Prorack K530 Manuel utilisateur

FittingKit

K530

Fitting Instructions for Basic Carrier

Instrucciones de montaje para el

sistema de transporte.

Instructions de montage pour Basic

Carrier

x 2

x 4

Revision No:

FittingKit

K530

MAX kgs (lbs)

W/P

WHD

Subaru

Impreza , 4dr Sedan 01- 07

50 kgs (110 lbs)

Impreza , 4dr Sedan 01- 07

50 kgs (110 lbs)

Impreza , 4dr Sedan 01- 07

50 kgs (110 lbs)

Impreza , 4dr Sedan 01- 07

50 kgs (110 lbs)

Impreza , 4dr Sedan 01- 07

50 kgs (110 lbs)

FittingKit

K530

First Time Installation

Remove parts from inside the package and

check. Contact your dealer if any parts are

missing or damaged.

This kit fits type A, B, C and D.

These instructions show type A crossbar

fitted. They also apply to type B, C and D.

NOTE: Clamp images in these instructions may

not be representative of the clamps in this kit

FittingKit

K530

Use keys to remove covers.

Use hex screwdriver to reverse adjusting

screw 10 turns.

Press adjusting screw and pull crossbar legs

out. Refer to the crossbar instructions for

crossbar adjustment.

Ensure each end of the crossbar is adjusted

equally.

FittingKit

K530

Remove locking screw.

Apply protective strip as shown.

Trim if required.

It is important to put the clamps in the correct

position on the vehicle.

Letters refer to the part numbers stamped on

clamps.

Clamp Part Number:

A = 849A

B = 850A

FittingKit

K530

Attach clamp to each leg. NOTE; clamps

may have labels showing their positions on

the vehicle (For example; "Front Right").

Refit locking screw so that it goes through

the hole in the clamp. Do not begin to tighten

the locking screw.

Fit rubber pad (supplied with crossbar) to foot.

FittingKit

K530

Make sure the pad fits into the holes

underneath the foot.

Fitment

Place crossbar on vehicle. Minimum

recommended spacing between the bars is

700mm (27 1/2") (unless otherwise stated).

Please check the rear of this manual for

information relating specifically to your

vehicle.

Clamps over body trim.

Press adjusting screw to adjust the leg

positions on the crossbar.

FittingKit

K530

Tighten adjusting screw to 5 Nm (3.7 ft lb).

Tighten locking screw on both legs evenly.

Check crossbar is securely attached to the

vehicle.

FittingKit

K530

Use keys to fit and lock covers

CAUTION: Recheck all fasteners immediately

after a load is applied to the crossbars.

Regularly check screws are tight.

FittingKit

K530

Clean the car roof and surfaces of the

product that will be in contact with the car

roof.

Follow the fitting instructions for fitting the

product to your vehicle. Make sure all steps

are carried out in order.

Set crossbars a minimum distance of 700mm

(27 1/2") apart where no other distance is

specified in the fitting instructions. This is

especially important when carrying long

loads.

Check unit is securely attached whenever

you refit it to the vehicle. If the unit feels

loose, refer to the fitting instructions and

readjust.

Some glass/panoramic roofs and radio

antennae may not be able to be used when

the product is fitted.

Do not modify this product.

Refer to the maximum permitted load

capacity specified in the fitting instructions.

Do not exceed the vehicle manufacturers

roof load rating if it is lower than the

maximum load capacity specified in the fitting

instructions.

Loads should not overhang the sides of the

product and be evenly distributed with the

lowest possible centre of gravity.

Long loads should be secured with non-

elastic straps to the front and rear of the

vehicle.

Objects with pointed ends (e.g. ski poles)

should be carried with the pointed ends to

the rear of the vehicle.

Remove all loose or removable objects from

the load prior to loading.

Make sure all loads are securely fastened

with non-elastic straps. Check regularly

during longer journeys.

Table des matières

Langues :

Autres manuels Prorack Accessoires automobiles

Prorack

Prorack K544 Manuel utilisateur

Prorack

Prorack K162 Manuel utilisateur

Prorack

Prorack K868 Manuel utilisateur

Prorack

Prorack K376 Manuel utilisateur

Prorack

Prorack K431 Manuel utilisateur

Prorack

Prorack K439 Manuel d'utilisation et d'installation

Prorack

Prorack K730 Manuel utilisateur

Prorack

Prorack K157 Manuel utilisateur

Prorack

Prorack K432 Manuel utilisateur

Prorack

Prorack K707 Manuel utilisateur

Prorack

Prorack K820 Manuel utilisateur

Prorack

Prorack K462 Manuel utilisateur

Prorack

Prorack K949 Manuel utilisateur

Prorack

Prorack K366 Manuel utilisateur

Prorack

Prorack K853 Manuel d'utilisation et d'installation

Prorack

Prorack K1153 Manuel utilisateur

Prorack

Prorack K786 Manuel utilisateur

Prorack

Prorack K674 Manuel utilisateur

Prorack

Prorack K304 Manuel utilisateur

Prorack

Prorack K762 Manuel utilisateur

Prorack

Prorack K776 Manuel d'utilisation et d'installation

Prorack

Prorack K1020 Manuel utilisateur

Prorack

Prorack K867 Manuel utilisateur

Prorack

Prorack K570 Manuel utilisateur

Manuels Accessoires automobiles populaires d'autres marques

James Baroud

James Baroud Odyssey Manuel utilisateur

Motorola

Motorola i50sx Manuel utilisateur

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manuel utilisateur

Feniex

Feniex T3 Manuel utilisateur

Renault

Renault 77 11 423 180 Manuel utilisateur

Kia

Kia E8300-4D000 Manuel utilisateur

Brink

Brink 756843 Manuel utilisateur

Whispbar

Whispbar K085W Manuel utilisateur

v.link

v.link CI-VL2-PC-HSD Manuel utilisateur

Viking

Viking Stack-Rack Guide de configuration rapide

Aries

Aries 203015 Manuel utilisateur

Choetech

Choetech AT0005 Manuel utilisateur

ZZ2

ZZ2 ZZAIR-PRO Manuel utilisateur

Holman

Holman 4A80L Manuel utilisateur

Thule

Thule 2075 Manuel utilisateur

Motorola

Motorola T325 Manuel utilisateur

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guide d'installation

DV8

DV8 FBJL-02 Manuel utilisateur