Quatech PCD-B/PCI-E Manuel utilisateur

User's Manual

QUATECH, INC. TEL: (330) 655-9000

5675 Hudson Industrial Parkway FAX: (330) 655-9010

Hudson, Ohio 44236 http://www.quatech.com

WARRANTY INFORMATION

Quatech, Inc. warrants the PCD2-F(B) / PCI - E to be free of defects for

one (1) year from the date of purchase. Quatech, Inc. will repair or replace any board

that fails to perform under normal operating conditions and in accordance with the

procedures outlined in this document during the warranty period. Any damage that results

from improper installation, operation, or general misuse voids all warranty rights.

Please complete the following information and retain for your records. Have this

information available when requesting warranty service.

DATE OF PURCHASE:

MODEL NUMBER: PCD2-F / PCI - E or PCD-B/PCI-E

PRODUCT DESCRIPTION: PC Card Drive

SERIAL NUMBER:

1998 - 2002, Quatech, Inc.

NOTICE

The information contained in this document cannot be reproduced in any form

without the written consent of Quatech, Inc. Likewise, any software programs that might

accompany this document can be used only in accordance with any license agreement(s)

between the purchaser and Quatech, Inc. Quatech Inc. reserves the right to change this

documentation or the product to which it refers at any time and without notice.

The authors have taken due care in the preparation of this document and every

attempt has been made to ensure its accuracy and completeness. In no event will Quatech,

Inc. be liable for damages of any kind, incidental or consequential, in regard to or arising out

of the performance or form of the materials presented in this document or any software

programs that might accompany this document.

Quatech, Inc. encourages feedback about this document. Please send any written

comments to the Technical Support department at the address listed on the cover page of

this document.

Windows ME, Windows 2000, Windows 98, Windows 95, Windows NT are trademarks or registered

trademarks of Microsoft Corporation. OS/2 is a registered trademark of IBM Corporation. All other

trademarks or registered trademarks are property of their respective owners.

Declaration of Conformity

Manufacturer's Name: Quatech Inc.

Manufacturer's Address: 5675 Hudson Industrial Parkway

Hudson, Ohio 44236 (USA)

Application of Council Directive: 89/336/EEC

Standards to which

Conformity is Declared: * EN50081-1 (EN55022,

EN60555-2, EN60555-3)

* EN50082-1 (IEC 801-2,

IEC 801-3, & IEC 801-4)

Type of Equipment: Information Technology

Equipment

Equipment Class: Commercial, Residential, & Light

Industrial

Product Name: PCD2-F / PCI - E or PCD-B/PCI-E

Model Number : PCD2-F / PCI - E or PCD-B/PCI-E

Table of Contents

2Troubleshooting ......................................................

1.1 (Win 9x, WinNT4, Win 2000, Win XP)

........................................1

1PCI Card Drive Installation .....................................

1PCI Card Drive Installation

1.1(Win 9x, WinNT4, Win 2000, Win XP)

Install the supplied driver disk BEFORE installing your Card Drive in the PC

The Card Drive WILL NOT work unless you install the Quatech driver CD !

PCI Card Drives are designed to be fully Plug-n-Play.

1. Install the supplied Quatech COM CD. Do this by selecting

Start-Run…D: Quatech_Comm_173\PC Card Drive\Drivers\PCI Drives\PSeries.exe

2. When setup is finished, shut down the PC.

3. Power off the PC, remover the lid, and plug the Card Drive into a

Free PCI Slot. For the PCD2-F/PCI-E, mount the socket assembly into a 3.5” drive

bay.

4. Power up the PC. Wait for it to boot.

5. As Windows starts, you will see the “New Hardware Found” and “Building

driver database” messages (not NT4).

6. Follow any instructions exactly as prompted.

7. You might need another reboot to get Window to fully configure

The Card Drive.

Test the installation by clicking on the PC-Card Icon in the Control Panel.

You should see the PC-Card sockets. Your Card Drive is Now ready to use

Quatech PCD2-F / PCI - EUser's Manual 1

2Troubleshooting

1. Are you sure you have installed the drivers?

Make sure you install them on every “profile” that you have set up.

If you install a “Service Pack”, be sure to install the drivers again

(Windows Service Packs might replace some of our drivers.)’

2. Try moving the Card Drive to a different PCI slot (some slots share

IRQs with unfriendly on-board peripherals). Try all combinations.

Also test the PCI slot with another PCI board like a network adapter… there are

some motherboard/Windows combinations that do not work very well !

3. In Win9x, when you insert a card it can take Windows 30-60s to

configure it ! Be Patient.

4. If in Win9x your card is not recognized (just a dash is shown by the

Slot in the PC-Card Properties screen), try turning off “Automatic

selection” in the “Global Settings” tab, and put a Start address of

“d0000”, and an End address of “df000”, then re-start the PC.

5. If when you plug in your card, Windows prompts that it needs to

restart, you have probably run out of free IRQs. Try disabling or

removing unused devices. Also Check the BIOS to make sure that all

known available IRQs are set to Plug-n-Play in the BIOS (i.e. not set to

“Reserved for use by ISA board”).

6. If all else fails, note the following BEFORE calling for support:

Windows version, motherboard type (chipset & processor), resources

used by the Card Drive & PC-Card.

Quatech PCD2-F / PCI - EUser's Manual 2

PCD2-F / PCI - E & PCD2-B/PCI-E

User's Manual

Revision 1.11

July 2004

P/N: 940-0181-111

Quatech PCD2-F(B) / PCI - EUser's Manual 3

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Quatech Adaptateur

Quatech

Quatech DSP-200/300 Manuel utilisateur

Quatech

Quatech PCD-X/U132-E Manuel utilisateur

Quatech

Quatech MPAP-200 Manuel utilisateur

Quatech

Quatech DSC-100 Manuel utilisateur

Quatech

Quatech ABDG-ET-DP501 Manuel utilisateur

Quatech

Quatech Asynchronous Communications Adapter for PCI bus... Manuel utilisateur

Quatech

Quatech DSU2-100 Manuel utilisateur

Quatech

Quatech SS-BLT-100 Manuel utilisateur

Quatech

Quatech SSU2-100 Manuel utilisateur

Quatech

Quatech SSP-100 Manuel utilisateur

Quatech

Quatech Asynchronous Communications Adapter... Manuel utilisateur

Quatech

Quatech SPPXP-100 Manuel utilisateur

Quatech

Quatech SS-BLT-100 Manuel utilisateur

Quatech

Quatech DSCLP-200 Manuel utilisateur

Quatech

Quatech DSU2-100 Manuel utilisateur

Quatech

Quatech QSP-100 Manuel utilisateur

Quatech

Quatech RS-485 Manuel utilisateur

Quatech

Quatech MPAC-100 Manuel utilisateur

Quatech

Quatech HS-PCI-100 Manuel utilisateur

Quatech

Quatech DSC-300 Manuel utilisateur

Quatech

Quatech ESU-100-EMB Manuel utilisateur

Quatech

Quatech SS-USB-100 Manuel utilisateur

Quatech

Quatech SSP-200 Manuel utilisateur

Quatech

Quatech DSC-100 Manuel utilisateur

Manuels Adaptateur populaires d'autres marques

PCB Piezotronics

PCB Piezotronics 090B274 Manuel utilisateur

Auvidea

Auvidea J20 Manuel du produit

Gossen MetraWatt

Gossen MetraWatt AT3-III E Manuel utilisateur

Akribis

Akribis ITF-21-BISS-MIT Manuel utilisateur

Tenda

Tenda W54U Manuel utilisateur

ROHO

ROHO AGILITY Manuel utilisateur

PROLiNK

PROLiNK WN2001 Manuel utilisateur

Hawking

Hawking HUF2 Manuel utilisateur

Airlink101

Airlink101 AWLC4030 Manuel utilisateur

NETGEAR

NETGEAR XAV101v1 - Powerline AV Ethernet Adapter Manuel utilisateur

Philips

Philips SWA4554S/10 Manuel utilisateur

JVC

JVC TS-C9D2B Manuel d'instructions

NETGEAR

NETGEAR A6100 Manuel utilisateur

D-Link

D-Link DWA-121 Manuel utilisateur

Philips

Philips SWA2037 Manuel utilisateur

Basalte

Basalte 0610-20 Manuel utilisateur

Yealink

Yealink EHS40 Manuel utilisateur

Balluff

Balluff BIC 1B0-IT1A7-Q40KFU-SM4A4A Manuel utilisateur