO key to enter manual mode. On the

display, you will see the word MANUAL illumi-

nated. This indicates that the programs are no longer

active and the unit is in Manual Mode.

2. Use UP/DOWN keys to adjust the blower speed.

•To end the permanent override:

1. Press the AUTO key. The display will now show

the word AUTO.

2. The unit will automatically adjust its controls to the

appropriate program for the day and time.

41451-01_Rev 8-6-04.pmd 8/5/04, 5:05 PM10

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels QuietFlo Purificateur d'air

QuietFlo

QuietFlo 30085 Manuel utilisateur

Manuels Purificateur d'air populaires d'autres marques

IKEA

IKEA UPPÅTVIND Manuel utilisateur

Nash

Nash AP-1 PureSmart Manuel utilisateur

LG PH-U450 Series Manuel utilisateur

DeLonghi

DeLonghi DDSX 220WFA Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric MA-E85R-E Manuel utilisateur

Sharp

Sharp FU-40SE Manuel utilisateur

Philips

Philips AC2721 Manuel utilisateur

Hitachi

Hitachi EP-A3000 Manuel utilisateur

TruSens

TruSens Z-2000 Manuel utilisateur

Motorola

Motorola MBP87SN Manuel utilisateur

Beko

Beko ATP 7100I Manuel utilisateur

Carrier

Carrier INFINITY 1620 Manuel utilisateur

AtmosAir

AtmosAir P2002 Manuel utilisateur

Winix

Winix NK300 Manuel utilisateur

Friedrich

Friedrich C-90A Instructions d'utilisation et d'installation

Surgically Clean Air

Surgically Clean Air JADE2.0 Manuel utilisateur

Base aire

Base aire 555 Pro Manuel utilisateur

Champion

Champion CP25 Manuel utilisateur