14 15
5.4 Curtains & Soft Furnishings
Steam curtains from the face side.
If curtains are interlined, it may be necessary to steam lining as well.
If using optional Drapery Kit, it will be necessary to change to standard
drapers hose when working at heights of less than 2m, otherwise
a large amount of condensation will build up in the hose and cause
reduced performance.
When steaming, periodically lift the hose so excess condensation can
run back into the boiler.
Ideal for use on bed valances, chair covers, banqueting table cloths
and removing pressure marks on carpets.
creases.
5.5 Fabric Limitations
• Seersucker
• Silk taffeta
If in doubt, test on a small inconspicuous area or steam from reverse
side of fabric.
Extreme caution should be used with man-made pile fabrics to
avoid shading – keep nozzle at least 10cm away from face or reverse,
allowing steam to penetrate and use Propress velvet brush to maintain
the pile.
Cotton and silk velvet can be steamed by lightly running the nozzle
over the pile. In the event of a condensation spot on fabric, gently rub
the back of the nozzle over the area. It should dry without leaving a
water mark.
5. TIPS ON USE (CONTINUED) 6. CARE AND MAINTENANCE
To ensure a long and trouble free life of your steamer it is essential that
of sediment and limescale. Descale regularly to ensure no unnecessary
on the heating element if not maintained properly; this will cause reduced
performance, irreparable damage to the element and void your warranty.
6.2 Cleaning your Steamer
Disconnect from the power supply.
Remove steam hose and pole assembly.
Steamer must be disconnected from the power supply.
The water in the steamer must be allowed to cool to a
temperature which will not cause injury before emptying.
NOTE: The steamer should be emptied through the steam outlet (not the
ller inlet) into a ground level drain where possible to avoid raising the
steamer up and emptying into a sink.
Start by emptying any residue water from the steamer.
fresh water and empty again, repeat procedure until the water runs clear.
Clean the outside of the steamer with a damp cloth. Do not use any
detergents or polish.
It is recommended the steamer be descaled using a non-aggressive descaler
at least every 2 months. Descaling frequency is dependent upon usage and
water hardness.
For details on suitable descalers, please contact Propress. We recommend
the use of Propress Descaler which can be purchased by calling Propress on
020 8417 0660 or visiting propress.co.uk.
