A1 AirTTL
4
www.profoto.com
General safety instructions
Safety Precautions!
Do not operate the equipment before studying the instruction manual and the accompanying safety.
Make sure that Profoto Safety Instructions is always accompanied the equipment! Profoto products
are intended for indoor conditions use.Do not place oruse the equipment where it can be exposed to
moisture,extreme electromagnetic fields,orin areaswith flammable gases or dust! Do not expose the
equipmenttodripping or splashing.Donot place anyobjectsfilledwithliquids,suchasvases,onornear
theequipment.Donotexposetheequipmentto hastytemperaturechanges inhumid conditionsasthis
could lead to condensation water in the unit.Do not connect this equipment to flash equipmentfrom
other brands.Front lens shall be changed if it has become visiblydamaged to such an extent that their
effectivenessisimpaired,forexamplebycracksordeep scratches. Equipmentmustonly beserviced,
modified or repaired by authorized and competent service personnel
WARNING – Electrical Shock Hazard – High Voltage!
Donot openordisassemble flashes,generatorsorlamp heads! Equipmentoperateswithhighvoltage.
Generatorcapacitors are electrically charged for a considerable length of time after being turned off.
Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as direct
sunlight,fire, orthe like.
Caution – Burn Hazard – Hot Parts!
If front lens cracks,it must be replaced before re-use of the equipment.Do not touchfront lens during
operation it mayreach high temperature.
Note about RF!
This equipment makes use of the radio spectrum and emits radio frequency energy. Proper care
should be taken when the device is integrated in systems.Make sure that all specifications within this
documentarefollowed,especiallythose concerningoperating temperatureandsupplyvoltagerange.
Make sure the device is operated according to local regulations.The frequencyspectrum this device
is using is shared with otherusers.Interference cannot be ruled out.
Laser radiation
IEC 60825-1,Edition 2.0 (2007-03).Wavelength at room temperature: 660 nm.Power through 7 mm
apertureat100mm distanceinfrontoftheexitwindowoftheautofocusassistunit atroomtemperature:
< 300 µW. Complies with 21 CFR 1040.10 and 1040.11 except fordeviations pursuant to Laser Notice
No.50,date June 24,2007.
Caution: Do not remove,disassemble or manipulate the laserauto focus assist light. Failure to comply
with this caution might lead to possible exposure to hazardous laser radiation.
Final Disposal
Equipment contains electrical and electronic components that could be harmful to the environment.
Equipment may be returned to Profoto distributors free of charge for recycling according to WEEE.
Followlocallegalrequirementsforseparatedisposalofwaste,forinstanceWEEEdirectiveforelectrical
and electronic equipment on the European market,when product life has ended!
CLASS 1
LASER PRODUCT
