Pro-4 Tactical Tactical Survival Set Manuel utilisateur
INSTRUCTIONS
Flashlight - COB Lantern, 13-in-1 Multi-Tool Pliers,
Portable Lantern, Molle Gear Pack
Tactical Survival Set
• Flashlight - COB Lantern
• Installing 3 AAA alkaline
batteries
• Striker head
• Zoom In / Out
• Exposing lantern modes
• Turning On / O
Switching Modes
• 13-in-1 Multi-Tool Pliers
• Pliers, tools and storage
• Auto-Locking tool
14+
AGES
QR CODE
Designed, Imported,
and Distributed by:
Pro-4 Marketing LLC
32411 Industrial Drive
Madison Heights, MI 48071
Tel: 248-809-2129
Toll Free: 1-833-776-3687
www.Pro-4Tactical.com
Instruction Manual
• Portable lantern
• Installing 3 AA alkaline
batteries
• On / O instructions
• Magnetic base
• Retractable hanging hook
and handles
• Built-In compass
• Molle gear pack
• Front pockets
• Molle webbing straps
• Inside pockets
WARNING: This product can expose you to chemicals including Benzene and Ethylbenzene which are known to the State
of California to cause cancer. For more information, go to www.p65Warnings.ca.gov
Troubleshooting
Maintenance
Warning
Zoom In / Out
Installing 3 AAA Alkaline Batteries
• Remove and store batteries when not in use for 90 days or longer
• Clean Flashlight with a clean, dry cloth as needed.
• Lubricate screw threads and moving parts with standard consumer
lubricant as needed
• High Intensity Beam. Extremely bright 300 lumen light
• Do not look directly into light; may cause vision damage
• Follow City Ordinance Guidelines for use &
proper disposal of dry cell batteries
• Recommended for Ages 14+
• Remove and replace batteries
• Be sure tail cap is screwed on tightly, and batteries are inserted properly in battery pack
• Be sure battery pack is properly inserted
• If problem persists, contact Pro-4 Tactical for technical advice
• See www.Pro-4Tactical.com for Warranty and Replacement Information
Zoom In
For a long, narrow, focused light beam:
Pull OUT Flashlight head as shown
Zoom Out
For a broader light beam: Push IN
Flashlight head as shown
1
2
Unscrew tail
cap. Remove
battery pack
Insert battery pack into
ashlight as shown
below. Replace tail cap
Insert 3 AAA batteries according
to polarity (+/-) as indicated on
battery pack
1
2
3
FRESH ALKALINE BATTERIES RECOMMENDED. DO NOT MIX OLD AND NEW, OR DIFFERENT TYPES OF BATTERIES
If the Flashlight does not turn on; works intermittently; or has a weak light:
FLASHLIGHT - COB LANTERN
When using “COB Lantern” mode or “Red Flashing” mode,
extend the Flashlight head to fully expose the COB Lantern.
Exposing Lantern Modes
Striker Head surrounds the ashlight lens. It is capable
of breaking or cracking ice, glass or similar items by
forcefully tapping the edge of striker head against the item
you wish to break.
CAUTION:
Do not use on vehicle windshields, windows or
any other surfaces you do not intend to break.
Unintended scratches can appear by
accident. Wipe down the striker head
with a wet or dry cloth after use to
ensure debris is removed.
Striker Head
1
2
5 LIGHT MODES:
High Power Light
COB Lantern
Low Power Light
Red Flashing
Strobe
1
2
3
4
5
To cycle through light modes (without turning
the ashlight o), press button in halfway. The
button will not click, and the light will advance
to the next mode.
Firmly press the ON / OFF button. You will hear a
“click,” and the light will turn ON. Firmly press again,
and the ashlight will turn OFF.
Note: The next time the button is pressed, the light
will advance to the next mode.
Turning
ON / OFF
Switching
Modes
CLICK
Pliers, Tools and Storage
Stainless steel construction houses multiple fold-away tools in Plier handles. Remove 13-In-1 Multi-Tool from Nylon carry
case; unfold handles. Pliers and Wire Cutter/Stripper are now usable. Tools have auto-locking feature in both handles
To use all other tools, unfold desired tool from Plier handle.
TOOLS INCLUDE:
2
3
5
12
9
10
6
7
8
13
13-IN-1 PLIERS WITH MULTI-TOOL
11
4
1
Long Nose Pliers
Standard Pliers
Wire Cutter / Stripper
Flat Head Screwdriver (large)
Metal / Wood File
Sharp Knife (small)
Flat Head Screwdriver (medium)
Sharp knife (large)
Fish hook remover
Saw
Phillips Head Screwdriver
Flat Head Screwdriver (small)
Bottle and can opener
7
8
9
10
11
12
13
1
2
3
4
5
6
Durable nylon construction. Velcro
fastener secures 13-In-One
Multi-Tool in Carry Case.
Nylon Carry Case
WARNING: This product can expose you to chemicals including Benzene and Ethylbenzene which are known to
the State of California to cause cancer. For more information, go to www.p65Warnings.ca.gov
WARNING: This product can expose you to chemicals including Benzene and Ethylbenzene which are
known to the State of California to cause cancer. For more information, go to www.p65Warnings.ca.gov
WarningMaintenance
13-in-1 Pliers with Multi-Tool features auto-locking tools which automatically lock into place to ensure safety.
• Clean 13-In-1 Pliers with Multi-Tool with a
clean, dry cloth as needed; dry after use
• Lubricate moving parts with standard
consumer lubricant as needed
• Use a standard consumer knife sharpener to
sharpen knives as necessary
• Knife blades are designed to be extremely sharp. Blades
are made for cutting only
• Do not use this item as a pry-bar, chisel, or punch
• Knives and other tools are very sharp; use caution with
this and all sharp-bladed objects
• Use all tools for intended purposes ONLY
• Recommended for Ages 14+
• Tools stored in handle may be too sti or too loose for your specic use. Tighten or loosen tools using Set Screws at base of
13-In-One Multi-Tool, to adjust tool tension
• See www.Pro-4Tactical.com for Warranty and Replacement Information
13-IN-1 MULTI-TOOL PLIERS
Auto-Locking Tools
Troubleshooting
Carefully pull out the desired tool
from the handle. To avoid injury,
use grooves located on each
individual tool as some tools are
very sharp
123
When tool is fully extended it will
automatically lock in position. This
will be accompanied by a clicking
sound, alerting you that the tool is
locked in position
To unlock tool, press and hold black
button located on the back side of
each handle while folding tool back
into its original position
Three magnets mounted in base of Lantern provide easy, hands-free
magnetic adhesion to most ferrous (iron-based) metal surfaces.
Magnetic base is most eective on a at metal surface.
Retractable hook on bottom of Lantern base
Retractable handles on side of Lantern. Use to hang Lantern in ideal
location for maximum light
FRESH ALKALINE BATTERIES ARE RECOMMENDED. DO NOT MIX OLD AND NEW, OR
DIFFERENT TYPES OF BATTERIES. DISPOSE OF BATTERIES PROPERLY.
Unscrew and remove battery cover on bottom of Lantern
Insert 3 AA batteries according to polarity (+/-) as indicated
on Lantern battery compartment
Replace and tighten battery cover
1
2
3
To turn Lantern ON, pull top of Lantern UP
from base until unit is fully extended
Adjust height of Lantern to
control amount of light emitted
To turn Lantern OFF, push top
of Lantern DOWN toward
base until unit is fully closed
123
1
1
2
2
300 LUMENS TACTICAL PORTABLE LANTERN
Installing 3 AA Alkaline Batteries
On / O Instructions
Magnetic Base
Retractable Hanging Hook and Handles
• The Built-In Compass at top of Lantern is as shown in photograph
Compass Reading Tips
• Hold Lantern level. The needle
must be balanced properly for an
accurate directional reading
• Read the correct direction; “N”
stands for “North”
• High Intensity Beam. Extremely bright 300 lumen light
• Do not shine directly into eyes; may cause vision
damage
• Follow City Ordinance Guidelines for proper disposal of
dry cell batteries
• Recommended for Ages 14+
• Remove and store batteries when not in
use for 90 days or longer
• Clean Lantern with a clean, dry cloth
as needed.
• Lubricate screw threads and moving
parts with standard consumer lubricant
as needed
If the Lantern does not turn on; works intermittently; or has a weak light:
• Remove and replace batteries
• Be sure Lantern base is screwed on tightly,
and batteries are inserted properly in battery
compartment
• If problem persists, contact Pro-4 Tactical for
technical advice
• See www.Pro-4Tactical.com for Warranty and
Replacement Information
• Move to a dierent area if the
compass reading is unstable
• Use common sense: e.g., know that
the sun rises in the East and sets
in the West
300 LUMENS TACTICAL PORTABLE LANTERN
WARNING: This product can expose you to chemicals including Benzene and Ethylbenzene which are known to
the State of California to cause cancer. For more information, go to www.p65Warnings.ca.gov
Built-In Compass
Maintenance Warning
Troubleshooting
On the top of the pack, both pockets unzip to
secure other items in place. Zippers will unzip
opposite from each other.
Both pockets have built in-liners as well for
extra security. Pockets can hold a number of
dierent items, such as keys, headphones,
backup charger, wallet, etc.
• Straps and handles may present a choking hazard
• Do not allow children to use this bag without adult supervision
• Store in a safe place when not in use
MOLLE GEAR PACK
On the back of the Gear Pack, there are adjustment straps. Adjust the
strap width to t belts and backpacks.
To adjust the width, unsnap on the bottom of the straps and weave one
strap through the molle webbing as shown in the picture. Both straps
should be at the same molle strap height to work properly. Make sure the
strap bottom is securely fastened to the Gear Pack
WARNING: This product can expose you to chemicals
including Benzene and Ethylbenzene which are known
to the State of California to cause cancer. For more
information, go to www.p65Warnings.ca.gov
Front Pockets
Molle Webbing Straps
The front of the pack has pockets to securely hold 13-in-1 Multi-Tool
Pliers and Flashlight-COB Lantern.
To place the 13-in-1 Multi-Tool Pliers in the pocket, rst fold the Multi-
Tool Pliers into compact mode. Then place the Pliers in the pocket by
inserting the Pliers top rst.
To place the Flashlight-COB Lantern in the pocket, place the Flashlight
into the pocket handle rst. Make sure Flashlight is not extended.
Inside Pockets Warning
No Questions Asked!
1YearWarranty
Tactical Survival Set
Send warranty slip to: Pro-4 Marketing, 32411 Industrial Drive, Madison Heights, MI 48071
Register your unit online: www.Pro-4Tactical.com/warranty-registration.
Pro-4 Tactical will repair or replace your nonworking unit FREE of charge within one year of purchase. To register
your Pro-4 Tactical product so it becomes eligible for coverage under our 1-Year, No Questions Asked Warranty, please
complete product registration by mail or on our website.
Name: Phone:
Email:
Address:
City: State: Zip:
Store Where Purchased:
Date of Purchase:
Month Day Year
Once you have registered your new product, you can make a claim to have your Pro-4 Tactical item replaced.
You MUST send in the following: Proof of purchase (store receipt), your contact information, a description of the problem,
and your nonworking product.
NOTE: You MUST register your product before requesting service. Registration must take place within 2 weeks
of purchase. You may also complete registration and send with the above items (within 2 weeks of purchase). If you do not
have a store receipt, indicate where and when you purchased your product.
- OR -
PRO-4 TACTICAL PRODUCT REGISTRATION FORM
Autres manuels pour Tactical Survival Set
1
Table des matières
Autres manuels Pro-4 Tactical Lampe de poche
Pro-4 Tactical
Pro-4 Tactical Mega Tac-Light Manuel utilisateur
Pro-4 Tactical
Pro-4 Tactical PRO-700 Manuel utilisateur
Pro-4 Tactical
Pro-4 Tactical PRO-1800 Manuel utilisateur
Pro-4 Tactical
Pro-4 Tactical Flashlight with Multi-Tool Manuel utilisateur
Pro-4 Tactical
Pro-4 Tactical Mega Tac-Light Manuel utilisateur
Pro-4 Tactical
Pro-4 Tactical Wide Beam COB Manuel utilisateur
Pro-4 Tactical
Pro-4 Tactical Tactical Survival Set Manuel utilisateur
Pro-4 Tactical
Pro-4 Tactical Tac-Pen Manuel utilisateur
Pro-4 Tactical
Pro-4 Tactical Large Baseball Bat Manuel utilisateur
Pro-4 Tactical
Pro-4 Tactical Flashlight with Multi-Tool Manuel utilisateur
