PuraShield PURABREEZE Manuel utilisateur
INSTRUCTION MANUAL
Model: PURABREEZE
Keep these instructions for future reference
Thank you for purchasing the innovative PuraBreeze air purifier. We wish you many years of
healthy indoor air with this efficient and effective product.
Please ensure that all safety precautions are followed when using this air purifier for the proper
operation of the device. These instructions describe the safety precautions to be observed
during operation. They are designed to prevent injuries or damage to this device.
SAFETY PRECAUTIONS:
1. Our air purifier is designed for 120V, 60Hz electrical connections.
2. Cleaning the unit while it is plugged in may result in electric shock, electric spark, and
serious injury. Unplug the unit before cleaning or performing maintenance.
3. This air purifier contains a UV-C emitter.
4. Unintended use of the air purifier or damage to the housing may result in the escape of
dangerous UV-C radiation. UV-C radiation may cause harm to the eyes and skin even in
small levels of direct exposure.
5. Air purifiers that are obviously damaged must not be operated.
6. Depending on the room conditions, the device needs to be cleaned of dust every 2-4
weeks to maintain peak performance. Before cleaning, unplug the device, open the back
cover, remove the filter, wipe the interior of the device with a wet towel.
7. If the UV light is damaged, it must be replaced by the manufactures, its service agent, or
similarly qualified persons to avoid a hazard.
WARNING: To reduce the risk of fire, electric shock, or injury, read and understand this user
manual before operating this air purifier.
1. The air purifier is not to be used by persons (including children) with reduced physical,
sensory, or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction. Children should not be allowed to operate the air
purifier without supervision.
2. This air purifier can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the air purifier in a safe
way and understand the hazards involved.
3. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or
similarly qualified persons to avoid a hazard.
4. Do not operate unit if cord or plug is damaged. Doing so can result in electric shock. Discard
the damaged unite or take if to an authorized service facility for examination and /or repair.
5. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. DO NOT ROUTE CORD UNDER FURNITURE OR AIR PURIFIER. Arrange cord
away from traffic areas and where it will not be tripped over.
6. Only use the air purifier as described in this manual.
7. Do not handle the unit with wet hands. Thoroughly dry your hands before handling any part
of the air purifier.
2
8. Hair, loose clothing, and body parts can get caught in the air purifier resulting in injury. Keep
hair, loose clothing, and body parts away from openings and moving parts.
9. Do not unplug by pulling on the cord. Doing so may result in electrical spark or fire, unplug
the unit by grasping and pulling the plug.
10. Do not use an extension cord.
11. Do not place the air purifier near sources of heat, such as: stove tops, ovens, radiators, or
computers.
12. Unplug the air purifier from the power supply before servicing.
13. This equipment should be inspected frequently and the dust that has collected should be
removed regularly to prevent excessive accumulation that may result in a fire.
14. Do not use the air purifier outdoors or on wet surfaces.
15. Do not use the air purifier in an enclosed space where flammable, combustible or explosive
gases are present.
16. Do not use in an area where toxic vapors, flammable dust or oxygen tanks are present.
Check the location and make sure these elements are not present.
17. Do not place open flames, including candles, directly in front of the air purifier.
18. It is important to keep all objects away from the air intake grille.
19. Place the air purifier on a flat, solid, stable surface. Never place the unit on soft surfaces
such as a bed or sofa.
20. Position the air purifier so that the contaminated air is not drawn across your head or body
while sitting or sleeping.
21. Place the air purifier so the plug on the power cord easily reaches a standard electrical
outlet for a polarized plug.
22. Children should be supervised when product is in use. Do not allow children to play on or
near the air purifier. Keep children’s hair, loose clothing, and body parts away from the
intake grille and openings.
23. This product is suitable for use with solid-state speed controls.
PRODUCT DIAGRAM:
3
FEATURES AND OPERATION:
Instructions for usage
Power: When plugged in, display will be on for 1 second and a beep sound will be heard.
The "OFF" character will be shown and "WIFI" icon will flash (it will always be on after
connecting to the App in mobile phone), then the air purifier keep in standby state.
When you touch the “Power” button, the PuraBreeze starts up and the air quality indicator
on the screen alternates between green, blue, yellow and red. Display shows "A" to indicate the
air purifier is working in Auto Mode with medium speed for 5 seconds. Then the “A” changes to
flashing “000”. 10 seconds later, it begins to show air quality data in real-time. Air quality
indicator shows air quality in the corresponding color and air purifier will adjust the speed
according to the air quality automatically.
Auto Mode Chart
Color
Air Quality
PM2.5 Data
Fan Speed
Red Bad ＞115 High
Yellow
Moderate
115~76
Medium
Blue
Good
75~36
Low
Green
Very Good
＜
36
Lower
4
Speed: Touch "Speed" button air purifier will exit the Auto Mode.
This cycles through fan speeds: low speed, medium speed and high speed.
The fan speed cannot be changed during Auto or Sleep modes.
Timer: Touch "Timer" button and “--H” icon will flash on the display. Touch the button
continually to set the timer from 1~12 hours, after choosing desired timer, the display will stop
flashing and switch to show the PM2.5 data, to indicate the setting is done. It calculates by
counting down every hour. When the time is up, the air purifier will shut down.
Touch the button till icon “--H” or long press the button for 2 seconds to cancel the timer setting.
UV: Touch "UV" button to turn on the UV function with the icon shown. Touch again
then turn off the UV function.
Sleep: Touch the "Sleep" button and the air purifier will enter Sleep Mode. Sleep Mode
uses the lowest possible fan speed (even lower than Auto Mode) to create a quite environment.
The display will show the icon with 1\3 brightness. The air purifier will operate at the
lowest speed. Touch any button to illume the display in 1\3 brightness, then you can operate
other functions. If 15 seconds pass without any operation, the display will show the icon
with 1\3 brightness only again. Touch again to turn back to Auto Mode.
Display turn off function: Long press the “Sleep” button for 2 seconds to turn off the
display. Touch any button to illuminate the display in 1\3 brightness, and then press it to operate
other functions. If 15 seconds pass without any operation the display turns off again. Long press
this button to exit this mode.
FILTER CHANGE
When the PuraBreeze has run for 3000 hours*, the filter change indicator icon in the
display will flash red to remind the user to change the filter. After the filter is changed, in standby
mode, touch the “Speed” button 2 times, then hold this button for 2 seconds and the filter
change indicator icon will flash quickly. 5 seconds later the whole display will flash for a
second and then turn off to enter in standby mode. It means filter change is finished. Touch the
"Power" button to switch on the air purifier.
*Note: 3000 hours is calculated based on low speed.
5
Safety
The air purifier has a safety function. When the filter cover is removed or not installed correctly,
the air purifier will automatic cut off.
REMOTE CONTROLLER SYNC
In standby mode, touch the “UV” button 2 times, then long press for about 2 seconds. The
screen will show “A1”. In that case, long press the “Speed” button on the remote controller
for about 2 seconds to match the code until the screen shows “A2”, then the display change to
standby mode. That means the remote synced successfully. And the remote is ready for use. (If
the sync failed, it will still show "A1", repeat above steps to match again.)
REMOTE CONTROL UNSYNC:
In standby mode, touch the “UV” button 2 times, then long press button for about 2
seconds until the screen show “A1”. Then long press again till “A0” shows on the display. That
means the remote is unsynced successfully. Remote controller is removed.
WIFI OPERATION INSTRUCTION:
1. Download “Tuya Smart” from App store. After installing, register by E-mail or mobile number,
and then follow below steps.
2. Long press the “Power” button for about 3 seconds (or long press for about 6 seconds to
enter AP mode), display shows the WIFI icon and keeps blinking. It means the air purifier
has entered the network state successfully. (If you long press this button for about 10 seconds,
the air purifier will exit the connection with the mobile APP).
3. Open the App and add the corresponding device and then follow the operation in the app.
4. When the App is connected to the air purifier successfully, the WIFI icon on the screen
will be on, and then the App can control the air purifier.
6
MAINTENANCE:
After continuous use, dust build up on the sensor will affect its sensitivity. We suggest cleaning
it every two months depending on your indoor environment.
HOW TO CLEAN THE DUST SENSOR:
Unplug the unit, then open the dust sensor cover. Dip a cotton swab in clean water. Clean the
lens with cotton swab. Then wipe the lens with a dry cotton swab to help dry it off.
TROUBLESHOOTING:
If your PuraBreeze is not working correctly, please check the following causes:
Trouble Possible reasons Possible Solution
No power Fault in power
source
Check that the power cord is
inserted properly
Not working
Plug not connected
or fault in electric
circuit.
Insert the plug in a different
power outlet.
Unusual noise
There is foreign
body in the air
purifier
Take to service center.
Dirty filter Replace the filter
Remote controller not
working
Battery may be
dead
Change battery
7
TECHNICAL SPECIFICATIONS:
1. Input voltage: AC 120V
2. Frequency: 60Hz
3. Power Consumption: 50W
4. Applicable area: 57m²
5. Noise level: ≤60dB
6. CADR: 288CFM (490m³/H)
7. Remote control distance: ≤10m
8. Temperature Range: 10℃~45℃
9. Humidity: ≤95%RH
WARRANTY AND SERVICE:
WE GUARANTEE THE UNIT TO BE FREE FROM DEFECTS IN MATERIAL OR
WORKMANSHIP FOR A PERIOD OF ONE (1) YEAR FROM THE DATE OF PURCHASE.
Should this unit be operated under conditions other than those recommended or at voltages
other than the voltage indicated on the unit, or any attempts to service or modify the unit in an
unauthorized fashion, will render the WARRANTY VOID. The product you receive may
sometimes differ slightly from illustration.
Visit https://purashield.com/pages/purashield-registration to register your device.
DISPOSAL: Do not dispose this product as unsorted municipal waste. This should be
recycled appropriately.
Contact
Website: https://purashield.com/
Phone: (866) 222-3040
8
Table des matières
