Onyx 90 Media Cutter
The World’s Best Media Cutter 828-707-5848
thebracket hardware package,mountthe top hangingbracket in allthreeplaces.
8. Measure 29 1/4” down from the bottom of the top hanging bracket and place a
mark on the vertical line.
9. Place the top of the bottom hanging bracket on that measurement line – the one you
just marked at 29 1/4”.
10. Using the bottom hanging bracket as a template, center the two holes in the bottom
hanging bracket over the vertical line.
11. Trace the two holes with a pencil.
12. Remove the bottom hanging bracket / template, and drill the two 1/8” pilot holes.
13. Place the bottom hanging bracket over the holes and using the screws and washers
from the bracket hardware package, mount the bottom hanging bracket to the wall.
14. Check to verify that the top and bottom hanging brackets are in line with each other
and plumb.
4.5.2 MountingtheVerticalAxisExtrusion
1. Placethevertical axis extrusionwiththe two flanges onthetop bracket andinsertthe
safety screwand nut.The screwis ¼-20X 1½” long.
2. Liftandsituatetheverticalaxisextrusionsothat
theflangesonthebackoftheverticalaxisextru
sion straddlethe top and bottom brackets.
3. Lightlytightenthefivescrewsontheverticalaxis
extrusion.Therewill beafurtheradjustmentlater.
4. Retrievethe left horizontal extrusion – it is marked.
5. Attachthelefthorizontalextrusiontotheleftmounting
bracket.Left andrighthorizontalmountingbracketsare identical.
6. Placethelefthorizontal extrusion onto theverticalaxisextrusion. Use two ¼-20 X
2”hex head screws, washersandlocking nuts tomaketheattachment.
7. Attachtheleftstainlesssteelgussetplatetothelefthorizontalextrusionandthe
verticalaxisextrusionusingthenine#4x40flatheadstainlesssteelscrewsandnuts.
8. Attachthelefthorizontalmounting bracket to thewall.Makesurethebracket is
perpendicularto thewall.
9. Placetherighthorizontalextrusion onto the verticalaxisextrusion. Usetwo¼-20X
2”hexheadscrews, washers and lockingnutstomake the attachment.
10. Attach therightstainlesssteelgusset plate to the righthorizontalextrusionandthe
verticalaxis extrusion using nine #4 x 40 flatheadstainlesssteelscrewsandnuts.
11. Attachtherighthorizontalextrusionwallmountingbrackettothewall.Again,make
surethe bracket is perpendiculartothe wall.
Page number 7
